KEYENCE OP-87524 User Manual
96M11938
When installing the Stand Main Unit to the equipment, ensure
insulation from the equipment. Since the Lens and the Camera have a
Case Grounding, if it is connected directly without insulation when
NOTICE
there is a difference in potential or where there is noise, it may cause
damage to or malfunction of the device.
Telecentric Macro Lens Mounting Stand
OP-87524
Instruction Manual
Read this manual before using the product in order to achieve maximum performance.
Keep this manual in a safe place after reading it so that it can be used at any time.
Checking the Package Contents
The OP-87524 is supplied with the following items. Check that all are included in the package.
F Stand . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
F Front Metal Bracket for Lens Mount. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
F Rear Metal Bracket for Lens Mount . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
F Mounting Screws (M4×L16mm double sems screw ×8) . . . . . . . . . . . . . . . . . . . . . 1 set
F Instruction Manual (this document)
* We make every effort to ensure products reach our customers without any damage.
However, if you encounter any defective, damaged, or missing parts, please contact
your nearest KEYENCE sales office.
Introduction
This is the instruction manual for the Dedicated Mounting Stand for the Telecentric Macro
Lens CA-LM0307. When using the CA-LM0307, it is necessary to fix the Lens Main Unit to
the equipment using this item or a stand of similar structure.
Symbols
This manual uses the following symbols so that you can recognize important messages at
a glance. Please read it in its entirety..
It indicates a situation which, if not avoided, could result in product
NOTICE
damage as well as property damage.
Installation
Refer to the diagram below to assemble the Stand and fix it to the Telecentric Macro Lens.
1. To tighten the bracket for fixing the Lens, tighten the round holes first, then
tighten the elliptical holes.
Dimensions
When attached to the CA-LM0307, CV-035C/M and XG-035C/M
68
Stand Main Unit screw positions
70
LENS Center
80
When attached to the CA-LM0307, CV-200C/M, CV-H035C/M, CV-H100C/M,
CV-H200C/M, CV-H500C/M, XG-200C/M, XG-H035C/M, XG-H100C/M, XG-H200C/M
and XG-H500C/M
Stand Main Unit screw positions
LENS Center
0.2 2560
70
60 250.2
41.2
(34.5)
(131.7) (48.3)
130.7
41.2
68
(34.5)
6.7
Unit: mm
Unit : mm
(60)(131.7)
1
80
130.7
Stand weight: approximately 160g
6.7
1
Recommended tightening torque:
80 to 100 cN·m (between Stand and Bracket)
Stand Main Unit Fixing recommended screw:
M4 double sems L-16 ×4
(fix the Stand Main Unit by the lower portion.)
2012
11938E 1012-1 96M11938
Loading...