D I G I TA L S I G N A L P R O C E S S O R S
PUBLIC ADDRESS
RAMSA
Digital Multi Processor
WZ-DM35NH
GEQ |
CH PEQ |
X-OVER |
LEVEL |
DELAY |
UTILITY |
•2 inputs and 4 outputs.
•6 functions: Graphic equalizer function, parametric equalizer function, delay function, crossover network
function, compressor/limiter function, and noise gate function.
•6 Basic Modes: Three delay modes for sense-of-direction control (DELAY1 to DELAY3) and three crossover
network modes (X-OVER1 to X-OVER3)
•Built-in digital audio interface and conforms to the AES/EBU format.
•24-bit A/D and D/A converters are employed for analog inputs and outputs to offer a dynamic range close to that
of an analog device.
•All settings can be saved in up to 16 patterns in the memory.
Dimensions |
|
|
|
480 |
5 |
275 |
|
465 |
|||
|
|
||
32 |
44 |
|
|
|
|
Unit : mm |
SPECIFICATIONS
|
Model No. |
WZ-DM35NH |
|
|
Input |
No. of Channels |
2 ch |
|
|
Analog |
|
|
|
Type |
Electronic balance |
|
|
Rated Input |
+4 dB |
|
|
Maximum Input |
+24 dB or more |
|
|
Connector |
XLR-3-31 or equivalent, 2 connectors |
|
|
Input Impedance |
20 kΩ |
|
|
In-Phase Reject Ratio |
40 dB or more |
|
|
A/D Converter |
24-bit ∆-∑ type |
|
|
Digital |
|
|
|
Type |
AES/EBU format, for professional use |
|
|
Sampling Frequency |
48 kHz±0.1% |
|
|
Connector |
XLR-3-31 or equivalent, 1 connector |
|
Output |
No. of Channels |
4 ch |
|
|
Analog |
|
|
|
Type |
Electronic balance |
|
|
Rated Output |
+4 dB±1 dB |
|
|
Maximum Output |
+24 dB or more (at 10 kΩ load) |
|
|
Output Impedance |
150Ω |
|
|
Connector |
XLR-type connector or equivalent, x4 |
|
|
Applicable Load Impedance |
600Ω or more |
|
|
D/A Converter |
24-bit ∆-∑ type |
|
|
Digital |
|
|
|
Type |
AES/EBU format, for professional use |
|
|
Sampling Frequency |
48 kHz |
|
|
Connector |
XLR-3-31 or equivalent, 1 connector |
|
|
|
(Recommended cable: Canare Electric DA206 or equivalent) |
|
General |
Frequency Response |
20 to 20,000 Hz, +0.5, –1.0 dB |
|
|
|
|
|
|
Dynamic Range |
Analog input/output (typ, IHF-A) |
|
|
|
115 dB (noise gate ON) |
|
|
|
109 dB (noise gate OFF) |
|
|
THD |
0.015% at +4 dB, 20 to 20,000 Hz, 30 kHz LPF (at 600Ω load) |
|
|
Crosstalk |
–70 dB or less (10 kHz) |
|
|
|
|
|
User Memory |
No. of memories: 16 |
|
External |
Type |
RS-485 RAMSA-NET (See Note.) |
|
Control |
Connector |
D-SUB 9-pin, IN/OUT 1 each, setscrew M2.6 |
|
|
|
|
Recommended connectors |
|
|
|
Male: OMRON XM2A-0901 or equivalent |
|
|
|
Female: OMRON XM2D-0901 or equivalent |
|
|
|
Hood: OMRON XM2S-0911 or equivalent |
|
|
|
|
|
Pattern |
Type |
Make contact type, No. of control patterns: 12 + MUTE |
|
Control |
|
Anti-reverse diode provided |
|
|
|
|
|
|
Connector |
D-SUB 15-pin, setscrew M2.6 |
|
|
|
Recommended connectors |
|
|
|
Male: OMRON XM2A-1509 or equivalent |
|
|
|
Hood: OMRON XM2S-1511 or equivalent |
|
|
|
|
|
Power Supply |
AC220-240V 50/60Hz |
|
|
Power Consumption |
19 W (as defined in the Electrical Appliances Control Act) |
|
|
|
|
|
|
Heat Flow |
19 W (15 kcal)* The figure in parentheses is calorific value per hour. |
|
|
Stacking Conditions |
2 units high maximum |
|
|
|
|
* If you are using 3 units or more, leave a space for a unit or more every 2 units. |
|
|
|
|
|
Dimensions |
480 (W) x 44 (H) x 280 (D) mm (without rubber feet) |
|
|
Weight (approx.) |
4.5 kg |
Note: "RAMSA-NET" is a protocol exclusive to Matsushita Communication Industrial Co., Ltd., used to send and receive data between the host computer and two or more audio control units connected to it with communication lines.
Rear Panel