Apple Mac Pro ATI Radeon Graphics Card Cable Owner's Manual

 Mac Pro
ATI Radeon Graphics Card Cable
Replacement Instructions
First Steps
1 Shut down computer.
2 Wait 10 minutes.
Warning: Parts inside computer can be very hot. Allow computer to cool down before continuing.
3 Unplug all external
cables except power cord.
4 Touch metal PCI cover
on back of computer.
5 Unplug power cord.
Note: Follow these instructions carefully. Failure to do so could damage your equipment and
void its warranty.
Opening the Computer
1 Hold side access
panel and lift latch on back of computer.
Warning: Edges of access panel and enclosure can be sharp. Be careful when handling.
2 Remove access panel
and place it on at surface covered by soft, clean cloth.
© 2009, 2010 Apple Inc. All rights reserved.
073-1250 Rev. B 1
Removing and Installing the Cable
1 Disconnect card’s
cable(s) from backplane board.
2 Disconnect card’s
cable(s) from card.
3 Connect replacement
cable(s) to card and backplane board.
Closing the Computer
1 Replace access panel.
Note: Make sure
latch is up before you replace panel. If latch is down, panel will not seat correctly.
2 Push latch down
to close and secure access panel.
Warning: Never turn on computer unless all its internal and external parts are in place and it is closed. Operating computer when open or missing parts can cause damage or injury.
© 2009, 2010 Apple Inc. All rights reserved.
073-1250 Rev. B 2
Loading...