Zanussi ZK25/10R USER MANUAL

0 (0)

m Warnings for your safety

Warnings for your safety. Carefully read these instructions before installing and using the machine.

m This freezer is designed to be operated by adults only. Children should not be allowed to tamper with the controls or play with the product.

m Any electrical work required to install the appliance should be carried out by a qualified electrician or competent person.

m This appliance is heavy. Care should be taken when moving it.

m Make sure that the cable is not trapped underneath the appliance, nor touches the motor.

m Repairs carried out by inexperienced persons may cause injuries or serious malfunctioning. Refer to the nearest Authorized Dealer.

m Make sure the rear part of the appliance stands against a wall as there are working parts which heat up and should not be of easy access.

m Make sure that there is a continous and adequate ventilation as a failure to do so may result in damage to the appliance or deterioration of the food.

m The appliance should be left for at least 4 hours after installation before it is turned on ill order to allow the refrigerant to settle.

m This product must be serviced only by an AUTHORIZED DEALER, and only GENUINE SPARE PARTS must be employed.

m Before cleaning or reparing the appliance, make sure it is unplugged.

m It is dangerous to alter the specifications or modify this product in any way.

mThese domestic refrigerators are designed to be used specifically for the storage and conservation of food.

mDO NOT USE SHARP INSTRUMENTS to scrap off frost or ice. Frost may be removed by using a plastic scraper. (See defrosting instructions).

m Frozen food must not be re-frozen once it has been thawed out.

m Manufacturer’s storage recommendations should be strictly complied with.

m Lollies can cause frost burns if consumed right away from the freezer.

m Do not place carbonate or fizzy drinks in the freezer as these may explode.

m When an old freezer is to be discarded make sure to:

m Dismount the doors in order to prevent children from getting trapped inside.

Have the gas from the cooling system withdrawn before making it to scrap iron.

1

Índex

Warnings for your safety

pag. 1

Installation

pag. 3

Changing the opening directions

 

of the doors and Panelling

pag. 4

Regulation and Control

pag. 5

How to use your

 

Refrigerator-Freezer

pag. 6 - 7

Maintenance of your

 

Refrigerator-Freezer

pag. 8 - 9

Something not working

pag. 10 - 11

Normal noises when

 

functioning

pag. 12

Guarantee, Service

 

and Spare Parts

pag. 13

Tecnical Features

pag. 14

2

Zanussi ZK25/10R USER MANUAL

Installation

Positioning

Place the refrigerator away from direct sunlight and heat sources.

Maintain recommended ventilation - see Fig. 1.

Make sure the refrigerator is accurately levelled turning the adjustable feet in order to avoid vibrations and noises.

This is a built in design to be aligned with other furniture

Cleaning the interior

Do not use alcohol or any cleanig product containing alcohol because it can damage the cabinet.

Before using the appliance for the first time wash the interior whith luke warm water and some neutral soap so as to remove the typical smell of a brandnew product arid then dry thoroughly.

Do not use detergents or abrasive powders as these will damage the finish.

Remove security used for transportation.

Electrical connection

mBefore plugging the appliance make sure that the voltage and frequency shown on the «Technical Features» correspond to your home supply.

mIt is essential that the appliance be efficiently earthed.

For this purpose the supply cable plug incorporates a special earth contact. If the sockets of your domestic wiring system are not grounded, have the appliance connected to a separate ground wire in accordance with existing safety regulations.

«THE MANUFACTURER DECLINES TO ACCEPT ANY LIABILITY IF THIS SAFETY RULE IS NOT OBSERVED».

mShould a change of the supply cord be necessary, remove the lid of the terminal board acting on «E» and «F» as shown figure 3 in order to gain access to the terminals. Fig. 3.

Starting – up

Plug the appliance into the mains.

Make sure the inner light «H» turns on when opening the door.

Turn to intermediate position the knobs of the «temperature regulators» «f» for refrigerating compartment and «e» for freezing compartment.

Fig. 1

Fig. 2

Fig. 3

3

Changing the opening direction of doors and Panelling

If you wish to change the opening side of the doors proceed as follows:

1... Remove the handles of the doors, (some models only).

2... Take off the plinth pressed onto cabinet.

3... Remove the lower hinge taking care for the lower door not to fall off.

4... Lift the lower door off the central hinge.

5... Remove the central hinge taking care for the upper door not to fall off and not to lose the plastic washer.

6... Take the upper door off the upper hinge. Be carefull not to lose the plastic washer.

7... Unscrew the plastic plugs located on the opposite side of the central hinge and introduce them in the holes occupied before by the hinge.

8... Unscrew the axle of the upper hing and screw it into the hinge on the opposite side. Make sure to fit in the metal washer for blocking.

9... Place upper door.

For the remaining parts proceed the other way round.

Once finished make sure that all joints close perfectly well all around the door and chek that the internal light turns of when the fridge door closes.

4

Regulation and Control

Freezer: Fig.5

Red light: (a)

When lighted indicates abnormal temperature conditions in the freezer, but for the exceptions appering on «Freezing of food» and «Something not working».

Orange light (b)

Indicates that the freezer is on freezing mode (S).

Fast-freezing knob: (c)

Turn the knob to switch on or off the fast-freezing.

Green light: (d)

Indicates connection to mains when lighted

Temperature Regulator for Freezer: (e)

Allows to adjust the temperature inside the freezer according to use and external conditions.

• Lowest setting, minimum cold:

1

Highest setting, maximum cold:

6

Off

l

Fridge:Fig. 5

Temperature Regulator for Refrigerator: (f)

Allows to adjust the temperature inside the refrigerator according to use and external conditions.

• Lowest setting, minimum cold:

1

Highest setting, maximum cold:

6

Off

l

Inside light: (H) Fig. 4

This comes on when you open the refrigerator door and goes off when you close it.

If you need get the bulb (see «IF SOMETHING FAILS TO OPERATE» remove the protective cover «X», pulling its clip horizontally.

Fig. 4

Fig. 5

5

Loading...
+ 9 hidden pages