Hand Held |
2 - 4 |
IMPORTANT INFORMATION |
Vacuum Cleaner |
||
Household Type |
|
|
Ownerʼs Guide |
4 |
GUARANTEE |
60 - 70 Series |
5 |
HOW TO ASSEMBLE |
|
||
|
5 - 6 |
HOW TO USE |
|
6 |
ROUTINE MAINTENANCE |
|
6 |
Dust Cup |
|
6 |
Filter |
IMPORTANT
For any advice on your cleaner and to order fi lters and accessories, please telephone the
Electrolux Helpline on
08706 055055
www.electrolux.co.uk
IMPORTANT SAFEGUARDS
When using an electrical appliance, basic precautions should always be followed, including the following:
READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER.
WARNING
To reduce the risk of fi re, electric shock, or injury:
Do not use outdoors or on wet surfaces
Do not leave vacuum cleaner when plugged in. Turn off the switch and unplug the electrical cord when not in use and before servicing
Do not allow to be used as a toy. Close attention is necessary when used by or near children
Use only as described in this manual. Use only manufacturerʼs recommended attachments
Do not use with damaged cord or plug. If vacuum cleaner is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, return it to a service center before using
Do not pull or carry by cord, use cord as a handle, close door on cord, or pull cord around sharp edges or corners. Do not run vacuum cleaner over cord. Keep cord away from heated surfaces
Do not use extension cords or outlets with inadequate current carrying capacity
Turn off all controls before unplugging
Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord
Do not handle plug or vacuum cleaner with wet hands
Do not put any object into openings. Do not use with any opening blocked; keep free of dust, lint, hair, and anything that may reduce airfl ow
This vacuum cleaner creates suction and contains a revolving brush roll. Keep hair, loose clothing, fi ngers, and all parts of body away from openings and moving parts
Do not pick up anything that is burning or smoking, such as cigarettes, matches, or hot ashes
Do not use without dust cup or fi lter(s) in place
Use extra care when cleaning on stairs
Do not use to pick up fl ammable or combustible liquids such as gasoline, or use in areas where they may be present
Store your cleaner indoors in a cool, dry area
Keep your work area well lighted
Unplug electrical appliances before vacuuming them
Belt pulleys can become hot during normal use. To prevent burns, avoid touching the belt pulley when servicing the drive belt
SAVE THESE INSTRUCTIONS
2
BEFORE YOU START
CHECK THE VOLTAGE
Before connecting the cleaner to an electrical supply, ensure that the voltage shown on the rating plate located beneath the cleaner is of the correct voltage for your electricity supply. If it is not, do not use the cleaner but refer back to your dealer
CONNECTING TO YOUR ELECTRICITY SUPPLY
Permanently connected to the cleaner is a mains supply (2-core) cable fi tted with a non-rewirable plug incorporating a 13A fuse.
n the event of the fuse requiring replacement the fuse cover should be removed using a small screwdriver. The old fuse MUST be replaced by a 13A ASTA approved BS1362 fuse or a BSI approved fuse. The cover must be replaced before the plug is used again. In the event of loss of the fuse cover, replacements can be obtained from your Electrolux Retailers and must be of the same colour as indicated by the coloured insert on the base of the plug.
In no circumstances must the plug be used without a correct fuse cover fi tted.
f the plug that is fi tted to your appliance is not suitable for your socket outlet, it must be cut off and the appropriate plug fi tted. Remove the fuse from the cut off plug
The cut off plug should then be disposed of to prevent the hazard of shocks in case it should be plugged into a 13 amp socket in another part of your home
The wires in the mains cable of this appliance are coloured in accordance with the following code: Blue: Neutral. Brown: Live.
As the colours of the wires in the mains cable of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows:
The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black. The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red.
f using a three-pin plug, do not make any connection to the terminal marked with the letter E or by the earth symbol or coloured green or green-and-yellow. This cleaner is double insulated and no earth connection is necessary.
t is in your interest to ensure that the plug is correctly attached to the mains cable. In case of doubt, consult a qualifi ed electrician, as Electrolux cannot regard the repair of faults on the plug connection as a service that can be given free of charge under the terms of the guarantee
Fuse |
13 Amp Fuse |
Cov |
|
own
Clamp
WARNING
The brush in the cleaning head rotates at high speed and can cause damage to the mains supply cable if the cleaner passes over it during cleaning operations.
Care should be taken to ensure that this does not happen. If the cleaning head has accidentally passed over the mains supply cable the following action should be taken:
Switch off and remove the plug from the socket outlet
2 Examine the mains supply cable for damage (only after removing the plug from the socket outlet).
3.If there is any sign of damage to the supply cable it MUST be renewed. The repair MUST be carried out by an Electrolux Service Agent or a similar qualifi ed person
4.NEVER use the machine with a damaged mains supply cable
Proprietary carpet conditioning and air freshening materials
After using proprietary carpet conditioning powders, it is recommended that the fi lters be changed. Some of these preparations contain substances which if left in the vacuum cleaner for extended periods could damage the plastic mouldings which form the structure of the cleaner
Many air fresheners, household deodorants, sprays and polishes contain a highly fl ammable gas propellant.
Because of this, it is particularly important that these products are used strictly in accordance with the relevant manufacturerʼs nstructions
t is essential that none of the above products are sprayed directly into the vacuum cleaner or any of its fi lters, hose assembly, dustbag chamber or dust cup
Thermal Cut Off
This vacuum cleaner has a special thermostat that protects the cleaner in case of motor overheating. If the cleaner switches off, push the switch to “Off” and unplug the cleaner. Check the cleaner for a possible source of overheating such as a full dust cup, a blocked hose or clogged fi lter. If these conditions are found, fi x them and wait at least 60 minutes before attempting to use the cleaner. After the 60 minute period, plug the cleaner back in and turn on the switch. If the cleaner still does not run, please call Electrolux on 08706 055055
3
Loading...