Whirlpool ARC 0060/S, TTB 14/S, ARL 620/S, ARC 0070/AL, ARC 0060/S-LH User Manual

60202001GB.fm Page 12 Monday, July 11, 2005 5:37 PM

ISTRUCTIONS FOR USE

PRODUCT DESCRIPTION

REPLACING BULBS

BEFORE USING THE APPLIANCE SAFEGUARDING THE ENVIRONMENT

PRECAUTIONS AND GENERAL

RECOMMENDATIONS

HOW TO OPERATE THE REFRIGERATOR COMPARTMENT

HOW TO DEFROST THE REFRIGERATOR CARE AND MAINTENANCE

TROUBLESHOOTING GUIDE/AFTER-SALES SERVICE

AFTER-SALES SERVICE

INSTALLATION

ELECTRICAL CONNECTION

12

60202001GB.fm Page 13 Monday, July 11, 2005 5:37 PM

PRODUCT DESCRIPTION

ALow temperature compartment

BLow temperature compartment door

CWater collection tray

DAdjustable shelves and grids

ECrisper drawer

FTemperature adjustment thermostat

GRating plate (at the side of the cripser drawer)

HAdjustable foot

IDoor seal spacers for transport purposes (remove and discard)

REPLACING BULBS

Replacing bulbs

1.Press as shown in the figure.

2.Pull towards the inside of the appliance.

3.Replace the bulb (max 15W).

13

60202001GB.fm Page 14 Monday, July 11, 2005 5:37 PM

BEFORE USING THE APPLIANCE

•Your new appliance is designed exclusively for domestic use

To get the most out of your new appliance, read the user handbook thoroughly. The handbook contains a description of the appliance and useful tips for storing food.

Keep this handbook for future consultation.

1.After unpacking, make sure that the appliance is undamaged and that the door closes properly. Any damage must be reported to your dealer within 24 hours after delivery of the appliance.

2.Wait at least two hours before switching the appliance on in order to ensure the refrigerant circuit is fully efficient.

3.Installation of the appliance and electrical connections must be carried out by a qualified electrician, in accordance with the manufacturer's instructions and local safety regulations

4.Clean the inside of the appliance before using it.

SAFEGUARDING THE ENVIRONMENT

1. Packing

The packaging material is entirely recyclable, and marked with the recycling symbol. Follow local regulations for scrapping. Keep the packaging materials (plastic bags, polystyrene parts, etc.) out of reach of children, as they are potentially dangerous.

2. Scrapping

The appliance is manufactured using recyclable material.

This appliance is marked according to the European directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE). By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product.

The symbol on the product, or on the documents accompanying the product, indicates that this appliance may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. Before scrapping, make the appliance unusable by cutting off the power cable and removing the doors and shelves so that children cannot easily climb inside the appliance.

Disposal must be carried out in accordance with local environmental regulations for waste disposal. Deliver the appliance immediately to an authorized dump; do not leave it unattended even for a few days, since it is potentially dangerous for children. For more detailed information about treatment, recovery and recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product.

Information:

This appliance does not contain CFCs (replaced with R134a) or HFCs (replaced with R600a). Appliances with Isobutane (R600a):

isobutane is a naturally occurring, low environmental impact gas. Caution is required, however, because isobutane is flammable. Therefore, it is essential to ensure that refrigerant pipelines are not damaged.

Declaration of conformity

•This appliance is designed to store food and is manufactured in conformity with European Directive 90/128/EEC, 02/72/EEC and Regulation (EC) No. 1935/2004

•This appliance is designed, manufactured, and

retailed in compliance with:

-the safety objectives of the Low Voltage Directive 73/23/EEC;

-the protection requirements of the “EMC” Directive 89/336/EEC

amended by Directive 93/68/EEC.

•The electrical safety of the appliance can only be guaranteed if the product is connected to an approved earth connection.

14