Epson R1800 bulk
feed instructions
Make sure all the relevant parts are included
with your system
1. Cartridge/Bottle assembly
2. Tube Support (4 pieces)
3. Air Filters
4. Syringe (for re-filling the bottles)
5. CD (includes ICC colour correction profile, and instructions for setting up the
profile in the printer driver)
Press the ink button on your machine and
when the cartridges move to the remove
position unplug the mains cable at the
rear.
Remove any existing cartridges. Manually move the printhead as far as it
Use a small screwdriver to gently lever
the lid hinge out whilst pulling the lid
towards you.
will go to the left of the machine (this
will move easily if you have unplugged
the mains)
Complete the lid removal.
Feed the Easy Flow cartridges
underneath the printer housing …...
After feeding the cartridges all the way
through the housing, lay them out of the
way on top of the printer
Slide the printhead back to the cartridge
removal position…...
….remove the elastic band and place the
cartridges into their relevant colour slots.
DO NOT PUSH THEM DOWN YET
Fix the angled tube support as shown.
The sticky pad is face down with the
clear tube furthest away from the angle.
Assemble the tube support as shown and
remove the three pieces of backing tape
from the double sided tape.
This support needs to be 250mm away
from the yellow cartridge. The support
easily slides along the tube for
positioning.
Position the tube support as shown
between the two marks made previously
(the 90 and 200mm).
Use a marker to identify the position of
the finished tube support. From the edge
of the opening to the first mark is 90mm
and 200mm to the second mark.
Take off the backing tape and position
the small tube clamp on the right of the
printer housing and slide the tube into the
clip.
Slowly lay the bottles down as shown
and stand them back up after 2-3
seconds. This self levels the ink in the
small chambers.
Do Not Raise Bottles Higher Than
The Printer. Remove the rubber
stoppers……..
...and fit the air filters.
Loading...