Start Here
Series
|
|
Easy Setup Instructions |
Photo Printer |
|
|
|
|
|
|
|
|
1 Unpack the Printer |
2 Prepare the Printer |
3 Install the FINE Cartridges |
4 Align the Print Head (FINE Cartridge) |
Carefully remove all items from the box.
PIXMA iP6310D Photo Printer
Power Cord
Color FINE Cartridge
(CL-41)
Photo FINE Cartridge
(CL-52)
Documentation and
Software Kit
1Remove the shipping tape from the front and back of the printer.
2Open (a) the card slot cover first and (b) the front cover next, Pull down and remove the protective material on the right side.
(a)Card slot cover
(b) Front cover
Protective material
3Close the front cover first and the card slot cover next.
4Plug the power cord into the back of the printer and connect the other end to a power outlet.
Press the POWER button. The printer will initialize. Wait until the POWER lamp remains fully lit.
1Take out the Color FINE Cartridge (CL-41) from its box and remove the protective tape gently.
Electrical contacts
To the FINE Cartridge holder
Print head nozzles
Protective tape
NOTE:
•Do not touch the electrical contacts or print head nozzles on a FINE Cartridge. The printer may not print out properly if you touch it.
•Do not reattach the protective tape once you have removed it.
•Handle the removed protective tape carefully to avoid getting your hands dirty or staining surrounding work area.
2 Insert the Color FINE Cartridge slightly slanted into the left slot (C).
Power cord
NOTE: Do not connect the USB cable at this stage.
5When the screen appears on the LCD, confirm a language and then press the OK button.
NOTE:
•If the language you want to be displayed is not selected, refer to "An Unintended Language is Displayed on the LCD" in the Direct Printing Guide.
•If you leave the printer more than five minutes without using any button on the operation panel, the LCD goes into sleep mode automatically. Press the OK button to turn on the LCD again.
6Open the card slot cover first and the front cover next. The FINE Cartridge holder automatically moves to the left.
Write down the serial number. You will need this to register the product.
3 Push up the Color FINE Cartridge until it clicks into place.
IMPORTANT: For correct printer operation, make sure the FINE Cartridge is secure in slots.
4Repeat the procedure for the Photo FINE Cartridge (CL-52), inserting it into the right slot (P).
FINE Cartridge
holder
Serial number |
5 Close the front cover first and the card slot cover next.
IMPORTANT: Wait until the preparatory operation is complete; this takes about one to two minutes.
The message requesting head alignment is displayed on the LCD. Go to the next step.
1 Open the paper support and pull out the paper output tray.
Paper support
Paper output tray
2Pinch the paper guide and slide it to the left. Load a few sheets of blank paper into the auto sheet feeder, then slide the paper guide toward the left edge of the paper.
Auto sheet feeder
Print side
Paper guide
Paper thickness lever
NOTE: Ensure that the paper thickness lever is set to the left position.
3Ensure that the message requesting head alignment is
displayed on the LCD, select YES using the buttons and press the OK button.
The pattern is printed. And the print head is aligned automatically.
IMPORTANT: It takes about four minutes to finish printing.
When automatic print head alignment can not be executed correctly, the message "HEAD ALIGNMENT ERROR" is displayed on the LCD. refer to "An Error Message is Displayed in the LCD" in the Direct Printing Guide.
Continue with Step 5
on side two.