PRECAUTIONS FOR PROPER USE OF AIR CONDITIONER
Please observe the following instructions.
1.Operate the Selector Switch to run or stop the unit.
-Do not use Main Power Switch or Auxiliary Power Switch to operate unit.
2.Do not stick anything into the air outlet or inlet.
-It is dangerous and it can cause injury or damage.
3.Avoid exposing your body directly to a continuous cool air - flow for long periods.
-It is not good for your health.
4.Do not pour water on the unit to clean it.
-It is dangerous and it can cause injury or damage.
Never use solvents or harsh chemicals when cleaning the unit.
When the air inlet grill and cabinet are dirty, wipe with luke - warm water (below 40°C)
5.Avoid placing any obstacles near the inlet or outlet.
-If the inlet or outlet is blocked with any obstacle, it may cause damage to the unit.
6.Do not run or stop the unit frequently.
-If you run or stop the unit more then 4-5 times an hour, it can cause damage to the unit.
7.Wait at least 3 minutes before restarting the unit or in the case of power failure.
-If you turn on the unit within 3 minutes after power off, this can cause damage to the unit.
8.If the air conditioner is operated without an air filter, dust is not removed from the air, and resultant accumulation in the unit may lead to a failure.
-Do not forget to install the air filter.
9.The air filter should be cleaned at least once every two weeks.
10.When the unit is cleaned, set the Selector Switch at off position.
-And then unplug the power plug.
11.Never store gasoline or other flammable liquid near the air conditioner.
-It is very dangerous.
12.Do not force the controls on the front panel too much.
-It can cause damage the controls and the unit.
13.Set a comfortable temperature.
-Very low temperature setting considerably increase power consumption.
14.Be careful to keep room temperature comfortable.
-Avoid continuous direct air flow on you or a sick person while sleeping.
15.Do not remove the plug by pulling the power cord.
-Damage to the cord and may cause shock hazard.
16.This air-conditioner must used 20°C(min)-43°C(max) outdoor and 20°C(min)~32°C(max) indoor on the temperature range.
17.The appliance is not intended for use by young children or infirm persons without supervision.
18.Young children should be supervised to ensure that they do not play with the appliance.
1
TABLE OF CONTENTS
1. GENERAL SPECIFICATIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 2. INSTALLATION INSTRUCTIONS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 3. NAMES OF MAJOR COMPONENTS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 4. OPERATION INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
•FAN & COOLING CONTROL
•TEMPERATURE CONTROL
5. GENERAL INFORMATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
•CHANGING AIR FLOW DIRECTION
•AIR FLOW AROUND UNIT
6. CARE AND MAINTENANCE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
•AIR FILTER
•CLEANING THE AIR CONDITIONER
7. ELECTRICAL REQUIREMENTS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
•ELECTRICAL GROUNDING INSTRUCTIONS.
•USE OF EXTENSION CORDS
8. BEFORE CALLING FOR SERVICE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . |
9 |
|
GENERAL SPECIFICATIONS |
|
|
|
MODEL |
ITEM |
DWB-052C |
|
|
|
|
POWER SOURCE |
AC 220 – 240V ~ 50Hz, SINGLE PHASE |
DIMENSIONS |
440(W) x 313(H) x 385(D) mm |
WEIGHT (NET) |
21Kg - Approx. |
2
INSTALLATION INSTRUCTIONS
• WINDOW INSTALLATION
1.Determine Window Location. Determine a suitable location.
The window where the Air Conditioner is to be installed should have enough strength to bear the weight of the Air Conditioner.
2.Measure unit’s dimensions
3.Install the Mounting Angle at the Proper Location.
Install the Air Conditioner using the Mounting Angle or other Hardware to be installed as shown in Fig.1 For proper drainage, Rear side of the unit should be inclined about 5mm lower.
Mounting Angle
Close up the gap 
unit
5mm
wall
Fig. 1 Mounting Angle Installation.
4.Insert unit in window.
With 2 people, lift unit and insert it into the window opening.
CAUTION : Two people must work together to avoid personal injury.
5.Finish opening
Close up the gap between unit and window using the sponge or tape for insulation as shown in Fig. 1
* If through the wall installation is required, you may choose to consult an independent servicing Dealer.
3
Loading...