Epson® PowerLite® 62c/82c
Quick Setup
You should have the following items:
Power cord |
Computer cable |
Projector |
|
Projector |
Password protect |
|
remote control |
sticker |
|
|
|
|
User’s Guide |
Carrying case |
CD-ROM |
|
The projector has 4 video connectors, as shown below. Each one requires a different type of cable. A computer cable is included. You can purchase optional video cables through Epson or at local electronics stores. You can connect up to 4 video devices and use the remote control to switch among them.
1 Check the connectors on your video equipment. If more than one connection is available, choose the one that provides the best quality. The projector connectors from highest to lowest quality are Computer1(Component) or Computer2(Component), S-Video,
and Composite Video.
2 Make sure you have the right cable(s) for the connection(s) you want to use, and the cables are long enough for your setup. If you need a cable longer than the standard 6 to 10 feet, you may need a distribution amplifier. (See the back page for accessory information.)
3
4
Before you connect your equipment, make sure everything is turned off.
Connect your video equipment to the projector.
Component |
Computer |
|
|
|
|
RCA video cable |
|||||||||||||||||||
|
video to |
|
cable |
S-Video |
(composite |
||||||||||||||||||||
VGA cable |
(included) |
cable |
video) |
||||||||||||||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Audio in ports
NOTE To play back audio through the projector, you can connect an audio cable from your video device to the audio in ports on the projector. See the User’s Guide on your CD-ROM for instructions.
1 Remove the battery cover.
2 Insert the batteries.
3 Replace the battery cover.
The remote control is ready for use.