getting started guide
hp LaserJet 1200
Copyright Information
© Copyright Hewlett-Packard Company 2002
All Rights Reserved. Reproduction, adaptation, or translation without prior written permission is prohibited, except as allowed under the copyright laws.
Part number: C7044-90939
First Edition: March 2002
FCC Regulations
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy. If this equipment is not installed and used in accordance with the instructions, it may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase separation between equipment and receiver.
Connect equipment to an outlet on a circuit different from that to which the receiver is located.
Consult your dealer or an experienced radio/TV technician.
Any changes or modifications to the printer that are not expressly approved by HP could void the user’s authority to operate this equipment.
Use of a shielded interface cable is required to comply with the Class B limits of Part 15 of FCC rules.
For more regulatory information, see the HP LaserJet 1220 electronic user guide.
Warranty
The information contained in this document is subject to change without notice.
Hewlett-Packard makes no warranty of any kind with respect to this information.
HEWLETT-PACKARD SPECIFICALLY DISCLAIMS THE IMPLIED WARRANTY OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE.
Hewlett-Packard shall not be liable for any direct, indirect, incidental, consequential, or other damage alleged in connection with the furnishing or use of this information.
Trademark Credits
Microsoft ®, Windows ®, and Windows NT ® are U.S. registered trademarks of Microsoft Corporation. All other products mentioned herein may be trademarks of their respective companies.
© 2002 Hewlett-Packard Company
制、改编或翻译。
C7044-90939
2002 3
FCC
FCC 15 B
/
HP
FCC 15 B
HP LaserJet 1220
Hewlett-Packard
HEWLETT-PACKARD
Hewlett-Packard
Microsoft® Windows® Windows NT® Microsoft Corporation
Preparation/
|
|
4 |
in.)(10.0mm |
19.1 |
|
1 |
|
2 |
|
|
7 |
|
|
3 |
253 |
486 |
|
|
|
|
486 mm (19.1 in.) 486 19.1 |
|
6 |
5 |
|
Review package contents. Make sure all parts are included. |
Prepare the location. Place on a sturdy, level surface. Allow space for |
|
1) |
HP LaserJet 1200 series printer. 2) Toner cartridge (in protective bag). |
ventilation. Allow space behind the printer for output from the |
3) |
Getting Started Guide. 4) Software and electronic user guide (on |
straight-through media doors. |
CD-ROM). 5) Power cord. 6) Printer media input tray. 7) Printer priority media input tray.
1) HP LaserJet 1200 |
12345'67 89:* 12;<=> ' ?:12@A= |
2) 3) 4) ! "#$%& '()* |
>BCDEF;GHIJ K2. |
5) #+, 6) -.) 7) /0-.) |
|
(QJOLVK
Regulate the environment. Do not place in direct sunlight. Ensure the environment is free from abrupt temperature or humidity changes.
•Temperature— 10° to 32.5° C (50° to 91° F).
•Relative humidity— 20% to 80%.
LMNOPQ5'R(FS TU NOPV2WXY Z["\[ ]^
•Z[ — 10° _ 32.5° C 50° _ 91° F
•`a\[ — 20% _ 80%
(QJOLVK
Assembly/
|
|
1
2
Open the toner door. Pull the sides of the door forward until the door locks in its open position. Leave the door open until step 7.
(QJOLVK
Remove the left side panel. 1) Grasp the left side panel using the finger hole. 2) Pull out and remove the panel.
b J cJ defghBF_iA' b 34 'jklX opq:r 1) s% tuvq:r 2) h2wopx:r 7 mg@F n b
|
|
2
1
(QJOLVK
Connect USB or parallel cable to printer. The HP LaserJet 1200 printer includes USB and parallel ports. Connect one cable to the proper port and run the cable through the cable slot. Do not connect the cable to the computer until Step 11 (during software installation).
c USB ywkz,{ |} HP LaserJet 1200 ~ USB •
€"w€ c@•z,|}_`‚ •€*Bƒz,Ez,„K…† ‡ '! ˆ lX 11 m?B‰cz,{Š‹ |}
Reattach the left side panel. 1) Insert the left side panel tabs behind the edge of the front panel. 2) Swing the panel shut.
Œ•|*q:r 1) cq:rŽ•• g:r‘’ ? 2) “”x:rC c•–*
Loading...