Distinctive alert faxability service
© 2005 Hewlett-Packard Development Company, L.P.
All rights reserved.
*Q7311-90101*
*Q7311-90101*
Q7311-90101
Printed in [country]
The HP Officejet 5600 All-in-One series devices have been designed to work with the Distinctive Alert Faxability Service in New Zealand. However, in order to work, the
Answer Ring Pattern for these devices must be set to Single Rings. The Single Rings option has been specifically designed to work with the Distinctive Alert Faxability Service. You can change this setting from the control panel.
To change the answer ring pattern from the control panel
1Verify that your HP All-in-One is set to answer fax calls automatically. For information, see the User Guide that came with your device.
2Press Setup.
3Press 5, then press 1.
4 Press!until Single Rings appears.
5Press OK.
Additional notice
1This equipment shall not be set to make automatic calls to the Telecom ‘111’ Emergency Service.
2This equipment should not be used under any circumstances which may constitute a nuisance to other Telecom customers.
3A Telepermit for any terminal equipment indicates only that Telecom accepts that the item complies with minimum conditions for connection to its network. It indicates no endorsement of the device by Telecom, nor does it provide any sort of warranty.
Above all, it does not assure that any item will work correctly with another item of Telepermitted equipment of a different make or model, nor does it imply that any device is compatible with all of Telecom’s network services.
4Decadic (or pulse) dialing is not supported on this device.
5This equipment is not capable, under all operating conditions, of correct operation at the higher speeds for which it is designed. Telecom will accept no responsibility should difficulties arise in such circumstances. This condition typically applies to 56 kbits per second modems and facsimile machines operating at greater than 14.4 kbits per second.
6Not all telephones will respond to incoming ringing when connected to the extension socket.
7This device only responds to Distinctive Alerts DA1, DA2, and DA4.
8When receiving a DA4 (Faxability) ring signal, setting the Rings to Answer to less than 3 will result in destroyed Caller ID information if a Caller ID device is connected to the same line. For information on setting the Rings to Answer, see the User Guide that came with your HP All-in-One.
9This equipment may not provide for the effective handover of a call to another device connected to the same line.
Loading...