Bench for ELS-02/ELS-02C Owner’s Manual
Checking the included items
Remove all parts from the package and make sure you have all of the items.
• Bench board |
1 |
|
• Legs |
4 |
|
• |
Foot rest |
1 |
• |
Bolts |
4 |
• Washers |
4 |
|
• Screws |
4 |
|
• Wrench* |
1 |
|
*Wrench is attached on the backside of bench board.
Have a Phillips-head (+) screwdriver of the appropriate size ready.
Bench assembly
1Turn the bench board over and install two legs for the front side.
Tighten the bolts using the included wrench (as shown).
CAUTION
Make sure to put washers between the bolts and the bench board. Make sure to properly tighten all bolts so that there is no gap between the bolts and the washers. If the bolts are not properly tightened, accident or injury may occur.
2Install the foot rest to the legs with the included four screws, using a screwdriver.
Foot rest
3 Install the two legs for the back side.
After completing the assembly, be sure to read the “PRECAUTIONS” section of the Owner’s Manual of ELS-02/ELS-02C.
|
Washer |
R |
Bolt |
L
Logo is written on back
– 1 –
Loading...