Release Notes
Product: SNC 6101® Firmware 4.60.02
Date: March 2005
Page Topic
1 Purpose of this Release
1 Resolved Issues
3 Documentation
This release extends the capabilities of SNC 6101. These release notes list corrections to problems that were encountered in previous releases of SNC 6101. Visit www.adic.com for additional information about SNC 6101 and previous releases. For a complete matrix of firmware compatibility, refer to the library release notes.
Problems that have been resolved in this release of SNC 6101 are as follows:
Change |
|
|
Request |
|
Description |
Number |
|
|
|
|
|
15314 |
CLI command hpFeatureDisable causes invalid block in partition errors. |
|
15394 |
SCSI - SNC 6101 |
Inquiry failure (12h). |
|
|
|
15395 |
SCSI - SNC 6101 |
Inquiry command error (12h). |
|
|
|
15467 |
SCSI - SNC 6101 |
Mode Sense error (1Ah). |
|
|
|
17086 |
CLI command initializeBox does not disable AMP feature. |
|
20720 |
“Failed to open tape: errno - 0x380003” during initializeBox command. |
|
26054 |
SNC hangs up if you type exit from the serial port prompt. |
|
29084 |
Write/Verify of greater than 1M does not work. |
|
|
|
|
29589 |
The vpsMapClear command does not clear the mapping assignments for the host. |
© March 2005, ADIC®
ADIC is a registered trademark of Advanced Digital Information Corporation. All other product, company, or service names mentioned herein are the property of their respective owners.
6-01237-02 Rev A