z 4 Channel BNC Camera Input
z 1 Channel BNC Video Output
z Video Source Option: NTSC / PAL
z Motion Detection with Sensitivity and Area Settings
z Time Schedule Recording / Motion Triggered Recording
z One ATA-100 Hard Drive Interface
z USB 2.0 Back up to computer
z Remote Control
2.1 Front Panel
CH1 #1
Channel #1
Chapter 2: Layout
Stop #10
IR Receiver
Stop recording / playing
CH2 #2
CH3 #3
CH4 #4
Quad #5
Pause #7
Play #8
REW #6
FWD #9
Channel #2
Channel #3
Channel #4
Quad View
Rewind
Pause
Play recorded video
Forward
REC #11
Menu/Esc #12
SEL/Edit #13
Up #14
Down #15
PWR #16
HDD #17
- 1 -
Record
Enter / exit setup menu
Select / modify item
Move up / left cursor
Move down / right cursor
Power indicator LED
Hard drive indicator LED
2.2 Rear Panel
1 BNC video output
QSD004C4-250 User’s Manual
4 BNC video inputs
Power Supply Input
Fan
Grounding Terminal
USB Port is located on the right side of the case.
2.3 Remote Control
CH1 Select or enlarge Channel #1
CH2 Select or enlarge Channel #2
CH3 Select or enlarge Channel #3
CH4 Select or enlarge Channel #4
Quad Quad View Rewind Play recording list Forward Record Pause Stop recording / playing back
Menu Enter or exit setup menu Move up / left cursor
SEL Select / modify item Move down / right cursor
- 2 -
QSD004C4-250 User’s Manual
Chapter 3: Installation (optional)
3.1 Installing Hard Drive
Note: This model comes with a 250GB Hard Drive already installed, so
this would only be necessary if you are replacing the hard drive.
1. Unplug the power supply. Don’t install or uninstall HDD when DVR is on!!
2. Carefully open the DVR case.
3. Connect the power cord and data cable to hard disk drive.
The 4 pin connection is the DC power cable for HDD, and the wider cable is the standard
hard drive IDE type connection.
Make sure the HDD is set as MASTER according to the hard drive manual.
4. Carefully replace the case cover.
3.2 Connecting Camera and Monitor
There are 4 camera inputs and 1 video output with BNC connectors (Refer to
2.2 Rear Panel). Attach the cable from each of the cameras to one of the BNC video
input ports. Attach a RCA video cable (not included) to the video out put port on the
DVR using a RCA to BNC adapter (included) and to a RCA video in port on the TV.
3.3 Connecting Power Supply
Please only use the power adapter supplied with the DVR. The standard power
supplied to the DVR is DC 12 Volts, 3 Amps.
- 3 -
QSD004C4-250 User’s Manual
Chapter 4: System Boot
4.1 Detecting Installed Hard Drive
Checking HDD ……
MASTER…
After connecting the power, the system will
boot-up and detect the installed hard drive.
On the screen it will show the hard drive
information.
4.2 Recovering Lost Data
RECOVER HDD?
04811-101735
(SELECT)YES/(MENU)NO
4.3 Restore Recording Feature
Power Error Detected
Restore Hard Disk (Master) OK
Restore REC Mode…………
OK
A power error can cause data to be lost, the
DVR system can automatically recover lost
data after power is reconnected.
If a power error occurs during the
recording process, the system will
automatically resume recording after
power is reconnected.
- 4 -
Loading...
+ 16 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.