HDS7132U-01
YOUR LIFE. OUR INSPIRATION,
Freestanding Dual Fuel Range
Safety ......... I
Preparation ...... 3
Installation ...... 5
Final Steps 7
Important Safety Instructions ,,, Our
Table of Contents
Important Safety Instructions .......................................................................................... 1
Preparation ................................................................................................................... 3
Installation .................................................................................................................... 5
Final Steps ................................................................................................................... 7
Please read all instructions before using this appliance,
PARTS PROVIDED:
Anti-Tip Bracket
TOOLSAND PARTS NEEDED:
• Range Power Supply Cord Kit with strain relief
(240V - 30 Amps)*
• Standard Measuring Tape
• Phillips Head Screwdriver
• 1-1/4"Wrench
• Pencil
• T-20 Torx Screwdriver
• 3/8" Nut Driver
• Screws (2) and Anchors (2) for Anti-tip Bracket
(Style will vary depending on mounting surface)
• Pipe Wrench (2)
• Teflon® Tape** or Pipe Joint Compound
(Appropriate for use with LP gasand Natural gas)
• Channel Lock Pliers
• Gas LeakTest Solution
• Level
• Drilland Drill Bit
• GasSupply Line (Flexible MetalAppliance Connector
or Rigid Pipe)
• Gas Shut Off Valve (If not already present)
• GIoves and Safety Goggles
Not needed for Canadian installations
• * Teflon is a registered trademark of DuPont
If the information in this manual is not followed|
exactly, a fire or explosion may result causing |
property damage, personal injury or death. J
%,,
Do not store or use combustible materials,
gasoline or other flammable vapors and
liquids in the vicinity of this or any other
appliance.
WHATTO DO IFYOU SHELLGAS:
• Do not try to light any appliance.
• Do not touch any electrical switch.
• Do not use any phone in your building.
• Immediately call your gas supplier from a
neighbor's phone. Follow the gas supplier's
instructions.
• If you cannot reach your gas supplier, call
the fire department.
Installation and service must be performed by a
qualified installer, authorized service agency or the
gas supplier.
,. j
,. Removealltapeand packaging before using
the range, Destroy the carton and plastic bags
after unpacking the range. Never allow children to
play with packaging material.
,. Be sure your appliance is properly installed
and grounded by a qualified technician in
accordance with the National Electrical Code ANSI/
NFPA No. 7 latest edition and local electrical code
requirements.
important: Local codes vary. installation, electrical
connections and grounding must comply with all
applicable codes.
• Installonlyperinstallationinstructions
included in the literature package for this
range,
• Askyour dealer to recommend a qualified
technician and an authorized repair service,
• Know how to disconnect the power to the
range at the circuit breaker or fuse box in and the
gas supply at the shutoff in case of an emergency.
,. Do not repair or replace any part of the
appliance unless specifically recommended in
the manuals, All other servicing should be done by
a qualified technician. This may reduce the risk of
personal injury and damage to the range.
,. When testing the supply piping system at test
pressures in excess of 1/2 psig (3,5 kPa)r the
appliance and its individual shutoffvalve must
be disconnected from the gas piping system,
,. When testing the supply piping system at test
pressures equal to or less than 1/2 psig (3,5
kPa), the appliance must be isolated from the
gas supply piping system by closing its
individual manual shutoffvalve,
• Never modify or alter the construction of a
range by removing leveling legs, panels, wire
covers, anti-tip brackets/screws, or any other part
of the product.
• Do not lift door by door handle, Remove the
door for easier handling and installation. See
Section 'Removing Oven Door' in Use and Care
manual.
English * 1
Loading...