Linear ACT-31DH, ACT-31DHC, ACT-34DH, ACT-34DHC Owner's Manual

ACT-31DH				DESCRIPTION	PROGRAM TRANSMITTER INTO RECEIVER
			The ACT-31DH and ACT-34DH are TRANS PROX key fobs that		Linear’s receivers that accept “Block Coding” can be
			contain a radio transmitter plus a HID proximity tag. Request		programmed to accept a user defined block of ID codes. The
ACT-34DH			access by pressing a button to send a wireless signal to a		ACT-31DH and ACT-34DH TRANS PROXs are block coded.
			Linear MegaCode® receiver or by moving the unit within two		Each block of transmitters are labeled with starting and
			inches of a compatible 26-bit HID format proximity reader. ending block code numbers, along with an optional facility
	ACT-31DH	ACT-34DH	The HID proximity tag is designed to work with Linear’s		code number. Refer to the receiver instructions for details on
			Model AM DPR HID reader, other manufacturer’s 26-bit HID		how to program the block and facility code numbers.
TRANS 0 PROX
			readers may also be compatible, but not all have been tested.		For non Block Coded	single learning receivers, press
Integrated transmitter			The ACT-31DH is a single-button miniature TRANS PROX		the desired transmitter button while the receiver is in
& HID proximity tag			that sends one wireless code. The ACT-34DH is a four-button		programming mode to program that button into the receiver.
			miniature TRANS PROX that sends four different wireless		Refer to the access system instructions for details on how to
Operation			codes, depending on which button is pressed.		enroll the proximity tags into the system.
			In addition to each	unit’s MegaCode® radio transmission
					USE AS A
Instructions			capabilities (factory set from over a million possible ID codes),			HID COMPATIBLE
					PROXIMITY TAG
			both units contain a built-in proximity tag. The proximity tag			TRANS PROX
			is factory programmed to the same ID and facility code as
			the transmitter using card access 26 bit Wiegand format.		LINEAR
	USA & Canada [phone] & [phone]		The TRANS PROXs are powered by two Type 2016 “coin cell”		MODEL	USE AS A
					AM-DPR
	[phone] - Toll Free FAX [phone]		batteries. A 2-part key ring is supplied with the units.			TRANSMITTER
	www.linearcorp.com
		REPLACING BATTERIES			LINEAR LIMITED WARRANTY
					This Linear product is warranted against defects in material and workmanship for twelve (12) months.
1	TWIST A COIN IN SLOT TO	2 REMOVE THE BACK OF THE CASE		3 REMOVE THE TWO	This warranty extends only to wholesale customers who buy direct from Linear or through Linear’s normal
					distribution channels. Linear does not warrant this product to consumers. Consumers should inquire from
	OPEN TRANSMITTER CASE			BATTERIES	their selling dealer as to the nature of the dealer’s warranty, if any. There are no obligations or liabilities on
					the part of Linear LLC for consequential damages arising out of or in connection with use or performance of
					this product or other indirect damages with respect to loss of property, revenue, or profit, or cost of removal,
					installation, or reinstallation. All implied warranties, including implied warranties for merchantability and
					implied warranties for fitness, are valid only until the warranty expires. This Linear LLC Warranty is in lieu
					of all other warranties express or implied.
					All products returned for warranty service require a Return Product Authorization Number (RPA#). Contact
					Linear Technical Services at 1-800-421-1587 for an RPA# and other important details.
				DISCARD BATTERIES	IMPORTANT !!!
					Linear radio controls provide a reliable communications link and fill an important need in portable wireless
				PROPERLY	signaling. However, there are some limitations which must be observed.
					• For U.S. installations only: The radios are required to comply with FCC Rules and Regulations as Part 15
4				5	devices. As such, they have limited transmitter power and therefore limited range.
					• A receiver cannot respond to more than one transmitted signal at a time and may be blocked by radio
					signals that occur on or near their operating frequencies, regardless of code settings.
SLIDE IN TWO NEW				SNAP CASE	• Changes or modifications to the device may void FCC compliance.
					• Infrequently used radio links should be tested regularly to protect against undetected interference or
TYPE 2016 BATTERIES
				TOGETHER	fault.
					• A general knowledge of radio and its vagaries should be gained prior to acting as a wholesale distributor
BE SURE BOTH PLUS (+)					or dealer, and these facts should be communicated to the ultimate users.
SIDES ARE FACING AWAY					• This device complies with FCC Part 15 and Industry Canada Rules and Regulations. Operation is subject
					to the following two conditions: (1) This device may not cause harmful interference, and (2) this device
FROM THE CIRCUIT BOARD
					must accept any interference received, including interference that may cause undesired operation.
					Copyright © 2010 Linear LLC	231340 A