|
|
|
|
|
EN |
DAILY REFERENCE |
|
|
|
|
|
|
|
|
|
|
|
GUIDE |
|
|
|
|
|
|
|
|
|
|
|
THANK YOU FOR BUYING A ARISTON PRODUCT. |
|
|
|
You can download the Safety Instructions and the Use |
|
|
|
|
|||
|
|
|
|||
In order to receive a more complete assistance, please |
|
|
|
and Care Guide, by visiting our website |
|
|
|
|
|||
register your appliance on: www.aristonchannel.com |
|
|
|
www.aristonchannel.com and following the |
|
|
|
|
|
Instructions on the back of this booklet. |
Before using the appliance carefully read Health and Safety guide.
PRODUCT DESCRIPTION
APPLIANCE
1 |
2 |
|
4 |
3 |
|
|
||
7 |
5 |
|
8 |
||
6 |
||
10 |
||
9 |
||
12 |
11 |
|
Service: |
|
|
0000 000 00000 |
|
1.Upper rack
2.Cutlery rack
3.Foldable flaps
4.Upper rack height adjuster
5.Upper spray arm
6.Space Zone
7.Lower rack
8.Lower spray arm
9.Filter Assembly
10.Salt reservoir
11.Detergent and Rinse Aid dispensers
12.Rating plate
13.Control panel
13
CONTROL PANEL
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
1 |
|
2 |
3 |
|
4 |
5 6 |
7 |
8 |
|
|
|
9 10 1112 |
13 |
|
14 |
|
15 |
|
16 |
|
||
1. |
On-Off/Reset button with indicator light |
|
|
|
|
9. |
|
Tablet (Tab) indicator light |
|
|
|
|
|||||||||||
2. |
Program selection button with indicator light |
|
|
|
|
10. |
Closed water tap indicator light |
|
|
|
|
||||||||||||
3. |
Zone Wash 3D button with indicator light |
|
|
|
|
11. |
Rinse Aid refill indicator light |
|
|
|
|
||||||||||||
4. |
Turbo button with indicator light / Key lock |
|
|
|
|
12. |
Salt refill indicator light |
|
|
|
|
|
|
||||||||||
5. |
Eco program indicator light |
|
|
|
|
|
|
|
13. |
Extra Dry button with indicator light |
|
|
|||||||||||
6. |
Key lock indicator light |
|
|
|
|
|
|
|
14. |
Tablet (Tab) button with indicator light |
|
|
|||||||||||
7. |
Display |
|
|
|
|
|
|
|
15. |
Delay button with indicator light |
|
|
|||||||||||
8. |
Program number and remaining time indicator |
|
|
|
16. |
Start/Pause button with indicator light / Drain out |
|||||||||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
1
FIRST TIME USE
SALT, RINSE AID AND DETERGENT
ADVICE REGARDING THE FIRST TIME USE
After installation, remove the stoppers from the racks and the retaining elastic elements from the upper rack.
FILLING THE SALT RESERVOIR
The use of salt prevents the formation of LIMESCALE on the dishes and on the machine’s functional components.
•It is important that the salt reservoir be never empty.
•It is important to set the water hardness.
The salt reservoir is located in the lower part of the dishwasher (see PROGRAMS DESCRIPTION) and should be filled when the SALT REFILL indicator lightin the control panel is lit.
1.Remove the lower rack and unscrew the
reservoir cap (anticlockwise).
2.Position the funnel (see figure) and fill the salt
reservoir right up to its edge (approximately 1 kg);
it is not unusual for a little water to leak out.
3.Remove the funnel and wipe any salt residue away from the opening.
Make sure the cap is screwed on tightly, so that no detergent can get into the container during the wash program (this could damage the water softener beyond repair).
Whenever you need to add salt, we recommend carrying out the procedure before the washing cycle is started.
SETTING THE WATER HARDNESS
To allow the water softener to work in a perfect way, it is essential that the water hardness setting is based on the actual water hardness in your house. This information can be obtained from your local water supplier.
The factory setting is for average (3) water hardness.
•Switch on the appliance by pressing the ON/OFF button.
•Switch off the appliance by pressing the ON/OFF button.
•Hold down button START/PAUSE for 5 seconds, until you hear a beep.
•Switch on the appliance by pressing the ON/OFF button.
•The current selection level number and the salt indicator light both flash.
•Press button P to select the desired hardness level (see WATER HARDNESS TABLE).
|
|
Water Hardness Table |
|
||
|
|
|
|
|
|
|
Level |
|
°dH |
°fH |
|
|
|
German degrees |
French degrees |
||
|
|
|
|||
|
|
|
|
|
|
1 |
Soft |
|
0 |
- 6 |
0 - 10 |
|
|
|
|
|
|
2 |
Medium |
|
7 - 11 |
11 - 20 |
|
|
|
|
|
|
|
3 |
Average |
|
12 |
- 17 |
21 - 30 |
|
|
|
|
|
|
4 |
Hard |
|
17 |
- 34 |
31 - 60 |
|
|
|
|
|
|
5 |
Very hard |
|
35 |
- 50 |
61 - 90 |
|
|
|
|
|
|
• Switch off the appliance by pressing the ON/OFF button. Setting is complete!
As soon as this procedure is complete, run a program without loading.
Only use salt that has been specifically designed for dishwashers.
After the salt has been poured into the machine, the SALT REFILL indicator light switches off.
