6
D88 Bulk Feed
Instructions
1
2
4
3
5
ITINERY
1. Bottles and cartridge assembly (pre-filled and including 2 small
clamps for fitting to printer housing).
2. 10ml Syringe
3. Small needle (only required for re-priming, see page 7)
4. Large extension
5. 4 x air filters
6. Subli-Print CD (including colour correction profile and instructions)
Turn on the printer and press the ‘ink’
button. When the printhead has moved to
the cartridge removal position unplug the
mains cable from the printer.
This allows the printhead to be manually
moved.
Remove any cartridges from the machine.
Remove all the small bungs from the bottles. (
do not throw these away as you will
need these for re-filling the bottles
)
Using the long needle attachment on the
10 ml syringe draw any ink out of the
centre chamber (through the small hole).
Repeat this on each colour then fit the air
filters supplied.
Page 2
Place the bottles to the left of the printer
as shown.
NEVER PLACE THE BOTTLES
HIGHER THAN THIS
(If the bottles are placed higher then the
ink may siphon into the bottom of the
printer.)
Make sure there are no twists in the
tubing.
Feed the cartridges through the opening in
the printhead lid. (If you have previously
removed this lid already do not worry as it
is not necessary for the operation of the
system).
Push the cartridges down firmly until they
snap into position. Close the printhead lid
making sure not to trap the tubing.
Remove the tape from the sticky pad and
firmly press the tube support into place as
shown Make sure the tubing is not
twisted..
Page 3
Loading...