Xpres TECMARK User Manual

0 (0)
Xpres TECMARK User Manual

XP2120/1 Tec Mark 3000

XP2125

Digit 100

XP2126 Digit 150 Cling

XP3136

Banner vinyl

Tec Mark® printable media is designed to be printed using Solvent or Eco Solvent Inks. Ensure the printable media is face up in the printer before printing/cutting. Profiles for the Roland Versacamm can be downloaded directly from the Xpres Website: www.xpres.co.uk/tech_support

ŸFor XP2120/1 Tec Mark® 3000 & XP2125 Digit 100 media please use the ‘Tecmark Digit 100' Profile

ŸFor XP2126 Digit 150 Cling media please use the ‘Tecmark Digit 150 Cling’ Profile

ŸFor XP3136 Banner Vinyl media please use the ‘Tecbanner’ Profile

Please note:

ŸWhen printing XP2126 Digit 150 Cling, do not use the Roland Versacamm media clamps

ŸUnroll the material to leave slack on the roll when printing/cutting

XP2120/1 Tec mark 3000 and XP2125 Digit 100 can be used with XP2122/3/4 Application Tape. For instructions please see the below steps:

1. Insert vinyl into the cutter, colour side up and clamp into position.

2.Once satisfied with the vinyl position send the job to the cutter (recommended force: 100-110gf).

3.Once cut weed away the excess material around the design as in diagram 1.

Diagram 1.

XPRES

4.Cut the design off the roll as in diagram 2.

5.Cover your design with application tape as in diagram 3.

6.Using sufficient pressure use the squeegee to flatten and smooth out any bubbles diagram 4.

Diagram 2.

XPRES

XPRES

Diagram 3.

7. Turn over and peel backing off the application tape diagram 5.

Diagram 4.

XPRES

Diagram 5.

8. Your design is now ready for application diagram 6.

9. Ensure your application area is clean and free of dust. Position the

Diagram 6.

design carefully. With sufficient pressure use the squeegee to apply

 

the design and to smooth out bubbles and imperfections. When

XPRES

applied remove the application tape.

 

Tips: Use an alcohol based solution on the application area to remove

any grease. To aid re-positioning of the logo on the application area, spray with water before applying the design.

XPRES

Diagram 7.

XPRES

01332 855 085 www.xpres.co.uk

Revision RJS1.0 27/01/2011

Loading...