Mobile Cam (Model MF68 )
User Manual
Edition: 1st edition, February, 2008
Copyright © 2008 by ZTE Corporation
MF68
|
Contents |
|
1 Warning and precautions ........................................................ |
6 |
|
1.1 |
Precautions............................................................................................................... |
6 |
1.2 |
Aircraft safety............................................................................................................ |
7 |
1.3 |
Precautions for medical Mobile Cams and facilities ............................................... |
7 |
1.4 |
General safety .......................................................................................................... |
8 |
1.5 |
Road safety .............................................................................................................. |
8 |
1.6 |
Vehicles equipped with an air bag ........................................................................... |
9 |
1.7 |
Third-party equipment .............................................................................................. |
9 |
1.8 |
Radio frequency energy........................................................................................... |
9 |
2 Getting to know your Mobile Cam......................................... |
11 |
|
2
|
|
MF68 |
2.1 |
Overview ................................................................................................................. |
11 |
2.2 |
Technical parameters.............................................................................................. |
12 |
2.3 |
Environment requirement ....................................................................................... |
12 |
2.4 |
Your Mobile Cam .................................................................................................... |
13 |
2.5 |
Getting started ........................................................................................................ |
16 |
|
2.5.1 SIM/USIM card....................................................... |
16 |
|
2.5.2 T-FLASH .................................................................... |
18 |
|
2.5.3 Battery....................................................................... |
18 |
|
2.5.4 Charging the battery.......................................... |
19 |
|
2.5.5 Understanding indicators................................ |
20 |
2.6 |
Power on/off ............................................................................................................ |
21 |
2.7 |
Fixing the Mobile Cam onto the ceiling.................................................................. |
21 |
3 White list............................................................................... |
23 |
|
3.1 |
Mobile Cam’s own phone number.......................................................................... |
23 |
3.2 |
Setting administrator (AD) number ........................................................................ |
23 |
3.3 |
Setting other user numbers .................................................................................... |
24 |
3.4 |
User entry................................................................................................................ |
25 |
3
MF68 |
|
|
|
4 |
Mobile CAM controlled by 3G video phone............................ |
25 |
|
|
4.1 |
Camera adjustment................................................................................................ |
26 |
|
4.2 |
Adjusting speaker volume...................................................................................... |
26 |
5 |
Administrator main menu operation...................................... |
27 |
|
|
5.1 |
Video phone main menu operation........................................................................ |
28 |
|
|
5.5.1 Adding users........................................................... |
29 |
|
|
5.5.2 Deleting user.......................................................... |
29 |
|
|
5.5.3 Changing PIN code.............................................. |
30 |
|
|
5.5.4 Changing administrator number .................. |
31 |
|
|
5.5.5 Video recording .................................................... |
31 |
|
5.2 |
SMS command operation ...................................................................................... |
32 |
6 |
Infrared/daylight Operation Modes and Non-white List User |
||
|
Validation Function............................................................... |
38 |
|
7 |
Trouble Shooting................................................................... |
40 |
|
4
MF68
Thank you for using the Mobile Cam.
To guarantee the Mobile Cam is always in best condition, please read this manual carefully and keep for further use. The pictures and contents in this manual are for your reference only. They might not be completely identical to your Mobile Cam.
5
MF68
1Warning and precautions
1.1Precautions
The Mobile Cam contains delicate electronic circuitry and battery systems. You should treat it with care and pay particular attention to the following points:
uDo not allow the Mobile Cam, battery or accessories to come into contact with liquids or moisture at any time. Do not immerse in any liquid.
uThe Mobile Cam can’t do the video call over 3 hours continuously. If the time is over 3 hours, it will shut off automatically.
uDo not place the Mobile Cam alongside computer disks, credit cards, travel cards or other magnetic media. The information contained on disks or cards may be affected by the Mobile Cam.
uDo not leave the Mobile Cam in places where the temperature could exceed 60°C – e.g. on a car’s dashboard or a windowsill or behind glass in direct sunlight.
uDo not dispose the Mobile Cam in a fire. This equipment is fitted with an internal battery that can only be replaced by a qualified service engineer so used batteries must be safely disposed at a recycling point.
uDo not attempt to dismantle the Mobile Cam or any of its accessories.
6
MF68
uThe Mobile Cam may become warm during normal use. The Mobile Cam may also become warm while the battery is being charged.
uUse a damp or anti-static cloth to clean the Mobile Cam. Do not use chemical or abrasive cleaners as these could damage the case.
