Self-Cleaning
Hot & Cold Hidden
Bottle-Water Cooler
Model No.: 8LIECH-SCSSFP5W
USERS’ MANUAL
SAVE THIS MANUAL FOR FUTURE USE
For service, call 1-855-594-4755
or e-mail Whirlpool@electrotemp.com
8LIECH-SCSSFP5W PN: 5M010993XX00(E+S)
Model # 8LIECH-SCSSFP5W: Page 2
TABLE OF CONTENTS |
|
Safety Precautions-Electrical Requirements ........................ |
2 |
Safety Precautions ...................................................................... |
3 |
Product Features ........................................................................ |
4 |
Key Information for Future Use ................................................ |
4 |
Specifications ............................................................................... |
5 |
Parts & Features .......................................................................... |
5 |
Unpacking and Assembly .......................................................... |
6 |
Installation ..................................................................................... |
6 |
SELF-CLEANING - An Exclusive Feature .......................... |
7 |
Operation ....................................................................................... |
7 |
Proper Care & Descaling ........................................................... |
11 |
LED Indicator Lights .................................................................... |
13 |
Troubleshooting ........................................................................... |
14 |
Limited Warranty ......................................................................... |
16 |
SAFETY PRECAUTIONS ---Electrical Requirements |
|
WARNING
Electrical shock Hazard Plug into a grounded 3 prong outlet. Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, fire, or electrical shock.
A 120 volt, 60 Hz., AC only, 15 amp, fused electrical supply is required. A time-delay fuse or circuit breaker is recommended.
If codes permit and a separate ground wire is used, it is recommended that a qualified electrician determine that the ground path is adequate.
Check with a qualified electrician if you are not sure whether the water cooler is properly grounded. The proprietary design of the hot water tank assures availability of hot water and efficient energy use.
IMPORTANT: Do NOT Return Dispenser To Store.
If you have a question or problem, please contact 1-855-594-4755 for assistance.
Model # 8LIECH-SCSSFP5W: Page 3
SAFETY PRECAUTIONS
Your safety and the safety of others are very important.
We have provided many important safety messages in this manual and your appliance. Always read and follow all safety messages.
This is the safety alert symbol.
This symbol alerts you to potential hazards that can kill or injure you and others.
All safety messages will follow the safety alert symbol and either the word “DANGER”or “WARNING” These words mean:
DANGER 
WARNING
You can be killed or seriously injured if you don′t immediately follow the instructions.
All safety instructions will inform you what the potential hazard is, how to reduce the chance of injury, and what can happen if the instructions are not followed.
State of California Proposition 65 Warnings:
WARNING: This product contains one or more chemicals known to the State of California to cause cancer. WARNING: This product contains one or more chemicals known to the State of California to cause birth defects or other reproductive harm.
The above warnings apply to electrical components within this product only, and not components that come into contact drinking water.
IMPORTANT SAFETY INSTRUCTIONS
WARNING: To reduce the risk of fire, electric shock, or other injury when using your water cooler, follow these basic precautions:
■Plug it into a grounded 3-prong outlet.
■Do not remove the ground prong.
■Do not use an adapter.
■Disconnect power before servicing.
■All of the parts and panels must be in place before use.
■Do not use an extension cord.
■Two or more people should move and install the water cooler and the bottles.
■Never allow children to dispense hot water without proper supervision. Unplug unit to prevent unsupervised use by children.
SAVE THESE INSTRUCTIONS
When operating this dispenser, please observe the following:
•Prior to use, this dispenser must be properly assembled and installed in accordance with this manual.
•This dispenser is intended to dispense water only. Do NOT use other liquids. Do NOT use for other purposes. Never use other liquids in the dispenser other than known and microbiologically safe bottled water. Warranty is void if used with any other liquids, including but not limited to coffee, tea, juices, beer or wine.
Location Requirements:
•Install the unit in an area where it is protected from the elements, including direct sun.
•Install and use only on a hard, flat and level surface.
•Do NOT place the dispenser inside an enclosed space or cabinet.
•Position the dispenser no closer than 4 inches from the wall. Leave at least 4 inches of clearance on all sides to permit free airflow.
•Service should only be performed by a certified technician. Please call 1-855--594-4755 for assistance.
IMPORTANT: Do NOT Return Dispenser To Store.
If you have a question or problem, please contact 1-855-594-4755 for assistance.
Model # 8LIECH-SCSSFP5W: Page 4
PRODUCT FEATURES
Congratulations! You have chosen a technology advanced, state-of-the-art water cooler.
