Bosch Rotak 37 Ergoflex, Rotak 40 Ergoflex, Rotak 40-17 Ergo, Rotak 43 Ergoflex, Rotak 430 Ergo-Power User Manual

OBJ_DOKU-36002-005.fm Page 1 Monday, January 25, 2016 2:45 PM

Robert Bosch Power Tools GmbH

70538 Stuttgart

GERMANY

www.bosch-garden.com

F 016 L81 421 (2014.10) O / 15 XXX

Rotak

37 Ergoflex | 40 Ergoflex | 40-17 Ergo | 43 Ergoflex | 430 Ergo-Power

en Original instructions

OBJ_BUCH-2011-005.book Page 2 Monday, January 25, 2016 2:46 PM

2 | English

English

Safety Notes

Warning! Read these instructions carefully, be familiar with the controls and the proper use of the machine. Please keep the instructions safe for later use!

Explanation of symbols on the machine

General hazard safety alert.

Read instruction manual.

Pay attention that bystanders are not injured through foreign objects thrown from the machine.

Warning: Keep a safe distance

from the machine when operating.

Caution: Do not touch rotating

blades. Sharp blade(s). Beware of severing toes or fingers.

Not applicable.

Switch off and remove plug from mains before adjusting, cleaning or if the cable is entan-

gled and before leaving the garden product unattended for any period. Keep the supply flexible cord away from the cutting blades.

Wait until all machine compo-

nents have completely stopped before touching them. The

blades continue to rotate after the ma-

chine is switched off, a rotating blade can cause injury.

Do not use the machine in the rain or leave it outdoors when it is raining.

Beware electric shock hazard.

Keep supply flexible cord away from cutting means.

Operation

Never allow children or people unfamiliar with these instructions to use the machine. Local regulations may restrict the age of the operator.

When not in use store the machine out of reach of children.

This machine is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the machine by a person responsible for their safety.

Children should be supervised to ensure that they do not play with the machine.

Never mow while people, especially children, or pets are nearby.

The operator or user is responsible for accidents or hazards occurring to other people or their property.

Do not operate the machine when barefoot or wearing open sandals, always wear substantial footwear and long trousers.

	F 016 L81 421 | (25.1.16)				Bosch Power Tools

OBJ_BUCH-2011-005.book Page 3 Monday, January 25, 2016 2:46 PM

Thoroughly inspect the area where the machine is to be used and remove all stones, sticks, wires, bones and other foreign objects.

Before using, always visually inspect to see that the blades, blade bolts and cutter assembly are not worn or damaged. Replace worn or damaged blades and bolts in sets to preserve balance.

Mow only in daylight or in good artificial light.

Avoid mowing in bad weather conditions especially when there is a risk of lightning.

Avoid operating the machine in wet grass, where feasible.

Walk, never run.

Never operate the appliance with defective guards or shields, or without safety devices, for example deflectors and/or grass catchers in place.

Always wear ear protection.

Working on banks can be dangerous.

–Do not mow on excessively steep slopes.

–Always be sure of your footing on slopes or wet grass.

–Mow across the face of slopes – never up and down.

–Exercise extreme caution when changing direction on slopes.

Use extreme caution when stepping back or pulling the machine towards you.

Never mow by pulling the mower towards you.

English | 3

Stop the blades if the machine has to be tilted for transportation when crossing surfaces other than grass and when transporting the machine to and from the area to be mowed.

Do not tilt the machine when starting or switching on the motor, except if the machine has to be tilted for starting in long grass. In this case, do not tilt it more than absolutely necessary and tilt only the part which is away from the operator. Always ensure that both hands are in the operating position before returning the machine to the ground.

Switch on the motor according to the instructions with feet well away from rotating parts.

Do not put hands or feet near or under rotating parts.

Always stand clear of the discharge zone when operating the machine.

Never pick up or carry the machine while the motor is running.

Do not modify this product. Unauthorized modifications may impair the safety of your product and may result in increased noise and vibration.

Regularly inspect the supply cable and any extension cables. Do not connect damaged cables to the supply or touch a damaged cable before it is disconnected from the supply. A damaged cable can lead to contact with live parts. Beware electric shock hazard.

