9
1290 Bulk Feed
Instructions
5
2
6
4
1
3
7
ITINERY
1. Bottles and cartridge assembly (pre-filled)
2. Main tube support
3. Small clamp
4. 10ml Syringe
5. Small needle (only required for re-priming, see page 7)
6. Large extension
8
7. 6 x air filters
8. Subli-Print CD (including colour correction profile and instructions)
9. Large syringe for re-filling bottles (if supplied)
10/07/2007 V4.0 NJE
Press the yellow button and as the
cartridges moves to the left unplug the
mains supply from the printer.
This allows the printhead to be manually
moved.
Take out any cartridges and remove the
Black cartridge lid as shown.
Remove all the small bungs from the
bottles. (
need these for re-filling the bottles
do not throw these away as you will
)
Using the long needle attachment on the
10 ml syringe draw any ink out of the
centre chamber (through the small hole).
Repeat this on each colour then fit the air
filters supplied.
Page 2
Place the bottles to the right of the printer
as shown.
NEVER PLACE THE BOTTLES
HIGHER THAN THIS
(If the bottles are placed higher then the
ink may siphon into the bottom of the
printer.)
Make sure there are no twists in the
tubing.
Place cartridge unit into printer and push
down lid firmly.
The tube support will be fixed 225mm
? ”) from the edge of the printer
(8
housing as shown.
Remove the tape from the sticky pads and
firmly press the tube support into place.
Page 3
Loading...