Teac FD235HF, 3FD0050A User Manual

3 1/2" 1.44 MB Floppy Disk Drive

3 1/2'' diskette
insertion window

Activity indicator

TEAC FD-235 Series

Installation Guide

Eject Button

Your FD-235 package includes:

* FD-235 3 1/2" floppy disk drive
* Installation Guide

Introduction

Thank you for purchasing the TEAC FD-235 Series 1.44 MB floppy disk
drive. This product is intended for use in IBM PC/AT compatible computers.

This quality drive will provide trouble-free operation for your computer
system if properly installed. PLEASE READ THE ENTIRE INSTALLATION
GUIDE THOROUGHLY BEFORE YOU BEGIN THE INSTALLATION.
Use a standard floppy controller card or the floppy connector (34 Pin) on
the motherboard.

Preparing your Personal computer for FD-235 Floppy Drive Installation

CAUTION: TURN OFF YOUR COMPUTER AND UNPLUG IT FROM
THE AC POWER SOURCE BEFORE INSTALLING THE FD-235.
FAILURE TO DO SO MAY RESULT IN ELECTRIC SHOCK.

1. Unplug your computer from the power source.

2. Remove cover from your computer. Refer to your computer system
manual for this procedure.

3. If you are replacing a current floppy, note the cables that are connected
to your floppy disk drive, as these same cables will be required to install
your FD-235. The floppy interface cable is the flat “ribbon” type, and
the power connector consists of the 4 or 2 separate wires attached to a
single connector. See Figure A.

Your system may also have a single ground wire attached to the floppy
disk drive. Carefully disconnect all cables from your floppy disk drive.
Remove original floppy disk drive.

4. Install the FD-235 Series 1.44 MB into an available drive bay.

Rear View of FD-235

Power connector

Pin #1 indicator stripe
(red or blue)

Flat “ribbon” cable

Pin #1

Traditional power connector
from PC power supply

FIGURE A

2