»
CD-GT1@#
Portable CD Guitar Trainer
This appliance has a serial number located on the rear panel. Please record the model number and serial number and retain them for your records.
Model number |
_____________ |
Serial number |
_____________ |
OWNER’S MANUAL
D00851000A
Important Safety Precautions
YFOR U.S.A.
CAUTION: TO REDUCE THE RISK OF ELECTRIC |
TO THE USER |
|
This equipment has been tested and found to |
||
SHOCK, DO NOT REMOVE COVER (OR BACK). |
||
comply with the limits for a Class B digital de- |
||
NO USER-SERVICABLE PARTS INSIDE. REFER |
||
vice, pursuant to Part 15 of the FCC Rules.These |
||
SERVICING TO QUALIFIED SERVICE PERSON- |
limits are designed to provide reasonable pro- |
|
NEL. |
tection against harmful interference when the |
|
equipment is operated in a commercial environ- |
||
|
Eradiate radio frequency energy and, if not installed and used in accordance with the instruc-ment. This equipment generates, uses, and can
The lightning flash with arrowhead symbol, |
tion manual, may cause harmful interference to |
|
radio communications.. However, there is no |
||
within an equilateral trinagle, is intended to |
||
guarantee that interference will not occur in a |
||
alert the user to the presence of uninsulated |
particular installation. If this equipment does |
|
“dangerous voltage” within the product’s en- |
cause harmful interference to radio or television |
|
closure that may be of sufficient magnitude to |
reception, which can be determined by turning |
|
the equipment off and on, the user is encour- |
||
constitute a risk of electric shock to persons. |
||
aged to try to correct the interference by one or |
||
|
more of the following countermeasures. |
Ra) Reorient or relocate the receiving antenna b) Increase the separation between the
WARNING: TO PREVENT FIRE OR SHOCK |
equipment and receiver. |
|
c) Connect the equipment into an outlet on a |
||
HAZARD, DO NOT EXPOSE THIS APPLIANCE TO |
||
circuit other from that to which the receiver |
||
RAIN OR MOISTURE. |
is connected. |
|
|
d) Consult the dealer or an experienced radio/ |
|
|
TV technician for help. |
|
|
CAUTION |
|
|
Changes or modifications to this equipment not |
|
|
expressly approved by TEAC CORPORATION for |
|
|
compliance could void the user’s authority to |
|
|
operate this equipment. |
2— TASCAM CD-GT1MKII
1 Read these instructions.
2 Keep these instructions.
3Heed all warnings.
4Follow all instructions.
5 Do not use this apparatus near water.
6Clean only with dry cloth.
7 Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
8 Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
9 Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong.The wide blade or the third prong are provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.
10Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.
11Only use attachments/accessories specified by the manufacturer.
12Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.
Important Safety Instructions
13Unplug this apparatus during lightning storms or when unused for long periods of time.
14Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.
•Do not expose this apparatus to drips or splashes.
•Do not place any objects filled with liquids, such as vases, on the apparatus.
•Do not install this apparatus in a confined space such as a book case or similar unit.
•The apparatus draws nominal non-operating power from the AC outlet with its POWER switch in the off position.
TASCAM CD-GT1MKII — 3
Important Safety Instructions
Safety Information
This product has been designed and manufactured according to FDA regulations “title 21, CFR, chapter1, subchapter J, based on the Radiation Control for Health and Safety Act of 1968”, and is classified as a class 1 laser product. There is no hazardous invisible laser radiation during operation because invisible laser radiation emitted inside of this product is completely confined in the protective housings. The label required in this regulation is shown here.
CAUTION
•DO NOT REMOVE THE PROTECTIVE HOUSING USING A SCREWDRIVER.
•USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE.
•IF THIS PRODUCT DEVELOPS TROUBLE, CONTACT YOUR NEAREST QUALIFIED SERVICE PERSONNEL, AND DO NOT USE THE PRODUCT IN ITS DAMAGED STATE.
Optical pickup:Type KSM-900AAA Manufacturer: SONY CORPORATION
Laser output: <1 mW play on the objec-
tive lens
Wavelength: 775—816 nm
4— TASCAM CD-GT1MKII
Table of contents
Handling of compact discs ............................................. |
6 |
About the power supply................................................. |
7 |
Part names and functions............................................... |
9 |
Making connections ..................................................... |
12 |
Using the menu system ................................................ |
14 |
Using the CD player...................................................... |
16 |
Pitch and tempo changes............................................. |
17 |
Using CD effects........................................................... |
18 |
Using built-in effects.................................................... |
19 |
Effect presets ............................................................... |
21 |
Using the metronome................................................... |
22 |
Using the tuner............................................................. |
23 |
Changing your preferences for the CD-GT1MKII.......... |
24 |
Facts and figures (specifications) ................................. |
25 |
About this Manual:
When we refer to a key or connector or control on the CD-GT1MKII, the typeface looks like this: PLAY.
When we refer to items shown on the display, the typeface looks like this: MENU.
