ADIC® Scalar® 100 Quick Start Guide
If your library configuration contains a SNC (Storage |
5 |
On the bottom-most drive, connect a jumper |
8 |
Remove the key from the back panel. |
|
Networking Controller), the installation and set-up |
cable to the top SCSI connector and then to |
Unlock and open the front door. Remove the |
|||
must be performed by ADIC-qualified personnel. |
|
the bottom SCSI connector on the drive |
|
interior packing and securing material. |
|
|
|
|
above it. Repeat this for all the drives. |
|
Be sure to remove the rubber band that |
1 |
If you have drives to install, install them now |
|
If you have more than two drives, split the |
|
|
|
|
secures the picker. |
|||
by following steps 2 and 3. Otherwise, skip |
|
|
|||
|
|
drives between SCSI buses. |
|
|
to step 4.
2 |
Beginning with the bottom slot (drive module |
1), find the lowest available drive slot(s). |
|
Loosen the two thumbscrews on the filler |
|
|
plate(s) and remove the filler plate(s). |
|
|
For AIT libraries, install drives into slots two |
|
|
through five, beginning with slot two. |
|
3 |
Slide the drive(s) into position and tighten |
|
the two captive thumbscrews. |
||
|
Filler Plate
Drive Module
Captive thumbscrews
4 |
Depending on your host SCSI bus type, set |
|
the SCSI interface switch to LVD or HVD. |
||
|
6-00671-01 Rev A
6 |
Terminate the SCSI bus(es) with an |
9 |
Install tape cartridges into magazines. Close |
|
and lock the front door. |
||||
appropriate terminator (LVD or HVD). |
|
|||
|
|
|
||
7 |
Install the cables between the bottom drive |
10 |
Connect the power cord to the power outlet |
|
on the rear of the library. |
||||
and the Library Controller and between the |
|
|||
|
Library Controller and the host. |
|
|
|
|
If you have more than one SCSI bus, |
11 |
Turn on the rear power switch and then turn |
|
|
|
on the front power switch.
connect a cable between the bottom drive on the SCSI bus and the host.
HVD SCSI |
SCSI Interface |
Connections |
Switch |
LVD SCSI
Connections
Library
Controller
to Host
Library
to Host
Optional
SNC
Terminator
Front Power Switch
Rear Power
Switch
12 |
Power up your host system and verify |
|
communication with all devices on the bus. |
||
|
Your library is now ready.
Drive to |
Jumper Cable |
Power Cord |
Library Controller |
|
|
|
|