If the salt container is not filled, the water softener and the heating element may be damaged as a result .
FILLING THE RINSE AID DISPENSER
Rinse aid makes dish DRYING easier. The rinse aid dispenser A should be filled when the RINSE AID REFILL indicator light in the control panel is lit.
35
25
A |
X |
M |
B |
A |
1.Open the dispenser B by pressing and pulling up the tab on the lid.
2.Carefully introduce the rinse aid as far as the maximum (110 ml) reference notch of the filling space - avoid spilling it. If this happens, clean the spill immediately with a dry cloth.
3.Press the lid down until you hear a click to close it.
NEVER pour the rinse aid directly into the tub.
ADJUSTING THE DOSAGE OF RINSE AID
If you are not completely satisfied with the drying results, you can adjust the quantity of rinse aid used.
•Switch the dishwasher on using the ON/OFF button.
•Switch it off using the ON/OFF button.
•Press button START/PAUSE three times - a beep will be heard.
•Switch it on using the ON/OFF button.
•The current selection level number and rinse aid indicator light flash.
•Press button P to select the level of rinse aid quantity to be supplied.
•Switch it off using the ON/OFF button
Setting is complete!
If the rinse aid level is set to 1 (ECO), no rinse aid will be supplied. The LOW RINSE AID indicator light will not be lit if you run out of rinse aid. A maximum of 4 levels can be set according to the dishwasher model. The factory setting is for a medium level.
•If you see bluish streaks on the dishes, set a low number (2-3).
•If there are drops of water or limescale marks on the dishes, set a high number (4-5).
FILLING THE DETERGENT DISPENSER
|
To open the detergent dispenser |
|
|
use the opening device A. Introduce |
|
|
the detergent into the dry dispenser |
|
B |
B only. Place the amount of |
|
detergent for pre-washing directly |
||
|
||
A |
inside the tub. |
|
|
1.When measuring out the detergent |
|
|
refer to the (see PROGRAMS TABLE) to |
|
|
add the proper quantity. |
|
|
Compartment B comprises a level |
showing the maximum quantity of liquid or powder detergent that can be added to each cycle.
2.Remove detergent residues from the edges of the dispenser and close the cover until it clicks.
3.Close the lid of the detergent dispenser by pulling it up until the closing device is secured in place.
The detergent dispenser automatically opens up at the right time according to the program.
If all-in-one detergents are used, we recommend using the TABLET button, because it adjusts the program so that the best washing and drying results are always achieved.
2
EN
PROGRAMS TABLE
Program
1. Eco
2. Auto Intensive
3. Auto Normal
4. Auto Fast
5. Express 30’
6. Good Night
7. Sanitizing
8. Soak
9. SelfClean
Drying phase
50°
65°
55°
50° -
50° -
50°
65°
--
65° -
|
Detergent |
Duration of |
Water |
Energy |
||
Available options *) |
container |
|||||
wash program |
consumption |
consumption |
||||
|
|
|||||
|
Tub |
B |
(h:min)**) |
(litres/cycle) |
(kWh/cycle) |
|
|
|
|
|
|||
|
|
|
3:15 |
11 |
0.95 |
|
|
- |
|
2:00 - 3:10 |
14 - 17 |
1.50 - 1.85 |
|
|
|
|
1:30 - 2:30 |
14.5 - 16 |
1.15 - 1.30 |
|
|
- |
|
0:40 - 1:20 |
13 - 14.5 |
1.15 - 1.25 |
|
|
- |
|
0:30 |
9 |
0.50 - 0.55 |
|
|
- |
|
3:30 |
15 |
1.15 |
|
|
- |
|
1:40 |
10 |
1.30 |
|
|
- |
- |
0:12 |
4.5 |
0.01 |
|
|
- |
|
0:50 |
8 |
0.80 - 0.85 |
ECO program data is measured under laboratory conditions according to European Standard EN 50242. *) Not all options can be used simultaneously.
**) The duration of the program shown on the display or in the booklet is an estimate calculated on standard conditions. The actual time may vary depending on many factors such as temperature and pressure of the incoming water, room temperature, amount of detergent, quantity and type of load, load balancing, additional selected options and sensor calibration. The sensor calibration can increase program duration up to 20 min.
Standby consumption: Left-on mode consumption: 5 W - Off mode consumption: 0.5 W
PROGRAMS DESCRIPTION
Instructions on wash cycle selection.
ECO
Normally soiled crockery. Standard program, the most efficient in terms of its combined energy and water consumption.
AUTO INTENSIVE
Heavily soiled dishes and pans (not to be used for delicate items).
AUTO NORMAL
Automatic program for normally soiled pans and dishes.
AUTO FAST
Limited quantity of daily soiling (ideal for 4 place settings).
EXPRESS 30’
Program to be used for lightly-soiled dishes with no dried food residues. (Ideal for 2 place settings).
GOOD NIGHT
Suitable for night-time operation of the appliance. Optimum performance ensured.
SANITIZING
Normally or heavily soiled crockery, with additional antibacterial wash.
SOAK
Crockery to be washed later. No detergent to be used with this program.
SELF-CLEAN
Program to be used to perform maintenance of the dishwasher. It cleans the interior of the appliance using hot water.
Notes:
Optimum performance levels when using the “1 Hour” and “Rapid” programs can be achieved by observing the maximum amounts of specified place settings.
To reduce consumption even further, only run the dishwasher when it is full.
3