RX-4109(A) 2006.6.21 08:25 AM 1
RX-4109(A) 2006.6.21 08:25 AM 1
RX-4109
AM/FM STEREO RECEIVER
RX-4109(A) 2006.6.21 08:25 AM 2
Introduction
READ THIS BEFORE OPERATING YOUR UNIT
|
|
|
|
|
This symbol is intended to alert the user to the presence |
|
|
|
|
|
of uninsulated "dangerous voltage" within the product's |
|
|
|
|
|
enclosure that may be of sufficient magnitude to |
|
|
|
|
|
constitute a risk of electric shock to persons. |
CAUTION |
|
NOT REMOVE COVER (OR BACK). NO USER- |
|
|
|
|
: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO |
|
|
This symbol is intended to alert the user to the presence |
|
|
|
|
|
|
|
|
|
SERVICEABLE PARTS INSIDE. REFER SERVICING |
|
|
of important operating and maintenance (servicing) |
|
|
|
|
instructions in the literature accompanying the appliance. |
|
|
|
TO QUALIFIED SERVICE PERSONNEL. |
|
|
|
|
|
|
|
|
|
WARNING |
: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, |
|
|||
|
|
DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. |
|
||
Caution regarding installation
Note : For heat dispersal, do not install this unit in a confined space such as a bookcase or similar enclosure.
Do not block ventilation openings or stack other equipment on the top.
Note to CATV System Installer :
This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.
FCC INFORMATION
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•Consult the dealer or an experienced radio/TV technician for help.
Caution : Any changes or modifications in construction of this device which are not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
FOR YOUR SAFETY
|
|
|
|
|
Units shipped to the U.S.A and CANADA are designed for operation on 120 V AC only. |
|
|
|
|
|
|
Safety precaution with use of a polarized AC plug. |
|
|
|
|
|
|
However, some products may be supplied with a nonpolarized plug. |
|
|
U.S.A |
|
120 V |
|||
|
|
|
CAUTION : To prevent electric shock, match wide blade of plug to wide slot, fully insert. |
|||
|
CANADA |
|
|
|||
|
|
|
|
|
ATTENTION |
: Pour éviter chocs électriques, introduire la lame la plus large de la fiche dans la borne |
|
|
|
|
|
||
|
|
|
|
|
correspondante de la prise et pousser jusqu’ au fond. |
|
|
|
|
|
|
|
|
CAUTION
•Leave a space around the unit for sufficient ventilation.
•Avoid installation in extremely hot or cold locations, or in an area that is exposed to direct sunlight or heating equipment.
•Keep the unit free from moisture, water, and dust.
•Do not let foreign objects in the unit.
•The ventilation should not be impeded by covering the ventilation openings with items, such as newspapers, table-cloths, curtains, etc.
•No naked flame sources, such as lighted candles, should be placed on the unit.
•Please be care the environmental aspects of battery disposal.
•The unit shall not be exposed to dripping or splashing for use.
•No objects filled with liquids, such as vases, shall be placed on the unit.
•Do not let insecticides, benzene, and thinner come in contact with the set.
•Never disassemble or modify the unit in any way.
■Notes on the AC power cord and the wall outlet.
•The unit is not disconnected from the AC power source(mains) as long as it is connected to the wall outlet, even if the unit has been turned off.
•When disconnecting the power cord from the wall outlet, always pull the plug, not the power cord.
•Disconnect the plug from the wall outlet when not using the unit for long periods of time.
•The wall outlet shall be installed near the unit and shall be easily accessible.
2
RX-4109(A) 2006.6.21 08:25 AM 3
SAFETY INSTRUCTIONS
1.Read Instructions - All the safety and operating instructions should be read before the product is operated.
2.Retain instructions - The safety and operating instructions should be retained for future reference.
3.Heed Warnings - All warnings on the product and in the operating instructions should be adhered to.
4.Follow Instructions - All operating and use instructions should be followed.
5.Cleaning - Unplug this product from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. Use a damp cloth for cleaning.
6.Attachments - Do not use attachments not recommended by the product manufacturer as they may cause hazards.
7.Water and Moisture - Do not use this product near water - for example, near a bath tub, wash bowl, kitchen sink, or laundry tub; in a wet basement, or near a swimming pool; and the like.
8.Accessories - Do not place this product on an unstable cart, stand, tripod, bracket, or table. The product may fall, causing serious injury to a child or adult, and serious damage to the product. Use only with a cart, stand, tripod, bracket, or table recommended by the manufacturer, or sold with the product. Any mounting of the product should follow the manufacturer’s instructions, and should use a mounting accessory recommended by the
manufacturer.
9.A product and cart combination should be
moved with care. Quick stops, excessive force, and uneven surfaces may cause the product and cart combination to overturn.
10.Ventilation - Slots and openings in the cabinet are provided for ventilation and to
ensure reliable operation of the product and to protect it from overheating, and
these openings must not be blocked or covered. The openings should never be blocked by placing the product on a bed, sofa, rug, or other similar surface. This product should not be placed in a built-in installation such as a bookcase or rack unless proper ventilation is provided or the manufacturer’s instructions have been adhered to.
11.Power Sources - This product should be operated only from the type of power source indicated on the marking label. If you are not sure of the type of power supply to your home, consult your product dealer or local power company. For products intended to operate from battery power, or other sources, refer to the operating instructions.
