AEG CS201DV, CS110DV, CS113D, CS113DV, CS114D Manual

Cave à vins de vieillissement Wine maturation celler Weinklimaschrank

Cave para envelhecimento de vinhos

Cava para envejecimiento del vino

Cantina per l’invecchiamento dei vini

Vinlagringsskåp

CS 110 160

200

Notice d’instructions .................	FR
Instruction manual .................	GB
Bedienungsanleitung .................	DE
Manual de instruções .................	PT
Manual de instrucciones .................	ES
Manuale di istruzioni .................	IT
Bruksanvisning .................	SE

825 12 10-01

Operating and Installation Instructions for your Electrolux Wine Cellar

Introduction

Thank you for choosing the Electrolux Wine Cellar. Please read the following instructions carefully before installing your new wine cellar. We trust you will be completely satisfied with your purchase.

The wine cellar must be installed and used according to these instructions in order for it to operate correctly and economically.

Transit damage

Inspect the wine cellar for transit damage. You must report any damage the company responsible for the delivery within the legal or stated time for this type of product. If there is no such established report time, the damage must be reported within seven days of delivery.

Data plate

Check the data plate, inside the wine cellar at the top left, to ensure you have received the right model. The data plate shows details that you will need to quote if you have to contact service personnel. It is a good idea to make a note of them here.

Model designation ……………………….…

Product number …………………………….

Serial number ……………………………….

Voltage ………………………………….......

Installation

Please follow these installation instructions:

For best performance, air needs to circulate freely over the cooling unit behind the wine cellar. The freestanding design of the cellar means that it should stand at least 25 mm from the rear and side walls. Allow a clearance of at least 100 mm above the wine cellar.

Adjust the feet of the wine cellar so that it stands in a vertical position in both directions. Use a spirit level if necessary.

1.Remove the transport pallet on which your wine cellar rests.

2.Adjust the feet to allow a 30 mm clearance under the wine cellar.

3.Attach the steel rod using the two screws at the top back on each side of the cellar. The rod ensures the correct distance to the wall behind.

4.For optimum performance, please place your wine cellar far away from any source of heat (radiator, cooker or intense sunlight).

Steel rod

30 mm

FIG. 1

Wall

Steel rod

25

Rear

25

Wall

FIG. 2

5.Check that the charcoal filter is in place at the top left corner inside the wine cellar.

6.Fit the door handle to the door. The door frame has pre-drilled holes on its side(s).

Please note that it must be possible to open the wine cellar door at least 90° to allow the sliding shelves to be pulled out.

6