Project __________________________
Item ____________________________
Quantity _________________________
CSI Section 11400
SPRDP-NE
Refrigerated Display Case, 30” counter height, 30” depth
MODELS
SPRD36P-36NE |
Pass through refrigerated display case, |
SPRD48P-60NE |
Pass through refrigerated display case, |
|
36” total length, 30” depth |
|
60” total length, 30” depth |
SPRD36P-50NE |
Pass through refrigerated display case, |
SPRD60P-74NE |
Pass through refrigerated display case, |
|
50” total length, 30” depth |
|
74” total length, 30” depth |
SPRD48P-50NE |
Pass through refrigerated display case, |
SPRD72P-74NE |
Pass through refrigerated display case, |
|
50” total length, 30” depth |
|
74” total length, 30” depth |
|
|
|
For actual display case dimentions see back |
STANDARD FEATURES
Display Section
• |
Display exterior sides are made of 18-gauge stainless steel |
• |
ABS plastic interior sides with molded shelf supports |
• |
(4) adjustable epoxy coated wire shelves |
• |
On/off switch for the display section light(s) |
• |
Top mount coil with multiple fans circulating the air throughout the |
|
cabinet |
• |
Display section runs off a thermostatic control |
• |
Sliding and removable self-closing .5” thick argon filled, low-E, |
|
warm edge insert, thermopane glass doors with left and right |
|
vertical gasket |
• |
Door locks standard |
Base Section |
|
• |
14-gauge stainless steel top standard |
• |
30” counter height, 30” depth |
• |
18-gauge stainless steel exterior body |
• |
9’ long cord and plug are supplied standard |
• |
R404A refrigerant |
• |
Standard on 5” diameter polyurethane casters |
• |
Stainless steel fully retractable interlock provided as standard |
• |
A wide selection of laminate colors available at no additional |
|
charge |
• |
One-year parts and 90 day labor standard warranty. Additional |
|
warranties available. |
OPTIONS AND ACCESSORIES
16”x30” Stainless steel drop tray shelfStainless steel cash self
Tray slides
• V-style
• Tubular bar
2” Wire basket (13.25”x20.5”x2.5”)4” Wire basket (13.25”x20.5”x4.75”)Decal package
Extra shelf 36”
Extra shelf 50”
Extra shelf 60”
Extra shelf 72”
220 volt, 50 cycle electrical system*
*Inclusion of these options will alter the electrical specifications of the unit
SPECIFICATIONS
between the interior and exterior. Four adjustable epoxy coated wire shelves are provided for the display section. An on/off switch for the display section light(s) is located at the right end of the front facing, above the display section doors. Display case refrigeration system consists of a fulllength top mounted coil with multiple fans circulating the air throughout the cabinet utilizing a thermostatic control. An ABS plastic drip pan is placed below the coil with a clear drain hose for running the condensation to the lower base mechanical section. Front of the display section is equipped with two sliding and removable self-closing .5” thick argon filled, low-e glass doors with a warm edge spacer. The
Display Case: Display section exterior sides are vertical outsides of each door tuck into an extruded made of 18-gauge stainless steel. Exterior display channel running vertically up each side. Locking doors section top to be 22-gauge galvanized metal. Interior are standard. Front and rear nosing to be 20-gauge sides are made of .095” thick ABS plastic with molded stainless steel. shelf supports. The interior bottom is constructed with Display cabinet to maintain 36to 40 degree stainless steel for long lasting durability. Display section temperatures at 100 degree ambient room is fully insulated with high density polyurethane foam temperature.
Refrigeration: Refrigeration system uses HFC-404A refrigerant and has a self-contained 115 volt, 60 Hertz, single phase hermetically sealed condensing unit. Self-contained models have a pre-wired condensing unit housed in a machine compartment, standard on right, with an easy removable louver panel for quick access. Machine compartment also is supplied with an 9’ cord and plug and electrical junction box.
Casters: Unit is mounted on 5” (12.7cm) diameter swivel polyurethane casters with non-marking tires and plate brakes. Casters are bolted directly to the 14-gauge bottom of the base. Overall height of caster assembly is 6.00” (15.2cm).
Styling: Units are standard with 18-gauge stainless steel exterior sides. Laminate is an option available at no additional charge. Decal packages are also available.
980 S. Isabella Road |
Phone: 800-733-8948 |
Approval _________________ |
|
Mt. Pleasant, MI 48858 |
Fax: 800-669-0619 |
Date____________________ |
|
www.delfield.com |
Email: info@delfield.com |
||
|
|||
|
|
|
<![endif]>DEPTH30”HEIGHT,30”COUNTERCASE,DISPLAYREFRIGERATED™SHELLEYSPEEDNE-SPRDP