Whirlpool ADL 961/1 WH, FUN 630 SW, ADG 343 WH, ADP 262 WH, FUN 630 BR User Manual

GB			CONTENTS
BEFORE USING THE DISHWASHER				PAGE 11
PROTECTING THE ENVIRONMENT				PAGE 11
PRECAUTIONS AND GENERAL RECOMMENDATIONS				PAGE 11
CONNECTIONS				PAGE 12
ELECTRICAL CONNECTION				PAGE 13
HOW TO FILL THE SALT CONTAINER				PAGE 14
HOW TO FILL THE RINSE AID DISPENSER				PAGE 15
HOW TO FILL THE DETERGENT DISPENSER				PAGE 16
CARE AND MAINTENANCE				PAGE 17

To make the most of your new dishwasher, please read these user instructions and the quick reference guide carefully.

10

BEFORE USING THE DISHWASHER

1.Removing the packaging and check

After unpacking, make sure that the dishwasher is undamaged and that the door closes correctly. If in doubt, contact a qualified technician or your local retailer.

• Keep the packaging materials (plastic bags, etc.) out of children's reach, as they are potentially dangerous.

2. Water and electrical connections

•All water and electrical connections must be carried out by a qualified technician in compliance with the manufacturer’s instructions (refer to the enclosed assembly instructions) and current local safety regulations.

The appliance must only be used in the household for the prescribed uses.

PROTECTING THE ENVIRONMENT

1.Packaging

The packing box may be fully recycled as confirmed by the recycling symbol .

2.Energy and water saving tips

•Do not rinse crockery under running water.

•Always fully load the dishwasher before switching on or set the wash programme to half load (if available) if one rack only has been filled.

•If ecological energy sources are available, such as solar panel heating, heat pumps or centralised heating systems, the appliance may be connected to the hot water mains up to a maximum temperature of 60° C. Make sure the water inlet hose is of the correct type. Refer to the “Connections” chapter in these user instructions.

3.Disposal of the packaging material and old machine.

The appliance is built from reusable materials. If you decide to scrap the dishwasher, it must be disposed of in compliance with local waste disposal laws.

In any case, before scrapping, cut off the power cable so that the appliance cannot be connected to the mains.

PRECAUTIONS AND GENERAL RECOMMENDATIONS

1. Child safety:

Children must not be allowed to play with the dishwasher.

Store the detergent, rinse aid and salt in a dry place out of the reach of children.

2. General recommendations:

The open dishwasher door can only support the weight of the loaded rack when pulled out. Do not rest objects on the open door or sit or stand on it: the appliance may topple over!

Do not use solvents inside the dishwasher: risk of explosion!

Only use detergents, rinse aids and regeneration salts specially recommended for use in domestic dishwashers.

•Before cleaning or carrying out any maintenance, switch off the appliance, disconnect the mains plug and turn off the water tap.

•If a fault occurs, switch off the appliance and turn off the water tap.

•If necessary, the power cable may be replaced with an identical one.

The power cable must only be replaced by a qualified technician.

•On completion of the programme, switch off the dishwasher and turn off the water tap.

3.For appliances with water stop system:

The water inlet hose and plastic casing contain electrical components. Do not therefore cut the hose or immerse the plastic casing in water. If the hose is damaged, switch off the appliance immediately.

EC Declaration of conformity

This appliance has been designed, constructed and distributed in compliance with the safety requirements of EC Directives:

•73/23/EC

•89/336/EC

•93/68/EC

•IEC 436/DIN 44990

•EN 50242

Load capacity: 12 place settings.

11

CONNECTIONS

Do not use the dishwasher if it has been damaged in transit. Consult our After-Sales Service or your local retailer.

(Refer to the separate assembly instructions booklet)

Water inlet and drain:

•Observe any special regulations issued by your local Water Board.

•Make sure the inlet and drain hoses are kinkfree and are not crushed.

•If the hose length is not sufficient, please contact your local dealer or our After-Sales Service.

•The inlet hose must be securely clamped to the water tap to prevent leaks.

•The water inlet pressure should not be less than 0.3 bars.

•If the water inlet pressure is higher than

10 bars, a pressure reducing valve should be fitted between the appliance inlet and the water source.

•The inlet water temperature varies according to the model installed: inlet hose marked “25° C Max”: maximum temperature 25° C.

All other models: maximum temperature 60° C.

•When installing the appliance, make sure the drain water discharges correctly (if necessary, remove the wire gauze from

the sink siphon).

•Fix the drain hose to the siphon with a clamp to prevent it from coming off during operation.

•For appliances with water-stop system only: If the water connections are made correctly according to the instructions, the water-stop system safeguards your home against damage caused by flooding.

Electrical connection:

•Observe the current regulations issued by your local electricity supplier.

•Voltage information is shown on the rating plate mounted inside the door on the right hand side.

•The appliance must be earthed as prescribed by law.

•Do not use extension leads or multiple adapters.

•Before carrying out maintenance, disconnect the mains plug.

•The power cable must only be replaced by a qualified technician.

•The manufacturer cannot be held responsible for damage caused by incorrect earthing of the appliance.

•For Austria: if the appliance is series connected to a fault current switch, this must be sensitive to the pulsating current.

12