Linear DXS-LRP-BK, DXS-LRP Owner's Manual

	DXS-LRP	PRODUCT DESCRIPTION		FEATURES
		The Model DXS-LRP is a battery powered, miniature, water-resistant*, supervised		THE PENDANT IS DESIGNED
		transmitter designed for use in emergency applications with Linear’s DX and DXS
				TO BE WORN WITH THE BUTTON
	BY	format receivers. The transmitter is supplied with an adjustable lanyard with a		TOWARDS THE CHEST TO ALLOW
		breakaway release. Pressing the button on the transmitter sends a digitally coded		EASY THUMB PRESS ACTIVATION
	SUPERVISED	wireless signal to its companion receiver. To insure sending a complete signal,		AND PROVIDE THE WEARER WITH
		press the transmitter button for a minimum of two seconds.		A DISCRETELY STYLED DEVICE
	LONG RANGE	The DXS-LRP transmitter is factory set to a unique code, so no fi eld coding is
		required. The DXS-LRP sends a signal when its button is pressed. The transmitter
	PENDANT
		can send a signal for up to 30 seconds per activation. The signal indicator on
	TRANSMITTER	the transmitter lights green when the unit is activated. Receivers must be
		programmed to the transmitter’s code before system testing and operation. Refer
		to the receiver’s instructions for details on programming.		LANYARD
	Operation	If status transmissions are enabled, the transmitter will send a status signal every		LENGTH
		two hours. Some receivers are able to monitor status signals, others are not.	2-COLOR	ADJUSTER
	Instructions	Every two hours the transmitter tests for a low battery. This test takes place even if	SIGNAL
			INDICATOR
		status transmissions have not been enabled. If the battery tests low, a low battery
		signal is sent. If the transmitter is activated with a low battery, the signal indicator	GREEN = BATTERY OK
		will light red.		BREAKAWAY
			RED = BATTERY LOW
		Each transmitter is sealed to provide water-resistance. The unit’s battery is not		RELEASE
	USA & Canada [phone] & [phone]	replaceable. The transmitter should be discarded at the end of its battery life.	ACTIVATION
		* NOTE: Water resistance not tested by UL
	[phone] - Toll Free FAX [phone]		BUTTON
	www.linearcorp.com
	STATUS OPTION & PROGRAMMING	SYSTEM TESTING	LINEAR LIMITED WARRANTY
	IF THE TWO HOUR STATUS TIMER IS DESIRED FOR SUPERVISION,	IMPORTANT ! TEST SYSTEM WEEKLY !	This Linear product is warranted against defects in material and workmanship for twenty-four (24) months.
			This warranty extends only to wholesale customers who buy direct from Linear or through Linear’s
	PERMANENTLY ENABLE THE TIMER BY PRESSING THE TRANSMITTER BUTTON	THE MANUFACTURER STRONGLY RECOMMENDS THAT YOU TEST EMERGENCY
			normal distribution channels. Linear does not warrant this product to consumers. Consumers should
	FIVE TIMES IN SUCCESSION WITHIN 3 TO 4 SECONDS. WHEN STATUS	EQUIPMENT FREQUENTLY. OVER A PERIOD OF TIME, NO ELECTRONIC
			inquire from their selling dealer as to the nature of the dealer’s warranty, if any. There are no obligations
	REPORTING IS TURNED ON, THE LED SIGNAL INDICATOR WILL BLINK 3 TIMES	PRODUCT IS BETTER THAN THE INSPECTION AND MAINTENANCE IT RECEIVES.	or liabilities on the part of Linear LLC for consequential damages arising out of or in connection
	AFTER ACTIVATION.	THEREFORE, FROM THE TIME OF INSTALLATION, IT IS ABSOLUTELY NECESSARY	with use or performance of this product or other indirect damages with respect to loss of property,
		TO TEST THE SYSTEM AT LEAST ONCE A WEEK.	revenue, or profit, or cost of removal, installation, or reinstallation. All implied warranties, including
		PLACE THE RECEIVER IN "TEST" MODE AND	implied warranties for merchantability and implied warranties for fi tness, are valid only until the warranty
		ACTIVATE THE TRANSMITTER. VERIFY THAT	expires. This Linear LLC Warranty is in lieu of all other warranties express or implied.
			All products returned for warranty service require a Return Product Authorization Number (RPA#). Contact
		THE SIGNAL WAS RECEIVED AND THAT THE
			Linear Technical Services at 1-800-421-1587 for an RPA# and other important details.
		SYSTEM REPORTS AS REQUIRED.
				IMPORTANT !!!
			Linear radio controls provide a reliable communications link and fi ll an important need in portable wireless
		IF THE SIGNAL INDICATOR	signaling. However, there are some limitations which must be observed.
	INSTRUCTIONS FOR	LIGHTS RED WHILE THE	For U.S. installations only: The radios are required to comply with FCC Rules and Regulations as
		BUTTON IS PRESSED,	Part 15 devices. As such, they have limited transmitter power and therefore limited range.
	THE INSTALLER	THE BATTERY IS	A receiver cannot respond to more than one transmitted signal at a time and may be blocked by radio
		LOW AND THE DXS-LRP	signals that occur on or near their operating frequencies, regardless of code settings.
			Changes or modifi cations to the device may void FCC compliance.
		TRANSMITTER NEEDS TO
			Infrequently used radio links should be tested regularly to protect against undetected interference or
		BE REPLACED
			fault.
			A general knowledge of radio and its vagaries should be gained prior to acting as a wholesale
		IF THE SIGNAL INDICATOR BLINKS RED-GREEN 3	distributor or dealer, and these facts should be communicated to the ultimate users.
	PROGRAM THE TRANSMITTER INTO THE RECEIVER BY PLACING THE RECEIVER		This device complies with FCC Part 15 and Canada Rules and Regulations. Operation is subject to the
		TIMES AT THE END OF AN ACTIVATION, THE BATTERY
			following two conditions: (1) This device may not cause harmful interference and (2) this device must
	INTO PROGRAM MODE, THEN SEND A SIGNAL TO THE RECEIVER FROM THE
		IS GETTING NEAR ITS LOW BATTERY LEVEL. NO LOW	accept any interference received, including interference that may cause undesired operation.
	TRANSMITTER. REFER TO THE UL LISTED PERS-2400B OR PERS-3600B
		BATTERY SIGNAL IS SENT IN THIS CONDITION.
	RECEIVER'S PROGRAMMING INSTRUCTIONS FOR DETAILS.		Copyright © 2012 Linear LLC	230836 D