Whirlpool HOB 602 S, HOB 601 S, HOB 611 B, HOB 612 AL N, HOB 601 B User Manual

6gb53191.fm Page 11 Wednesday, December 10, 2003 10:24 AM

INSTRUCTIONS FOR USE

BEFORE USING THE GLASS-CERAMIC HOB INSTALLATION

ELECTRICAL CONNECTION ENERGY SAVING TIPS PROTECTING THE ENVIROMENT

PRECAUTIONS AND GENERAL RECOMMENDATIONS

COOKTOP ACCESSORIES

CARE AND MAINTENANCE OF THE GLASS-CERAMIC COOKTOP

TROUBLESHOOTING GUIDE AFTER SALES SERVICE

11

6gb53191.fm Page 12 Wednesday, December 10, 2003 10:24 AM

BEFORE USING THE GLASS-CERAMIC HOB

•To make the most of your new appliance, please read the user instructions carefully and keep them to hand for future consultation.

INSTALLATION

Cooktop

•The cooktop must be set into a worktop between 20 mm and 50 mm deep.

•There must be nothing between the cooktop and the oven (cross rails, brackets, etc.).

•The distance between the lower face of the glass ceramic hob and the cupboard or separating panel must be at least 20 mm.

•If the cooktop is to be installed next to a column unit, leave a distance of at least 100 mm from the edge of the cooktop.

•Make an opening in the worktop of the dimensions shown in the Product Description Sheet supplied separately.

•Apply the supplied gasket to the cooktop (unless it has already been fitted), after having cleaned its surface.

Important

In order to prevent the electronic circuits from overheating, and therefore from being damaged, we recommend the following:

•Do not install the cooktop near the dishwasher or washing machine, so that the electronic circuits are not in contact with steam or moisture, which could damage them.

If there is an oven under the hob (manufactured by us), make sure that it is equipped with a cooling system.

If the temperature of the electronic circuits exceeds the maximum permitted temperature, the cooktop will switch off automatically; in this case, wait for a few minutes until the internal temperature of the electronic circuits reaches a tolerable level, at which point it will be possible to switch the cooktop on again.

• Switch off the hob after use.

12

6gb53191.fm Page 13 Wednesday, December 10, 2003 10:24 AM

INSTALLATION

Assembly

A)If the worktop is made of wood, use the supplied spring clips and screws.

•Position the 4 clips (A) as shown and at the specified distance.

•Secure the clips using the 4 screws (B).

•Fit the cooktop in the prepared worktop (see figure).

B)If the worktop is made of marble or other materials (plastic compounds, ceramics, stone, etc.), the cooktop must be fitted by means of brackets code 4819 404 78697 (to be requested from the After-Sales Service).

•Position the cooktop into the prepared worktop.

•Position the 3 brackets (C) as shown in the figure, in accordance with the thickness of the worktop.

•Secure the three screws (E) in the holes (D).

13