	Bosch Power Tools				F 016 L81 421 | (25.1.16)

OBJ_BUCH-2011-005.book Page 4 Monday, January 25, 2016 2:46 PM

4 | English

Leaf Collect

The leaf collect blade has been designed to allow you to pick up autumn leaves from your lawn. In order for this functionality to work within optimal parameters, please note the following:

–only collect leaves with the machine set at 70 mm cutting hight

–collect leaves from your lawn only

–before collecting leaves inspect the area where the machine is to be used and keep people, pets, glass structures and cars away from use

Remove the plug from the socket:

–Whenever you leave the machine.

–Before clearing a blockage,

–Before checking, cleaning or working on the machine,

–After striking a foreign object. Inspect the machine for damage and make repairs as necessary,

–If the machine starts to vibrate abnormally (check immediately).

Power supply

The voltage indicated on the rating plate must correspond to the voltage of the power source.

We recommend that this equipment is only connected into a socket which is protected by a circuitbreaker that would be actuated by a 30 mA residual current.

Only use or replace power supply cables for this unit which correspond to the types indicated by the manufacturer. See the operating instructions for the order no. and types.

Never touch the mains plug with wet hands.

Do not run over, crush or pull the power supply cable or extension lead, otherwise it may be damaged. Protect the cable from heat, oil and sharp edges.

The extension lead must have a cross section in accordance with the operating instructions and be protected against splashed water. The connection must not be in water.

Always wear gardening gloves when handling or working near the sharp blades.

Electrical Safety

Warning! Switch off, remove plug from mains before adjusting, cleaning or if cable is cut, damaged or entangled.

The blades continue to rotate for a few seconds after the machine is switched off.

Caution – do not touch the rotating blade.

Your machine is double insulated for safety and requires no earth connection. The operating voltage is 230 V AC, 50 Hz (for non-EU countries 220 V, 240 V as applicable). Only use approved extension cables. Contact your Bosch Service Centre for details.

Extension cords/leads should only be used if they comply with H05VV-F, H05RN-F types or IEC type design (60227 IEC 53, 60245 IEC 57).

	F 016 L81 421 | (25.1.16)				Bosch Power Tools

OBJ_BUCH-2011-005.book Page 5 Monday, January 25, 2016 2:46 PM

If you want to use an extension cable when operating your product, only the following cable dimensions should be used:

–1.0 mm2: max. length 40 m

–1.5 mm2: max. length 60 m

–2.5 mm2: max. length 100 m

Note: If an extension cable is used it must be earthed and connected through the plug to the earth cable of your supply network in accordance with prescribed safety regulations.

If in doubt contact a qualified electrician or the nearest Bosch Service Centre.

WARNING! Inadequate extension cables can be dangerous. Extension cable, plug and socket must be of watertight construction and intended for outdoor use.

Cable connections should be kept dry and off the ground.

It is recommended for increased electrical safety to use a Residual Current Device (RCD) with a tripping current of not more than 30 mA. Always check your RCD every time you use it.

For products not sold in GB: WARNING: For your safety, it is required that the plug attached to the machine is connected with the extension cord. The coupling of the extension cord must be protected against splash water, be made of rubber or coated with rubber. The extension cord must be used with a cable strain relief.

The connection lead must be inspected for signs of damage at regular intervals and may only be used if in perfect condition.

English | 5

If the supply cord is damaged, it must be replaced by a Bosch Service Centre.

Products sold in GB only: Your product is fitted with a BS 1363/A approved electric plug with internal fuse (ASTA approved to BS 1362).

If the plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place by an authorised customer service agent. The replacement plug should have the same fuse rating as the original plug. The severed plug must be disposed of to avoid a possible shock hazard and should never be inserted into a mains socket elsewhere.

Products sold in AUS and NZ only: Use a residual current device (RCD) with a rated residual current of 30 mA or less.

Maintenance

Always wear gardening gloves when handling or working near the sharp blades.

Keep all nuts, bolts and screws tight to be sure that the machine is in safe working condition.

Check the grass catcher frequently for wear or deterioration.

Examine the machine and replace worn or damaged parts for safety.

Ensure replacement cutting means of the right type are used.

Ensure replacement parts fitted are Bosch approved.

Before storage ensure machine is clean and free from debries, if necessary clean with a soft, dry brush.

	Bosch Power Tools				F 016 L81 421 | (25.1.16)