<< |
Previous |
Next >> |
|
|
|
Installing Your Multifunction to Your Network for the First Time
PIXMA MG3120
Macintosh OS
1
|
|
|
|
|
|
<< Previous |
|
Next >> |
|
|
|
|
|
|
|
|
|
|
|
Installing Your Multifunction to Your Network for the First Time
PIXMA MG3120
Macintosh OS
Preparing to Connect My Multifunction to My Network |
3 |
Network Requirements |
3 |
Notes on Wireless Connection |
4 |
Installing the Drivers & Software |
5 |
2
Preparing to Connect My Multifunction To My Network
<< Previous |
|
Next >> |
|
|
|
Network Requirements
Before connecting the machine to the network, make sure that configuration of the computer and access point or router is complete, and that the computer is connected to the network.
Wireless Connection
Before connecting the machine to the network, the computer needs to be connected to the network. Make sure that configuration of the computer and access point or router is complete.
3
Preparing to Connect My Multifunction To My Network
<< Previous |
|
Next >> |
|
|
|
An "Ad-hoc connection," which establishes a direct wireless connection between the computer and printer without using an access point, is not supported.
A router or access point is required for your printer to be used on a wireless network.
Notes on Network Connection
•The configuration, router functions, setup procedures and security settings of the network device vary depending on your system environment. For details, refer to your device's instruction manual or contact its manufacturer.
•In an office setup, consult your network administrator
•If you connect to a network that is not protected with security measures, there is a risk of disclosing data such as your personal information to a third party.
•If an error message appears or if you have trouble with the network connection, refer to the printed manual: Network Setup Troubleshooting.
•Place the machine and computer on the same network segment.
4
Loading...