Gateway 6021GZ, 6525GP, 6018GZ, 6010GZ, 6510GZ Manual

...
0 (0)

Replacing the AC Adapter

To connect the AC adapter:

1 Connect the power cord to the AC adapter.

Caution Replace the power cord if it becomes damaged. The replacement cord must be of the same type and voltage rating as the original cord or your notebook may be damaged.

2Connect the AC adapter to your notebook’s power connector.

Replacing the AC Adapter

3Plug the power cord into a wall outlet. The power indicator turns on.

Power indicator

If the power indicator does not turn on, unplug the adapter from your notebook, then plug it back in.

Warning Do not attempt to disassemble the AC adapter. The AC adapter has no user-replaceable or user-serviceable parts inside. The AC adapter has dangerous voltages that can cause serious injury or death. Contact Gateway about returning defective AC adapters.

Technical Support

See the label on the bottom of the notebook for Customer Care information.

Safety, Regulatory, and Legal

Information

See your user guide for important safety, regulatory, and legal information.

© 2005 Gateway, Inc. All rights reserved. Gateway, Gateway Country, the Gateway stylized logo, and the black-and-white spot design are trademarks or registered trademarks of Gateway, Inc. in the United States and other countries. All other brands and product names are trademarks or registered trademarks of their respective companies.

www.gateway.com

1

Gateway 6021GZ, 6525GP, 6018GZ, 6010GZ, 6510GZ Manual

Replacing the Battery

Tips & Tricks If your notebook is connected to AC power you

can change the battery while the notebook is turned on. If your notebook is not plugged into an AC outlet, you must turn the notebook off while changing the battery.

Locating Components

Battery

Warning Danger of explosion if battery is incorrectly replaced.

Replace only with a battery specifically manufactured for your notebook. Recycle or discard the battery as hazardous waste.

The battery used in this device may present a fire or chemical burn hazard if mishandled. Do not disassemble, heat above 212°F (100°C), or incinerate. Keep away from children.

To replace the battery:

1If your notebook is on and is connected to AC power, go to Step 2.

- OR -

If your notebook is on and is not plugged into an AC outlet, save your work and turn off the notebook.

2Close the LCD panel.

3Turn your notebook over so the bottom is facing up.

Replacing the Battery

4 Slide the battery lock to the unlock position.

5Slide the battery release latch, then slide the battery out of the notebook.

6Slide the replacement battery into the notebook until it snaps into place.

7Slide the battery lock to the lock position.

8Turn your notebook over.

9Plug your notebook into an AC outlet.

10Open the LCD panel and press the power button.

Technical Support

See the label on the bottom of the notebook for Customer Care information.

Safety, Regulatory, and Legal

Information

See your user guide for important safety, regulatory, and legal information.

© 2005 Gateway, Inc. All rights reserved. Gateway, Gateway Country, the Gateway stylized logo, and the black-and-white spot design are trademarks or registered trademarks of Gateway, Inc. in the United States and other countries. All other brands and product names are trademarks or registered trademarks of their respective companies.

www.gateway.com

1

Replacing the DVD Drive

Tips & Tricks You need a small Phillips screwdriver to replace the DVD drive.

Preventing static electricity discharge

The components inside your notebook are extremely sensitive to static electricity, also known as electrostatic discharge (ESD). ESD can permanently damage electrostatic discharge-sensitive components in your notebook.

Warning To avoid exposure to dangerous electrical voltages and moving parts, turn off your notebook, remove the battery, and unplug the AC adapter, modem cable, and network cable before replacing a component.

Warning To prevent risk of electric shock, do not insert any object into the vent holes of your notebook.

Replacing the DVD Drive

4Disconnect all peripheral devices and remove any PC Cards.

5Turn your notebook over so the bottom is facing up, then remove the battery. For more information, see “Changing Batteries” in your user guide.

6With a small Phillips screwdriver, remove the keyboard screw and put it in a safe place.

Tips & Tricks The keyboard screw hole is marked with a K.

Screw

Before working with notebook components, follow these guidelines:

Avoid static-causing surfaces such as carpeted floors, plastic, and packing foam.

Remove components from their antistatic bags only when you are ready to use them. Do not lay components on the outside of antistatic bags because only the inside of the bags provide electrostatic protection.

Always hold components by their edges. Avoid touching the edge connectors. Never slide components over any surface.

Wear a grounding wrist strap (available at most electronics stores) and attach it to a bare metal part of your workbench or other grounded connection.

Touch a bare metal surface on your workbench or other grounded object.

To replace the DVD drive:

1Follow the guidelines under “Preventing static electricity discharge.”

2Turn off your notebook.

3Disconnect the AC adapter, modem cable, and network cable.

7Loosen the six memory bay cover screws (these screws cannot be removed), then remove the memory bay cover.

Screws

Screws

www.gateway.com

1

8With a small Phillips screwdriver, remove the DVD drive screw, then put it in a safe place.

Screw

9Turn your notebook over so the top is facing up.

10Insert a straightened paper clip into the DVD drive’s manual eject hole, push in the paper clip to eject the drive tray, then pull the drive tray open.

11 Carefully slide the drive out of the drive bay.

Replacing the DVD Drive

12Slide the new DVD drive into the drive bay. Make sure that the drive fits securely in the bay.

13Turn your notebook over so the top is facing down.

14Secure the DVD drive with the screw removed in Step 8.

15Replace the memory bay cover, then tighten the six cover screws.

16Replace the keyboard screw.

17Insert the battery, then turn your notebook over.

18Connect the power adapter, modem cable, and network cable, then turn on your notebook.

Technical Support

See the label on the bottom of the notebook for Customer Care information.

Safety, Regulatory, and Legal

Information

See your user guide for important safety, regulatory, and legal information.

© 2005 Gateway, Inc. All rights reserved. Gateway, Gateway Country, the Gateway stylized logo, and the black-and-white spot design are trademarks or registered trademarks of Gateway, Inc. in the United States and other countries. All other brands and product names are trademarks or registered trademarks of their respective companies.

2

www.gateway.com

Loading...
+ 8 hidden pages