TASCAM CD-GT1MKII — 5
Handling of compact discs
Observe the following:
Always place compact discs in the tray with their label facing upward (compact discs can only be played on one side).
To remove a disc from its storage case, press down on the center of the case, and lift the disc out, holding it carefully by the edges.
Finger marks and dust should be carefully wiped o the disc’s recorded surface with a soft cloth. Unlike conventional records, the compact disc has no grooves to collect dust and microscopic debris, so gently wiping with a soft cloth should remove most particles.
Wipe in a straight motion from the inside to the outside of the
disc. Small dust particles and light stains will have absolutely no effect on reproduction quality.
Never use such chemicals as record sprays, antistatic sprays or fluid, benzine or thinner to clean compact discs. Such chemicals will do irreparable damage to the disc’s plastic surface.
Discs should be returned to their cases after use to avoid serious scratches that could cause the laser pickup to “skip”.
Don’t expose discs to direct sunlight or high humidity and temperature for extended periods. Long exposure to high temperature can warp the disc.
Only use circular compact discs. Avoid using noncircular promotional, etc. discs.
Tokeepthelaserpickupsclean,do not touch them. For the same reason,donotleavethedisctrayopen unnecessarily.
The CD-GT1MKII cannot play unfinalized CD-R/RW discs. In addition, some finalized CD-R/ RW discs may be unplayable on the CD-GT1MKII.
6— TASCAM CD-GT1MKII
Operation using batteries
Take o the cover of the battery compartment at the back of the CDGT1MKII and insert four AA (SUM- 3) batteries (not supplied) following the + and – markings inside the battery compartment.
CAUTION
We strongly recommend the use of rechargeable Ni-MH batteries (alkaline batteries may also be used). Your CD-BT1MKII may not operate properly with batteries of other types.
WARNING
Misuse of batteries may cause leaks and explosions. Please carefully read and follow the instructions below:
Notes on batteries
When you are using the CDGT1MKII with batteries, unplug the AC adapter.
About the power supply
Make sure the batteries are inserted in the correct direction, according to the markings inside the battery compartment.
Always use batteries of the same type, and replace all batteries together.
Do not attempt to recharge batteries that are not rechargeable.
If you are not going to use the CD-GT1MKII for longer than one month, remove the batteries.
Do not throw batteries into water or fire. Do not disassemble batteries.
If a battery leaks in the compartment, wipe the liquid away completely with a disposable cloth. Make certain no residue remains before inserting new batteries.
Remaining battery charge level display
When the CD-GT1MKII is running on batteries, a rough indication of the remainingbatterychargeisdisplayedas
as the battery |
follows: |
3 parts are lit
There is plenty of battery charge left.
2 parts are lit
Battery charge is approximately half.
1 part is lit |
|
Not much |
is left. |
3 parts blink
Battery charge is nearly gone. Replace with fully charged batteries.
Auto power-save
While using battery power, the CD player and CD functions of the CDGT1MKII shut down automatically if any of the following conditions lasts more than 5 minutes: (the CD part of the display shows CD OFF).
Being in Stop mode
CD drive cover is open
No CD is loaded
To turn the CD player on, press the
PLAY key.
TASCAM CD-GT1MKII — 7
About the power supply (Continued)
CAUTION
Because the CD-GT1MKII is equipped with special functions such as key change and effects, the battery life is shorter compared with standard portable CD players.
The length of battery life in CD-GT1MKII is affected by both the environment and the number of functions in use. Factors that affect battery life include temperature, humidity, the number of special functions used, and so on.
Under some circumstances, there may not be enough power in the batteries to power the CD-GT1MKII, despite the battery power indication on the display. If this happens, change the batteries, or use an AC adapter.
Always dispose of used batteries as recommended by your local authorities.
Length of battery life
Ni-MH batteries: Approx. 4.5 hours
Alkaline batteries: Approx. 1.5 hours
Operation using an AC adapter
Connect a TASCAM PS-PS5 AC adapter (sold separately) to the DC IN jack at the back of the CD-GT1MKII.
Insert the plug of the AC adapter into a domestic AC power outlet. Make sure that the voltage of the outlet corresponds to that marked on the adapter.
PS-PS5 |
Wall outlet |
DC plug |
|
WARNING
Use only a PS-PS5 AC adapter with your CDGT1MKII. Using another type of AC adapter may damage your CD-GT1MKII.
CAUTION
Remove the batteries before operating the CD-GT1MKII with an AC adapter. There is a possibility of slight noise if you use the unit with an AC adapter while the batteries are
inside. If you plug in an AC adapter but have forgotten to take out the batteries, turn the power off using the POWER switch, and take out the batteries. Likewise, turn the power off before you change between using the batteries and using the AC adapter.
Unplug the AC adapter from the domestic AC power outlet when you are not using the CD-GT1MKII.
Settings may not be properly saved if you turn the power off immediately after inserting a CD or changing settings. If settings are not saved properly, the system may not start with the last settings and instead will start using the default values.
Switching the unit on and off
Use the POWER switch to turn the power to the whole unit on and o .
8— TASCAM CD-GT1MKII
Loading...