To provide consistently cold water, this water cooler forms an "Ice Bank" in the cold tank. Formation of the initial "Ice Bank" can take up to 1 hour.
WHEN THE UNIT IS PLUGGED IN FOR THE FIRST TIME, IT CAN TAKE OVER AN HOUR BEFORE THE "ICE BANK " FORMS AND THE UNIT CAN PROVIDE THE COLDEST WATER.
KEY INFORMATION FOR FUTURE USE
Please register your dispenser immediately at
www.electrotemp.com
For future support, please record your serial number (located on the label at the back of the dispenser) and purchase date. Staple your receipt to the manual.
You will need this information to obtain warranty service.
Product |
Self-Cleaning Hot & Cold Hidden |
|
Bottle-Water Cooler |
Model Number |
8LIECH-SCSSFP5W |
Serial ID Number |
|
Date of Purchase |
|
|
|
|
|
IMPORTANT: Do NOT Return Dispenser To Store.
If you have a question or problem, please contact 1-855-594-4755 for assistance.
|
|
Model # 8LIECH-SCSSFP5W: Page 5 |
||
SPECIFICATIONS |
|
|
|
|
|
|
|
||
|
Power Supply |
AC 120V / 60Hz / 6.5Amp |
||
|
Refrigerant Type |
R-134A |
||
|
Cold Water Power |
100 Watts |
||
|
Cold Capacity / Hour |
4 Litres / 1.06 Gallon |
||
Energy |
Cold Temperature |
3°C - 10°C / 37.4°F - 50°F |
||
Hot Water Power |
650 Watts |
|||
Verified |
||||
Hot Capacity / Hour |
6 Litres / 1.59 Gallon |
|||
|
||||
|
Hot Temperature |
80°C - 92°C / 176°F - 197.6°F |
||
|
Dimensions |
1028H mm x 320W mmx 382D mm |
||
|
|
40.5H inch x 12.6W inch x 15D inch |
||
Version 2.0 |
Net Weight |
36.8 Ibs / 16.7 Kg |
||
PARTS & FEATURES
Control: Hot Water |
1 |
Hot Water Release |
2 |
Control: Cold Water |
3 |
Hidden Faucet or Tap: Hot Water |
4 |
Hidden Faucet or Tap: Cold Water |
5 |
LED Night lights |
6 |
Drip Tray |
7 |
Door |
8 |
Bottle Tray |
9 |
Water Pump |
10 |
Door Switch |
11 |
Bottle Probe |
12 |
Cold Power Switch(Energy Saving) |
13 |
Hot Power Switch (Energy Saving) |
14 |
Power Cord |
15 |
Carry Handle |
16 |
Drain Plug |
17 |
Condenser |
18 |
|
Front |
Back |
1 |
|
14 |
2 |
3 |
|
|
|
13 |
4 |
5 |
15 |
|
||
|
6 |
16 |
|
|
7 |
10 |
17 |
|
11 |
|
|
12 |
|
8 |
|
|
|
|
18 |
|
9 |
|
IMPORTANT: Do NOT Return Dispenser To Store.
If you have a question or problem, please contact 1-855-594-4755 for assistance.
Model # 8LIECH-SCSSFP5W: Page 6
UNPACKING AND ASSEMBLY
Remove the dispenser from packaging:
TO OPEN: |
TOP |
|
|
TOP |
TOP |
|
TOP |
WARNING
Excessive Weight Hazard
Use two or more people to move and install the water cooler and the bottles.
Failure to do so can result in back or other injury.
1.Lay the box containing the unit on its side.
2.Open bottom flaps of the cardboard box.
3.Stand cooler upright, with box flaps unfolded.
4.Pull box straight up.
5.Unpack the drip tray and insert it into the dispenser.
6.Keep original packing for the duration of warranty.
INSTALLATION
WARNING
Excessive Weight Hazard
Use two or more people to move and install bottles.
Failure to do so can result in back or other injury.
Note: Do NOT plug in the power cord until told to do so.
1.Place the dispenser on a hard and level surface in a cool, shaded location near a grounded wall outlet.
2.Position dispenser so that the back is at least 4 inches from the wall, and there are at least 4 inches of clearance on both sides.
3.To minimise vibrations and noise, use mat provided. If required, place shims under the bottom of dispenser to make it sit even without rocking.
IMPORTANT: Do NOT Return Dispenser To Store.
If you have a question or problem, please contact 1-855-594-4755 for assistance.
Loading...