Apple G5, RAID, XSERVE RAID User Manual



Xserve, Xserve G5, Xserve RAID

Hard Drive

Replacement Instructions

Follow the instructions in this sheet carefully. Failure to follow these instructions could
damage your equipment and void its warranty.

Online instructions covering customer-installable parts are available at
http://www.info.apple.com/installparts/.

Note:

Blank drive carriers, which may fill some of the hard drive bays, follow the same
replacement procedure as hard drives. If you are replacing a blank carrier with a drive
module, be sure to keep the blank for possible future use. Blank drive carriers must be
installed in all empty drive bays to maintain proper airflow through the unit. Be careful not
to apply excessive pressure when installing the blank carriers.

Tools Required

No tools are required for this procedure.

Preliminary Steps

Xserve/Xserve G5 includes one to four drive bays, and Xserve RAID includes fourteen
drive bays for Apple Drive Modules. The modules consist of hard drives attached to
carriers; they are removed from or installed in the server as a unit. You can replace hard
drives while the system is running; you do not need to shut down or open the unit first.

Note:

There are two LED indicators on the front of each drive.

• The upper LED (Xserve) or right LED (Xserve RAID) shows drive status: a green light

indicates the drive is good; a yellow or red light indicates the drive should be replaced
or removed and reinserted.

• The lower LED (Xserve) or left LED (Xserve RAID) shows drive activity: when the light

is blinking, the system is reading from or writing to the drive. To avoid losing data,
never remove a drive when the lower or left LED is blinking.

1. If the hard drives are in the locked position (the yellow security LED on the front panel

is on), use the Allen key that came with the system to unlock them.

WARNING:

drive. If the drives are locked, pulling on the drive to remove it could damage the
drive handle.

Drives must be in the unlocked position before you attempt to remove a

2. Wait for the lower or left LED on the front of the drive to stop blinking.

073-0666 Rev. E

Removing the Installed Hard Drive

1. Make sure the drive being replaced is not in use by any application and that removing

it will not disrupt the RAID scheme in use.

2. Press the handle on the front of the drive module so the handle pops out.

Note:

The illustrations below are for Xserve drives; Xserve RAID drives, although

oriented vertically, are removed in a similar way.

Figure 1

(Figure 1)

3. Wait for the upper or right LED on the drive to go out. Then grasp the drive handle, and

pull the drive module out of the server.

Figure 2

(Figure 2)

Xserve, Xserve G5, Xserve RAID Hard Drive -

2