tekmar 479 Installation

- Data Brochure
tekmarNet®4 User Switch 479
D 479
05/07
1
Information
Brochure
Choose controls
to match
application
2
Application
Brochure
Design your
applications
3
Rough In
Rough-in
instructions
Wiring
wiring
4
Wiring
Brochure
Wiring and
installation of
specific control
5
Control settings
and sequence of
Introduction
The User Switch 479 has 3 buttons that allow users to easily change between scenes.
Features
tN4 Compatible
3 User buttons
Data
Brochure
operation
6
Job
Record
Record settings &
wiring details for
future reference
Away
Decora cover plate not included
1 of 4 © 2007 D 479 - 05/07
Table of Contents
Table of Contents ............................................................2
Sequence of Operation ...................................................2
Applications ....................................................................3
Error Messages ..............................................................3
Sequence of Operation
Three User Buttons
The User Switch provides users with a simple interface to change the operating scene of the tN4 system.
Each of the 3 User Buttons is programmed to select a particular scene on the tN4 system. The temperature of each tN4 thermostat in the system is pre-programmed by the installer for each of the scenes. This allows users to change the temperature of all the thermostats using a single button.
Cleaning the User Switch ..............................................4
User Button Label Template ...........................................4
Warranty .........................................................................4
When a selected scene is “On” and that User button is pressed again, the scene is changed based on the following table:
Current Scene
Press the
Same Button
New Scene
Perm Scene 1 No Change
Away
tN4 thermostats must have Scenes turned to “On” in order to respond to scene changes on the User Switch.
When a User Button is pressed, the green LED under that button turns on and remains on until a new scene is selected.
When the current selected scene on the tN4 network is the same as the scene that the User Button is programmed for, the button turns green.
Perm Scene 2
- Away
Perm Scene 3
- Unoccupied
Selects Scene 1
Selects Scene 1
Included with the User Switch are labels to identify the operation of each User Button. Each label has a description on it. Choose the label with the appropriate description for each button.
A template has been included on the back page to create your own labels.
Insert the label into the slot located under the right hand side of each User Button.
Repeat for each User Button.
UP
© 2007 D 479 - 05/07 2 of 4
Away
Loading...
+ 2 hidden pages