NX-1811E
NX-181xx NetworX Voice
keypad with touch buttons
Installation Manual
P/N 230240 • REV C • ISS 18JUL14
Copyright
© 2014 UTC Fire & Security Americas Corporation, Inc.
All rights reserved.
This document may not be copied in whole or in part or otherwise
reproduced without prior written consent from UTC Fire & Security
Americas Corporation, Inc., except where specifically permitted
under US and international copyright law.
Trademarks and
patents
The NX-181xx name and logo are trademarks of UTC Fire & Security
Americas Corporation, Inc.
Other trade names used in this document may be trademarks or
registered trademarks of the manufacturers or vendors of the
respective products.
Manufacture
r
Placed on the market by:
UTC Fire & Security Americas Corporation, Inc.
3211 Progress Drive, Lincolnton, NC, 28092, USA
Authorized EU manufacturing representative:
UTC Fire & Security B.V.
Kelvinstraat 7, 6003 DH Weert, Netherlands
FCC compliance
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful
interference to radio communications.
You are cautioned that any changes or modifications not expressly
approved by the party responsible for compliance could void the
user's authority to operate the equipment.
NFPA 72 Check local ordinances, this device is not listed by an approved test lab
to meet NFPA 72 and therefore may not be sold or installed for use with
a fire system in some localities.
EU compliance
EU directives UTC Fire & Security hereby declares that this device is in
compliance with the applicable requirements and provisions of one
or more of the Directives 1999/5/EC, 2014/30/EU and 2014/35/EU.
For more information see: www.utcfireandsecurity.com or
www.interlogix.com
2002/96/EC (WEEE directive): Products marked with this sy mbol
cannot be disposed of as unsorted municipal waste in the European
Union. For proper recycling, return this product to your local supplier
upon the purchase of equivalent new equipment, or dispose of it at
designated collection points. For more information see:
www.recyclethis.info.
2006/66/EC (battery directive): This product contains a battery that
cannot be disposed of as unsorted municipal waste in the European
Union. See the product documentation for specific battery
information. The battery is marked with this symbol, which may
include lettering to indicate cadmium (Cd), lead (Pb), or mercury
(Hg). For proper recycling, return the battery to your supplier or to a
designated collection point. For more information see:
www.recyclethis.info.
Contact information www.utcfireandsecurity.com or www.interlogix.com
Customer support www.interlogix.com/customer-support or
www.utcfssecurityproducts.eu
NX-181xx NetworX Voice keypad with touch buttons Installation Manual 3
Content
Important information 4
Limitation of liability 4
Advisory messages 4
Disclaimer 5
Warranty 5
Installation 6
Wiring Structure Note 7
Advanced System Configuration 9
Panel and Device Configuration 13
Service provider phone number 14
Quick NX-181xx programming guide 15
Word Library 16
Cable Requirements 17
Specifications 18
4 NX-181xx NetworX Voice keypad with touch buttons Installation Manual
Important information
Limitation of liability
To the maximum extent permitted by applicable law, in no event will UTCFS be
liable for any lost profits or business opportunities, loss of use, business
interruption, loss of data, or any other indirect, special, incidental, or
consequential damages under any theory of liability, whether based in contract,
tort, negligence, product liability, or otherwise. Because some jurisdictions do not
allow the exclusion or limitation of liability for consequential or incidental
damages the preceding limitation may not apply to you. In any event the total
liability of UTCFS shall not exceed the purchase price of the product. The
foregoing limitation will apply to the maximum extent permitted by applicable law,
regardless of whether UTCFS has been advised of the possibility of such
damages and regardless of whether any remedy fails of its essential purpose.
Installation in accordance with this manual, applicable codes, and the instructions
of the authority having jurisdiction is mandatory.
While every precaution has been taken during the preparation of this manual to
ensure the accuracy of its contents, UTCFS assumes no responsibility for errors
or omissions.
Advisory messages
Advisory messages alert you to conditions or practices that can cause unwanted
results. The advisory messages used in this document are shown and described
below.
WARNING: Warning messages advise you of hazards that could result in injury
or loss of life. They tell you which actions to take or to avoid in order to prevent
the injury or loss of life.
Caution: Caution messages advise you of possible equipment damage. They tell
you which actions to take or to avoid in order to prevent the damage.
Note: Note messages advise you of the possible loss of time or effort. They
describe how to avoid the loss. Notes are also used to point out important
information that you should read.
Keep in mind, the level of security you will obtain with this system relates
specifically with two major factors:
• The quantity, quality, and placement of security devices attached to this
security system.
• The knowledge you have of the security system and how that knowledge is
utilized in a weekly test of the complete system.
This product is to be installed by qualified SERVICE PERSONNEL only.
NX-181xx NetworX Voice keypad with touch buttons Installation Manual 5
The equipment should only be operated with an approved power adapter with
insulated live pins.
Caution: Risk of explosion if battery is replaced by an incorrect type. Dispose of
batteries according to the instructions. Contact your service provider for
replacement batteries.
Disclaimer
A level of TCP IP knowledge is required by the installer/s to set up some of the
NX-181xx functionality. UTCSF limits it support to NX-181xx setup only, and is
unable to offer further assistance on your client's DSL modem, router, firewall or
any other 3
rd
party software. Please consult your customers IT department or
qualified IT professional about implementing this product onto your client's
network.
Warranty
UTC Fire & Security Americas Corporation, Inc. guarantees this product against
defective parts and workmanship for twenty-four (24) months from the date of
purchase. If any defect appears during the warranty period contact your service
provider. UTC Fire & Security Americas Corporation, Inc. assumes no liability for
consequential or indirect damage, and accepts no responsibility for repairing
damage to the product caused by misuse, careless handling, or where repairs
have been made by others.
No other guarantee, written or verbal, is authorized by UTC Fire & Security
Americas Corporation, Inc.
6 NX-181xx NetworX Voice keypad with touch buttons Installation Manual
Installation
Remove the cap that’s covering the locking mechanism, this is located on the
bottom of the NX-181xx. With the cap removed you now have access to the
locking mechanism that secures your NX-181xx to its mounting plate. Insert a
small flat head screwdriver until it is located under the locking tongue.
Whilst turning either clockwise or counter clock wise, slide the NX-181xx down
and clear of the locking tongue, you can now remove the NX-181xx from its
mounting bracket. Use the fixings supplied to secure the mounting plate to the
wall. The top of the NX-181xx will be 9 mm above the top of mounting bracket
after it is locked back in place.
Figure 1: NX-181xx mounting
Figure 2: Rear view showing cable header pins
Loading...