Epson SAA-101100, SAA-101200, SAA-102100, SAA-102200, SAA-111100 Datasheet

DOCUMENT NUMBER NCD-5DC2-01

SAA-1 Series

Single-Mode

FC ADAPTOR

TECHNICAL SPECIFICATIONS

Seiko Instruments Inc.

Components Sales Dept.

8, Nakase 1-Chome

Mihama-ku, Chiba-shi, Chiba-ken

261 JAPAN

Telephone : [phone]

-1215

Facsimile : 043-211-8035

SAA-1 Series Single-Mode FC ADAPTOR

TECHNICAL SPECIFICATIONS

Document Number NCD-5DC2-01

NAE63D01 " SAA-1 Part " May 1986

NAE63D02 " SAA-1 Part " September 1986

SSA930305	March 1993
39055-2016-01	September 1993
NCD-5DC2-01	December 1995

Copyright 1986, 1993, 1995 by Seiko Instruments Inc.

All right reserved.

The information contained herein shall not reproduced or disclosed to any third party without the express written consent of SII.

The Specifications contained herein are subject to change without notice.

SII is a trademark of Seiko Instruments Inc.

Please address any questions, comments, and suggestions to:

Seiko Instruments USA Inc.	Seiko Instruments GmbH
Electronics Components Division	OFC Division
2990 West Lomita Boulevard	Siemensstraße 9b
Torrance, CA 90505, U.S.A.	D-63263 Neu-Isenburg, Germany
Phone: [phone]	Phone: [phone]
Fax: [phone]	Fax: [phone]

Seiko	Instruments (H.K.) Ltd.	Seiko Instruments Taiwan Inc.
Sales Department		Sales Department
4th & 5th Floor, Wyler Center 2		5F-1, No.99, Sec. 2, Chung Shan
200 Tai Lin Pai Road, Kwai Chung		Rd.
N.T., Kowloon, Hong Kong		Taipei 104, Taiwan, R.O.C.
Phone: [phone]		Phone: [phone]
Fax: [phone]		Fax: [phone]
Seiko Instruments Singapore pte. Ltd.
2, Marsiling Lane,
Woodlands New Town,
Singapore, 2573, Singapore
Phone:	65-2691370

Fax: [phone]

ii

		TABLE OF CONTENTS
Section			Page
1.	PROVISION		1
1.1	Application Limit		1
2.	PARTS NUMBER		1
3.	GENERAL SPECIFICATIONS		2
3.1	Parts and Materials		2
3.2	Physical Dimensions		2
3.3	General Tolerances		2
3.4	Insertion Loss		3
4.	PACKING		3
5.	SHIPPING INSPECTION		3
		Table
Table 1		Parts Number	1
Table 2		Parts and Materials	2
Table 3		General Tolerance	2
Table 4		Insertion Loss and the Measurement Conditions	3
		Figure
Figure 1		Insertion Loss Measurement System	3
Figure 2		SAA-1 Adaptor	4
Figure 3 to 4		Part Dimensions	5

iii