1.2 Aircraft safety
u Onboard an aircraft, please turn off your Mobile Cam before take-off. In order to protect aircraft communications systems from interference, do not use the Mobile Cam while in flight. Using the Mobile Cam before take-off requires aircrew permission, according to safety regulations.
u Do not use the Mobile Cam on the ground at an airport without permission from ground staff.
1.3 Precautions for medical Mobile Cams and facilities
uWhen using your Mobile Cam near pacemakers, please: Always keep the Mobile Cam more than 8 inches (20 centimeters) from the pacemaker while the Mobile Cam is switched on.
uIf you use any other personal medical device, please consult the device manufacturer to determine if it is adequately shielded from RF energy.
7
MF68
uIf on premises with special demands, such as hospital or healthcare facilities, please pay attention to the restriction of the use of the Mobile Cams. Switch off your Mobile Cam if required.
1.4 General safety
u Keep the Mobile Cam out of the reach of small children. The Mobile Cam may cause injury if used as a toy.
u The operation of some medical electronic items, such as hearing aids and pacemakers, may be affected if the Mobile Cam is used in close proximity. Observe any related signs and manufacturer recommendations.
1.5 Road safety
uSwitch off your Mobile Cam at refueling points, such as petrol stations, even if you are not refueling your own car.
uDo not store or carry flammable or explosive materials in the same compartment as a radio transmitter.
uElectronic vehicle systems, such as anti-lock brakes, speed control and fuel injection systems are not normally affected by radio transmissions. The manufacturer of such equipment can advise if it is adequately shielded from radio transmissions. If you suspect vehicle problems caused by radio transmissions, consult your dealer and do
8
MF68
not switch on the Mobile Cam until it has been checked by qualified and approved installers.
1.6 Vehicles equipped with an air bag
u An air bag inflates with great force. Do not place objects, including installed or portable wireless equipment in the area above the air bag or in the air bag deployment area. If in-vehicle wireless equipment is improperly installed and the air bag inflates, serious injury could result.
1.7 Third-party equipment
u The use of third-party equipment, cables or accessories, not provided or authorized by ZTE, may invalidate the warranty of your Mobile Cam and also adversely affect the Mobile Cam’s operation.
1.8 Radio frequency energy
uYour Mobile Cam is a low-power radio transmitter and receiver. When it is switched on, it intermittently receives and transmits radio frequency (RF) energy (radio waves). The system that handles the call also controls the power level at which the Mobile Cam transmits.
uThe antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20cm from all persons.
9
MF68
uThis device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:(1)This device may not cause harmful interference, and(2)this device must accept any interference received, including interference that may cause undesired operation.
uNOTE:The phone has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation.
The phone generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If the phone does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
10
MF68
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
—Consult the dealer or an experienced radio/ TV technician for help.
uWe,ZTE Corporation,declared that the product is installed with battery separately in the box.The FCC ID label is placed on the mobile cam clearly visible to all persons at the time of purchase.
2Getting to know your Mobile Cam
2.1Overview
Empowered by the latest 3G technology, Mobile Cam is capable of receiving video phone calls automatically. Users can dial the Mobile Cam from any WCDMA handset supporting video phone calls, and view the picture with sound captured by the Mobile Cam anytime, anywhere. The Mobile Cam supports video call, but doesn’t support voice call.
11
MF68
2.2 Technical parameters
Type |
|
Mobile Cam(Model: MF68) |
||
Dimensions W×L×H |
105mm×85mm×112mm |
|||
Weight |
|
263g (with integrated battery) |
||
Camera |
|
0.3 megapixel (solar/infrared dual mode) |
||
Battery |
|
|
|
|
Continuous standby time |
|
120-200 hours |
||
Recording time |
(in sunlight environment) |
7-12 hours |
||
Recording time |
(in infrared environment) |
3-5 hours |
||
Video communication time (in sunlight environment) |
2-3 hours |
|||
Video communication time (in infrared environment) |
1.6-2.6 hours |
|||
Charging time |
|
|
5 hours |
|
2.3 Environment requirement
The Mobile Cam can be used indoors or half-outdoors – e.g. inside an automobile. Environment parameter details are as follow:
Working temperature range: 10 45
12
MF68
Relative humidity: 5 95 without dew
Power supply: 220V supply, integrated spare battery
This mobile camera is only used in WCDMA network.
2.4 Your Mobile Cam
Front view of your mobile cam
13
Loading...