99505147/III-10 GB/China
1 |
4 |
|
5 |
2 |
|
|
|
3 |
open |
close |
6 |
|
|
||
|
|
|
7 |
4 |
|
|
|
a |
b |
|
|
c |
|
|
|
|
close |
|
|
click! |
|
close |
|
open |
open |
|
|
|
|
|
|
|
|
close |
|
|
open |
|
|
|
click! |
|
|
d |
e |
|
|
f |
|
|
|
g |
h |
|
|
i |
|
|
|
English
Please read the use instructions carefully and thoroughly before using the appliance.
Warning
This appliance is not intended for use by children or persons with reduced physical, sensory or mental capabilities, unless they are given supervision by a person responsible for their safety. In general, we recommend that you keep the appliance out of reach of children. Children should be supervised to ensure that they do not play with the appliance.
Batteries may leak if empty or not used for a longer time. In order to protect you and the appliance, please remove batteries in a timely manner and avoid skin contact whilst handling leaking batteries.
Batteries
Two 1.5 volt batteries.
For best performance, use alkaline manganese batteries (type LR 6, AM 3, MN 1500 or size AA alkaline, e. g. Duracell®). These batteries provide a shaving capacity of approx. 60 minutes.
To open the battery cover (6), turn it 90° as shown in (c). Insert batteries with the poles in the direction marked. Before closing the battery compartment, make sure the cover is dry and clean.
This appliance is suitable for use
in a bath or shower. When using it in a shower, we recommend that
you apply shaving foam or gel.
Shaving
Turn the twisting protective cap (4) (a) until it clicks in place as shown (b). To switch the shaver on, push the on/off switch (3) up.
Long hair trimmer
(M-90 only)
Use the extendable long hair trimmer (5) for exact trimming of side burns and moustaches. To operate, slide the long hair trimmer to the right (e) and turn on the appliance. After use, slide it back until it engages.
Cleaning and maintenance
For optimum shaving performance, clean the shaver after each use:
Cleaning under running water
Turn on the shaver and hold the shaver head under warm running water (f). You may also use liquid soap. Rinse off all foam and let the shaver run for a few more seconds. Then turn it off and remove the shaver foil (1) as shown (g) and let it dry. If you often clean your shaver under running water, put a drop of light machine oil onto the shaver foil.
3
Loading...