Delfield N8630, N8656, N8669, N8681 General Manual

	Project __________________________________
	Item ____________________________________
	Quantity ________________________________
N8600	CSI Section 11400
	Approved _______________________________
	Date ____________________________________

Drop-In Self-Contained Hot & Cold Combination Pan

Models

•N8630 30” hot & cold combination pan drop-in

•N8643 43” hot & cold combination pan drop-in

•N8656 56” hot & cold combination pan drop-in

•N8669 69” hot & cold combination pan drop-in

•N8681 81” hot & cold combination pan drop-in

		Standard Features
		• NSF-4 and NSF-7 certified for hot and
		cold operation
		• Stainless steel immersion heaters with
		stainless steel perforated covers
		• Remote control panel with 3-way hot/
		cold/off power switch and thermostat
		for hot operation
		• Thermostat for cold operation located
		next to condensing unit
		• Adjustable pan support for flush
		mounted hot operation or 2” recessed
		cold operation
		• 1’’ stainless steel drain with screen
		• Stainless steel louver provided
		• High density environmentally friendly,
		Kyoto Protocol compliant, Non ODP
		(Ozone	Depletion Potential),			Non
		GWP	(Global	Warming	Potential)
		polyurethane foam throughout
		• Push-in flange gasket is standard
	N8630	• Adaptor bars for 12”x20” pans provided
		• Environmentally friendly HFC-404A
		refrigerant
		• Standard 90 day		labor and	one	year
		parts warranty

Options &

Accessories

•Additional adaptor bars or plates

•Relocate compressor

•Remote refrigeration

•Automatic water fill

•220V/50C electrical

•3-phase electrical

•Counter protectors

•Extended warranty

Specifications

Top: Top is constructed of one-piece 20-gauge stainless steel.

Interior: Interior liner is constructed of 16gauge stainless steel with a 1” (2.54cm) drain. Adjustable stainless steel pan rest for flush mount heating or 2” recessed cooling to accommodate up to 6” (15.2cm) deep 12”x20” pans, supplied by others. Stainless steel immersion heater(s) installed in bottom for wet only heating operation.

Exterior: Exterior body is constructed of 24gauge galvanized steel with high density environmentally friendly, Kyoto Protocol compliant, Non ODP (Ozone Depletion Potential), Non GWP (Global Warming Potential) polyurethane insulation throughout.

Refrigeration: Condensing unit is suspended on a 16-gauge galvanized steel frame. Environmentally friendly HFC-404A refrigerant is utilized. Temperature controlled by thermostat located next to condensing unit.

Operation: Remote control panel contains 3- way Hot/Cold/Off power switch and thermostat for heated operation.

Electrical: All units must be hard wired at installation.

	980 S. Isabella Rd.	Phone: [phone] or 989-773-7981
	Mt. Pleasant, Michigan 48858		www.delfield.com
		Fax: [phone]

<![if ! IE]>

<![endif]>Pan Combination Cold & Hot Contained-Self In-Drop N8600