Whirlpool ASE 500, ASE 501, ASE 502, ASE 503, ASE 504 INSTRUCTIONS FOR THE INSTALLATION AND USE

GB

Design Series Traditional Series 800 Traditional Series 700

REFRIGERATING UNITS

INSTRUCTIONS FOR THE INSTALLATION AND USE OF

REFRIGERATING UNITS

ASE 500	ASE 516	ASE 532	ASE 548	ASE 315	ASE 008
ASE 501	ASE 517	ASE 533	ASE 300	ASE 316	ASE 009
ASE 502	ASE 518	ASE 534	ASE 301	ASE 317	ASE 010
ASE 503	ASE 519	ASE 535	ASE 302	ASE 318	ASE 011
ASE 504	ASE 520	ASE 536	ASE 303	ASE 319	ASE 012
ASE 505	ASE 521	ASE 537	ASE 304	ASE 320	ASE 013
ASE 506	ASE 522	ASE 538	ASE 305	ASE 321	ASE 014
ASE 507	ASE 523	ASE 539	ASE 306	ASE 322	ASE 015
ASE 508	ASE 524	ASE 540	ASE 307	ASE 323	ASE 016
ASE 509	ASE 525	ASE 541	ASE 308	ASE 001	ASE 017
ASE 510	ASE 526	ASE 542	ASE 309	ASE 002	ASE 018
ASE 511	ASE 527	ASE 543	ASE 310	ASE 003	ASE 019
ASE 512	ASE 528	ASE 544	ASE 311	ASE 004	ASE 020
ASE 513	ASE 529	ASE 545	ASE 312	ASE 005	ASE 021
ASE 514	ASE 530	ASE 546	ASE 313	ASE 006
ASE 515	ASE 531	ASE 547	ASE 314	ASE 007

EQUIPMENT COMPLYING WITH THE FOLLOWING DIRECTIVES::

73/23 EEC LOW VOLTAGE, ELECTRICAL SAFETY 89/336 EEC: ELECTROMAGNETIC COMPATIBILITY 93/EEC: CE MARK REGULATIONS

Ed: A	Data	Evento modifica	Redatto	Verificato	Approvato
Rev: Ø	01/01/02	Prima emissione
Rev: 1	05/05/05	Seconda emissione	RSSC	ULGR	PLTN
Rev: 2

1

INDEX
1.GENERAL WARNINGS	pg.3
2.SPECIAL WARNINGS FOR POSITIONING AND CONNECTING THE APPLIANCE	pg.4
3.POSITIONING	pg.4
4.REFRIGERATED DISPLAY COUNTER	pg.4
5.LAWS AND DIRECTIVES	pg.5
6.ELECTRICAL AND EQUIPOTENTIAL CONNECTION	pg.5
7.CONDENSATION WATER DRAWING	pg.5
8.GENERAL INSTRUCTIONS FOR USE	pg.6
9.CLEANING AND CARE OF APPLIANCE	pg.6
10.CONTROL PANELS	pg.7
11.USE AND OPERATION	pg.8

The manufacturer declines any responsibility for possible inexact information contained in this manual and due to printing or transcription errors.

We reserve the right to make any changes that we believe are necessary or useful without affecting the essential features.

The partial or total reproduction or photocopying or texts or pictures of this instruction manual is not allowed without prior authorisation.

2

1) GENERAL WARNINGS

Only qualified installed and personnel authorised by the manufacturer can carry out installation, start-up and maintenance operations on the equipment.

Read the instructions contained in this manual very carefully, as they are very important for safety in case of installation, use and maintenance.

1.The appliance must be used only for its intended purpose, i.e. for holding previously chilled food or drinks; the appliance is not designed for any other use that is therefore prohibited.

2.The room conditions for the proper operation of the appliance must be a temperature of 25°C with 60% humidity.

3.Once unpacked, make sure that the appliance has not been damaged.

4.Before positioning and installing the unit, check that power and voltage requirements shown on the data plate are equivalent to the specifications of power supply on site.

The data plate ( see image A ) is on the lower right-hand side of the serving side.

Image A

5.In case of malfunctioning, turn off the appliance immediately and interrupt and/or close all connections.

3