After each drying cycle
The fluff filters and condensation containers must always be cleaned or emptied after each drying cycle.
1 |
2 |
Cleaning the fluff filter
During drying, fluff and hair from the laundry is trapped by the fluff filter. A blocked or partially cleaned fluff filter reduces the flow of air. This means that the dryer does not reach its maximum performance. The fluff filter must therefore be cleaned after each drying cycle. Rinse the filter regularly under running water and carefully dry it. See also the notes on “Care and cleaning” in the instruction manual.
Emptying the condensation container
After each drying cycle, empty the condensation container because, under certain circumstances, the next drying programme will be cancelled as a result of the condensation container being full. You must also regularly clean the filter in the condensation container under running water or in the dishwasher. See also the information on “Care and cleaning” in the instruction manual.
Further important information can be found in your instructions for use and installation manual or care instructions. Pay particular attention to the chapter “What to do if...” and “After-sales service”.
9110/ 9000689281 *689281*
Dryer
The main points to begin with |
en |
This leaflet provides you with a brief overview of the important information and improvements that you need to know about your new dryer before using it for the first time.
Residual moisture from the laundry
–Warm laundry feels damper than it actually is.
–Thanks to the heat pump technology, your laundry is always dried at gentle temperatures in any programme.
However, you must observe the maximum load and type of laundry in order to achieve optimum results.
–You must also observe the information in the chapter “Notes on laundry” in the instructions for use.
The laundry feels slightly damper
If you think that the laundry is slightly too damp, use the fine adjustment for the drying result. You can find instructions on how to set required degrees of dryness in the section “Fine adjustment of the drying result” or “Adjust drying level” in your instructions for use.
The laundry is not evenly dry…
If you are drying thin and thick or multi-layered fabrics together, these will dry differently. To ensure that the laundry dries evenly, you must sort it according to the type of fabric and the structure. If required, select a time programme to finish the drying.
The laundry is still noticeably damp…
Take note of whether the drying cycle was interrupted after a service display (for example, Empty the container or Please empty the condensation container, or Clean the fluff filter or Please clean the lint filter), which means that the drying cycle is not yet complete. Correct the fault and continue the programme. See the chapter “What to do if...” in the instructions for use.
Loading...