POWERSHRED® 425Ci/425i/485Ci/485i
Please read these instructions before use. Do not discard: keep for future reference.
Lire ces instructions avant utilisation. Ne pas jeter : conserver pour référence ultérieure.
Lea estas instrucciones antes de usarlo.
No las deseche: guárdelas para tenerlas como referencia.
Diese Anleitungen vor Gebrauch genau durchlesen.
Bitte nicht entsorgen: zur späteren Bezugnahme aufheben
Prima dell’uso, si raccomanda di leggere questo manuale di istruzioni. Conservare il manuale per consultarlo secondo le necessità.
Dese instructies voor gebruik lezen.Niet weggooien, maar bewaren om later te kunnen raadplegen.
Läs dessa anvisningar innan du använder apparaten.
Släng inte bort, behåll för framtida bruk.
Læs venligst denne vejledning før anvendelse. Bør ikke bortskaffes. Behold for fremtidig henvisning.
Lue nämä ohjeet ennen käyttöä.
Älä hävitä: säilytä myöhempää käyttöä varten.
Vennligst les nøye igjennom denne bruksanvisningen før bruk.
Ikke kast den: Ta vare på den for senere referanse.
Przed użyciem proszę zapoznać się z tą instrukcją. Nie wyrzucać - zachować jako źródło informacji na przyszłość
Перед началом эксплуатации обязательно прочтите данную инструкцию.
Не выбрасывайте данную инструкцию: сохраните ее для последующего использования.
Παρακαλείσθε να διαβάσετε αυτές τις οδηγίες πριν χρησιμοποιήσετε το προϊόν.
Μην τις απορρίψετε: κρατήστε τις για μελλοντική αναφορ
Kullanmadan önce lütfen bu talimatları okuyun. Atmayın: ileride başvurmak üzere saklayın.
Před použitím si pročtěte tyto pokyny. Nelikvidujte: uschovejte pro budoucí použití.
Pred použitím si prečítajte tieto pokyny. Nezahadzujte: odložte pre budúce použitie.
Kérjük, hogy használat előtt olvassa el az utasításokat! Az utasításokat ne dobja ki; tartsa meg referenciaanyagként való jövőbeni használatra.
Leia estas instruções antes da utilização. Não as deite fora: conserve-as para consulta futura.
Quality Office Products Since 1917
|
F. |
|
A. |
G. |
|
|
||
B. |
L. |
|
C. |
||
|
||
D. |
|
E.
H.
K. |
I. |
|
J.
ENGLISH
Models 425Ci/425i/485Ci/485i
KEY
A. SafeSense® Technology |
L. Control panel |
|
B. Paper entry |
1. |
Sheet capacity indicator |
C. CD, credit card and |
2. Low oil indicator (red) |
|
junk mail entry |
|
425Ci and 485Ci only |
D. Door |
3. |
Bin full (red) |
E. Casters |
4. |
SafeSense® (yellow) |
F. See safety instructions |
5. |
Remove paper (red) |
G. Disconnect power switch |
6. |
Door open (red) |
H. Oil reservoir |
7. |
Straight feed (red) |
425Ci and 485Ci only |
8. |
Auto button |
I. Oil drain plug (inside) |
9. |
Reverse |
425Ci and 485Ci only |
10. ON/OFF |
|
J. Basket |
11. Forward |
|
K. Accessory tray |
|
|
2. |
|
|
3. |
1. |
|
4. |
||
|
5.
6.
7.
9.10. 11.
CAPABILITIES
Will shred: Paper, 132 column continuous form, credit cards, CD/DVDs, staples, small paper clips and junk mail
Will not shred: Adhesive labels, transparencies, newspaper, cardboard, large paper clips, laminates, file folders, X-rays or plastic other than noted above
Paper shred size: |
|
Cross-Cut (425Ci, 485Ci)............................................................................ |
3.9mm x 30mm |
Strip-Cut (425i, 485i).............................................................................................. |
5.8mm |
Maximum: |
|
Sheets per pass, 80g paper (Cross-cut) |
......................................................................... 28* |
Sheets per pass, 70g paper (Cross-cut)......................................................................... |
30* |
Sheets per pass, 80g paper (Strip-cut).......................................................................... |
38* |
Sheets per pass, 70g paper (Strip-cut).......................................................................... |
40* |
CDs/Cards per pass........................................................................................................ |
1* |
Paper entry width (485Ci, 485i)............................................................................. |
407mm |
Paper entry width (425Ci, 425i)............................................................................. |
305mm |
*A4, paper at 220-240V/50 Hz, 6Amps; heavier paper, humidity or other than rated voltage may reduce capacity. Recommended daily usage rates: 10,000 sheets per day, 500 credit cards; 50 CDs.
Fellowes SafeSense® shredders are designed to be operated in office environments ranging between 50 – 80 degrees Fahrenheit (10 – 26 degrees Celsius) and 40 – 80% relative humidity.
IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!
•Keep away from children and pets. Keep hands away from paper entry.
Always set to off or unplug when not in use.
•Keep foreign objects – gloves, jewelry, clothing, hair, etc. – away from shredder openings. If object enters top opening, switch to Reverse ( ) to back out object.
•Never use aerosol products, petroleum based lubricants or other flammable products on or near shredder. Do not use canned air on shredder.
•Do not use if damaged or defective. Do not disassemble shredder.
Do not place near or over heat source or water.
•Operation, maintenance, and service requirements are covered in the instruction manual. Read the entire instruction manual before operating shredders.
•This shredder has a Disconnect Power Switch (G) that must be in the ON (I) position to operate shredder. In case of emergency, move switch to OFF (O) position. This action will stop shredder immediately.
•Avoid touching exposed cutting blades under shredder head.