12.Grounding or Polarization - This product may be equipped with a polarized alternating-current line plug (a plug having one blade wider than the other). This plug will fit into the power outlet only one way. This is a safety feature. If you are unable to insert the plug fully into the outlet, try reversing the plug. If the plug should still fail to fit, contact your electrician to replae your obsolete outlet. Do not defeat the safety purpose of the polarized plug.
Alternate Warnings - This product is equipped with a three-wire grounding-type plug, a plug having a third(grounding) pin. This plug will only fit into a grounding-type power outlet. this is a safety feature. If you are unable to insert the plug into the outlet, contact your electrician to replace your obsolete outlet. Do not defeat the safety purpose of the gronding-type plug.
13.Power-Cord Protection - Power-supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them, paying particular attention to cords at plugs, convenience receptacles, and the point where they exit from the product.
14.Outdoor Antenna Grounding - If an outside antenna or cable system is connected to the product, be sure the antenna or cable system is grounded so as to provide some protection against voltage surges and built-up static charges. Article 810 of the National Electrical Code, ANSI/NFPA 70, provides information with regard to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna-discharge unit,
connection to grounding electrodes, and requirements for the grounding electrode. See Figure 1.
Figure 1
Example of antenna grounding as per
National Electrical Code, ANSI/NFPA 70
15.Lightning - For added protection for this product during a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna or cable system. This will prevent damage to the product due to lightning and power-line surges.
16.Power Lines - An outside antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can fall into such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits as contact with them might be fatal.
17.Overloading - Do not overload wall outlets, extension cords, or integral convenience receptacles as this can result in a risk of fire or electric shock.
18.Object and Liquid Entry - Never push objects of any kind into this product through openings as they may touch dangerous voltage points or short-out parts that could result in a fire or electric shock. Never spill liquid of any kind on the product.
19.Servicing - Do not attempt to service this product yourself as opening or removing covers may expose you to dangerous voltage or other hazards. Refer all servicing to qualified service personnel.
20.Damage Requiring Service - Unplug this product form the wall outlet and refer servicing to qualified service personnel under the following conditions:
a)When the power-supply cord or plug is damaged,
b)If liquid has been spilled, or objects have fallen into the product,
c)If the product has been exposed to rain or water,
d)If the product does not operate normally by following the operating instructions. Adjust only those controls that are covered by the operating instructions as an improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the product to its normal operation.
e)If the product has been dropped or damaged in any way, and
f)When the product exhibits a distinct change in performance - this indicates a need for service.
21.Replacement Parts - When replacement parts are required, be sure the service technician has used replacement parts specified by the manufacturer or have the same characteristics as the original part. Unauthorized substitutions may result in fire, electric shock, or other hazards.
22.Safety Check - Upon completion of any service or repairs to this product, ask the service technician to perform safety checks to determine that the product is in proper operating condition.
23.Wall or Ceiling Mounting - The product should be mounted to a wall or ceiling only as recommended by the manufacturer.
24.Heat - The product should be situated away from heat sources such as radiators, heat registers, stoves, or other products (including amplifiers) that produce heat.
3
RX-4109(A) 2006.6.21 08:25 AM 4
CONTENTS |
|
Introduction |
|
•READ THIS BEFORE OPERATING YOUR UNIT |
......................................................................................... 2 |
SAFETY INSTRUCTIONS .............................................................................................................................. |
3 |
System Connections ........................................................................................................................................ |
5 |
Front Panel & Remote Controls ..................................................................................................................... |
7 |
•REMOTE CONTROL OPERATION RANGE ................................................................................................ |
9 |
•LOADING BATTERIES ................................................................................................................................ |
9 |
Operations |
|
•LISTENING TO A PROGRAM SOURCE ................................................................................................... |
10 |
•LISTENING TO RADIO BROADCASTS .................................................................................................... |
12 |
•RECORDING .............................................................................................................................................. |
15 |
•OTHER FUNCTIONS ................................................................................................................................. |
15 |
Troubleshooting Guide .................................................................................................................................. |
16 |
Specifications .................................................................................................................................................. |
17 |
4
RX-4109(A) 2006.6.21 08:25 AM 5
System Connections
•Do not plug the AC input cord into the wall AC outlet until all connections are completed.
•Be sure to connect the white RCA pin cords to the L (left) and the red RCA pin cords to the R (right) jacks when making audio connections.
•Make connections firmly and correctly. If not, it can cause loss of sound, noise or damage to the receiver.
•If the electricity fails or the AC input cord is left unplugged for more than several days, the memorized contents will be cleared. Should this happen, memorized them again.
1. CONNECTING ANTENNAs
• Change the position of the FM indoor antenna until you get the best reception of your favorite FM stations.
• A 75Ω outdoor FM antenna may be used to further improve the reception. Disconnect the indoor antenna before replacing it with the outdoor one.
• Place the AM loop antenna as far as possible from the receiver, TV set, speaker cords and the AC input cord and set it to a direction for the best reception.
• If the reception is poor with the AM loop antenna, an
AM outdoor antenna can be used in place of the AM loop antenna.
2. CONNECTING PHONO
■Note
•Do not connect the turntable with MC type cartridge directly. If so, use a separate head amplifier or step-up transformer.
5
Loading...