XP-530/XP-630/XP-830 Small-in-One® Printer
Start Here
Read these instructions before using your product.
The illustrations show the XP-830, but the steps are the same for the XP-530 and XP-630.
Note for Spanish speakers/Nota para hispanohablantes:
Para obtener instrucciones de configuración en español, consulte
la Guía de instalación en epson.com/support/xp530sp, epson.com/support/xp630sp o epson.com/support/xp830sp
(requiere una conexión a Internet).
(XP-630/XP-830)
Note:
•Do not open ink cartridge packages until you are ready to install the ink. Cartridges are vacuum packed to maintain reliability.
•The CD/DVD tray is taped to the bottom of cassette 2.
1 Remove all protective materials from the product.
2Lift up the scanner unit and remove all protective materials.
3 Lower the scanner unit.
1Connect the power cord to the back of the printer and to an electrical outlet.
Caution: Do not connect to your computer yet.
2 Turn on the product, then adjust the control panel.
3Select these settings: XP-530/XP-630: Language
XP-830: Language, country, date, and time
Note:
•You can change these settings later using the product’s control panel. For more information, see the online User’s Guide.
•If an error message appears, turn off the product and check that no protective material has been left inside the product.
1 Lift up the scanner unit.
Caution: Do not touch the flat, white cable.
2Gently shake the Black (BK) ink cartridge. Do not shake Photo Black (PBK) or other ink cartridges.
3Unpack the ink cartridges.
Caution: Do not touch the areas shown below. Doing so may prevent normal operation and printing.
4Remove the cap from each ink cartridge. Store the caps in the included plastic bag.
Note: Save the caps and use them to recap the ink cartridges after removing them for storage or disposal.
5Insert the cartridges at an angle in the holder for each color. Press each cartridge down until it clicks.
6 Lower the scanner unit.
7The printer starts charging the ink. Ink charging takes approximately 7 minutes. When you see a completion message on the printer’s LCD screen, charging is complete.
Caution: Don’t turn off the printer or raise the scanner unit while the printer is charging or you’ll waste ink.
Note:
•The printer is designed for use with Epson® cartridges only, not third-party cartridges or ink.
•The cartridges included with the printer are designed for printer set up and not for resale. After some ink is used for charging, the rest is available for printing.
See the online User’s Guide for instructions on loading paper in the cassette 1 and rear paper slot, available paper types, sizes, loading capacity, and loading CD/DVD/Blu-ray™ discs (XP-630/ XP-830).
XP-630/XP-830
Output tray |
|
Cassette 1 |
Cassette 2/front cover |
You can load the following paper sizes:
•Cassette 1: 3.5 × 5-, 4 × 6-, or 5 × 7-inch photo paper
•Cassette 2: Letter-size, A4-, legal-size, or 8 × 10-inch paper See the instructions below for loading paper.
•Rear paper feed slot: One sheet at a time (XP-830)
XP-530
Output tray
Cassette/front cover
You can load the following paper sizes: 3.5 × 5-, 5 × 7-, 8 × 10inch, letter-size, A4-, or legal-size.
1Lower the front cover (if it’s not open already) and pull on the front cover to pull out the paper cassette.
2Slide the side edge guides outward and set the front edge guide to the paper size you are using.
3Insert the paper with the glossy or printable side facedown.
Note: Make sure the paper is loaded against the front edge guide and not sticking out from the end of the cassette.