KEYENCE OP-87601 User Manual

12098E 1042-1 96M12098 Printed in Japan

CAUTION

NOTICE

Recommended tightening torque: 0.7 to 0.9 N·m

Ta b

Mouse storage

4-Elongate hole (Note)

166

13 1376

7.6

3.5 48

9.5

1.6

174

160

180

(Mounting

hole)

(Note) Details on the elongate hole (2/1)

12.8

16.8

96M12098

Keep hands away from the movable part when opening/closing the

CAUTION

Stand to prevent hands or fingers from being caught.

Do not put anything on the Stand other than the mouse.

NOTICE

Doing so may cause damage to the Stand or the mounting portion.

Mouse Stand

OP-87601

Instruction Manual

Read this manual before use. Keep this manual in a safe place after reading it so that it can be used at any time.

Checking the Package Contents

The OP-87601 is supplied with the following items. Check that all are included in the package.

F Stand . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1

F Mounting screws (M3 x L10mm double sems screws x 4) . . . . . . . . . . . . . . . . . . . 1 set

F Instruction Manual (this document)

* We make every effort to ensure products reach our customers without any damage.

However, if you encounter any defective, damaged, or missing parts, please contact your nearest KEYENCE sales office.

Introduction

This is the instruction manual for the Mouse Stand, OP-87601. To use the Stand, fix it to a metal plate with a thickness of 1.6 mm or more.

 Symbols

This manual uses the following symbols so that you can recognize important messages at a glance. Please read it in its entirety.

It indicates a hazardous situation which, if not avoided, could result in minor or moderate injury.

It indicates a situation which, if not avoided, could result in product damage as well as property damage.

Dimensions

OP-87601

Stand weight: approximately 350 g

Installation

Refer to the diagram below to assemble the Stand.

1. Make four holes of ø3.5 on the metal plate as shown below.

2. Put the screw into the hole and fix it with the nut on the back side.

The recommended tightening torque is 0.7 to 0.9 N·m.