•Use only designated entry for CDs/cards. Keep fingers away from CD entry.
•Do not put foreign objects in paper entry.
•Shredder must be plugged into a properly grounded wall outlet or socket of the voltage and amperage designated on the label. The grounded outlet or socket must be installed near the equipment and easily accessible. Energy converters, transformers, or extension cords should not be used with this product.
•FIRE HAZARD – Do NOT shred greeting cards with sound chips or batteries.
•For indoor use only.
•Unplug shredder before cleaning or servicing.
2
BASIC SHREDDING OPERATION
1
Plug in and put disconnect power switch in ON (I) position
2 |
|
3 |
4 |
|
|
|
or |
Press |
) ON/OFF |
Feed paper into paper |
Feed CD, Credit card |
to activate (blue) |
entry and release |
or junk mail into |
|
|
|
|
designated entry |
and release
5
Set to Off ) or shredder will automatically go into sleep mode after 2 minutes of inactivity
Advanced product features
|
Jam Proof System |
|
|
Auto OilTM |
Patented SafeSense® |
|
|
Energy Saving System |
|
Eliminates paper jams |
|
|
Lubricates the cutters |
Technology |
|
|
Reduces energy |
|
and powers through |
automatically to |
Automatically stops |
|
|
consumption by |
||
|
||||||||
|
tough jobs. |
enhance performance |
when hands touch the |
|
|
up to 70%.* |
||
|
|
|
|
and extend shredder life. |
paper opening. |
|
|
*Compared to conventional shredders |
|
|
|
|
|
|
|
|
during normal usage. |
JAM PROOF SYSTEM OPERATION*
Eliminates paper jams and powers through tough jobs.
1 Advanced Jam PreventionElectronically |
2 |
3 |
measures paper thickness to prevent paper jams:
Up to RED: Too many |
|
Remove several sheets until |
Continue 100% Jam |
|||
sheets have been inserted. |
|
indicator is below red. |
||||
|
|
|
|
Proof Shredding |
||
Up to YELLOW: Productivity |
|
|
|
|
|
|
is optimized. |
|
|
|
|
|
|
Up to GREEN: More sheets |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
can be added. |
|
|
|
|
|
|
|
|
|
|
|
|
Straight Feed
If a misfeed |
All indicators light up and |
occurs: |
shredder pauses for 3-6 seconds |
If Straight Feed indicator illuminates, remove paper and feed straight into shredder.
Wait for flashing to stop after automatic correction |
If |
|
illuminates after paper has been |
|
reversed, press reverse and remove paper. |
||||
is complete. Regular shredding will resume. |
||||
Otherwise, regular shredding will resume. |
||||
|
||||
|
|
|
|
*100% Jam Proof when used in accordance with user manual
AUTO OIL™ OPERATION
Lubricates the cutters automatically to enhance performance and extend shredder life
(Auto oil system is only included on cross-cut models - 425Ci and 485Ci.)
SET-UP AND TESTING |
|
1 |
2 |
|
AUTO |
Before using, fill oil reservoir |
Press the auto and forward |
with 12 oz. (355 ml.) of |
buttons at the same time for |
Fellowes shredder oil |
3 seconds to manually oil |
|
shredder |
REFILLING OIL |
|
1 |
2 |
Low oil indicator will |
To maintain shredder |
signal when your |
performance, refill oil |
reservoir needs refilling |
reservoir with up to 12 oz. |
|
(355 ml.) of shredder oil |
|
(Fellowes #35250) |
3
Once refilled, automatic oiling will resume
3
Advanced product features
SAFESENSE® TECHNOLOGY OPERATION
Automatically stops when hands touch the paper opening.
SET-UP AND TESTING
1 |
2 |
3 |
Turn the shredder on to |
Touch test area and |
SafeSense® is active and |
activate SafeSense® |
look for the SafeSense® |
working properly |
|
indicator to illuminate |
|
ENGLISH
Models 425Ci/425i/485Ci/485i
SLEEP MODE OPERATION
Energy saving feature shuts down the shredder after
2 minutes of inactivity
WHEN IN SLEEP MODE |
|
|
1 |
2 |
3 |
In sleep mode |
To get out of sleep mode or insert paper |
|
touch control panel |
PRODUCT MAINTENANCE
Cleaning Auto-Start Infrared Sensors
Paper detection sensors are designed for maintenance free operation. However, on rare occasions, the sensors may become blocked by paper dust causing the motor to run even if there is no paper present. (Note: two paper detection sensors are located in the center of the paper entry.)
TO CLEAN THE SENSORS |
|
|
|
|
1 |
2 |
3 |
4 |
5 |
Turn off and unplug |
Lift CD flap |
Locate Auto-start |
Dip cotton swab in |
Using cotton swab, wipe |
shredder |
|
infrared sensor |
rubbing alcohol |
away any contamination |
|
|
|
|
from the paper sensors |
AUTO OILTM
Automatically oils the cutters to enhance performance and extend shredder life.
(Auto oil system is only included on cross-cut models - 425Ci and 485Ci)
REFILLING THE OIL
1 |
2 |
3 |
Low oil indicator will |
To maintain shredder |
Once refilled, automatic |
signal when your reservoir |
performance, refill oil |
oiling will resume |
needs refilling |
reservoir with up to 12 |
|
|
oz. (355 ml.) of shredder |
|
|
oil (Fellowes 35250) |
|
•All cross-cut shredders require oil for peak performance. If not oiled, a machine may experience diminished sheet capacity, intrusive noise when shredding and could ultimately stop running. We recommend that you refill the Auto OilTM reservoir as instructed for optimum performance.
•If shipping shredder, oil must be drained. Open cabinet door and remove basket to access oil drain plug. Place suitable container under drain, remove plug and let oil drain out. Replace plug.
4