Make sure you have the relevant parts with your
system
These include:
1. 1 x Prefilled cartridge, tube and bottle
assembly.
2. 1 x Tube support (clip comes in three parts)
3. 1 x bag containing 4 x air filters and small tube
clip
4. 1 x Syringe (used for filling bottles later, not
used in installation.
5. 1 x Computer disc containing ICC profile and
all relevant pdf files for using the system.
Epson D88 Bulk Feed
Installation
Press the ink button until the cartridges reach the
‘change’ position and unplug the Mains Cable from
the rear of the printer
Gently remove the cartridge lid from the printer There is a small spring to remove on the left side of
Remove any cartridges.
the lid.
Page 1
Before fitting the system to the printer lay the bottle
unit down as shown here for a couple of seconds then
stand it back up.
This sets the levels in the small side of the bottles
correctly (this is usually necessary due to movement
in shipping)
Make sure the tube support is fitted as shown. Note
the support is on top of the tubes with the double
sided tape upwards.
Take of the red tape and press the tube support into
position as shown. This is directly in front of the
center button of the printer.
Put the cartridges into the printer and push them
firmly into place.
Fit small tube clamp on the side of the printer as
shown.
Page 2
Loading...