MITSUBISHI
FRONT WHEEL DRIVE
MANUAL TRANSMISSION (E-W)
WORKSHOP MANUAL
This Workshop Manual contains procedures for removal, disassembly, inspection, adjustment, reassembly and installation, etc. for service mechanics.
All information, illustrations and product descriptions contained in this manual are current as at the time of publication. We, however, reserve the right to make changes at any time without prior notice or obligation.
FILING INSTRUCTION
Please keep these manual pages in the binder No. BN940001.
File these pages according to the signs “Added”, “Revised” and “Deleted” on the “List of effective pages” which are interpreted below.
Added:
File the pages with this sign additionally in your manual.
Revised, Deleted:
Replace the existing pages with the corresponding pages with this sign.
Missing sheets will be supplied upon request.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Clutch |
. 21A |
F5MR1, F5MR2, F5MR3 |
|
Clutch |
|
. 21B |
|
F5M41, F5M42, W5M42 |
|
Manual Transmission . . . . . . . . . . . . . . . . . . . . 22A
F5MR1, F5MR2, F5MR3
Manual Transmission . . . . . . . . . . . . . . . . . . . . 22B
F5M41, F5M42, W5M42
. . . . . . . . . . . . . . . . . . .Manual Transmission |
. 22C |
F5M51 |
|
E Mitsubishi Motors Corporation Jun. 2000 |
Pub. No. PWEE9508-G |
EXPLANATION OF MANUAL CONTENTS
Maintenance and Servicing Procedures
(1)A diagram of the component parts is provided near the front of each section in order to give the reader a better understanding of the installed condition of component parts.
(2)The numbers provided with the diagram indicate the sequence for maintenance and servicing procedures.
: Indicates a non-reusable part.
The tightening torque is provided where applicable.
DRemoval steps:
The part designation number corresponds to the number in the illustration to indicate removal steps.
DDisassembly steps:
The part designation number corresponds to the number in the illustration to indicate disassembly steps.
DInstallation steps:
Specified in case installation is impossible in reverse order of removal steps. Omitted if installation is possible in reverse order of removal steps.
DReassembly steps:
Specified in case reassembly is impossible in reverse order of disassembly steps. Omitted if reassembly is possible in reverse order of disassembly steps.
Classification of Major Maintenance/Service Points
When there are major points relative to maintenance and servicing procedures (such as essential maintenance and service points, maintenance and service standard values, information regarding the use of special tools, etc.), these are arranged together as major maintenance and service points and explained in detail.
AA" : Indicates that there are essential points for removal or disassembly. "AA : Indicates that there are essential points for installation or reassembly.
Symbols for Lubrication, Sealants and Adhesives
Information concerning the locations for lubrication and for application of sealants and adhesives is provided, by using symbols, in the diagram of component parts, or on the page following the component parts page, and explained.
:Grease (multipurpose grease unless there is a brand or type specified)
: Sealant or adhesive
: Brake fluid, automatic transmission fluid
: Gear oil