Zanussi ZGG642Y, ZGG752XR, ZGG752ALU, ZGG642W, ZGG642B User Manual

GAS HOBS

ZGG 642

ZGG 752

INSTRUCTION BOOKLET

Please read this instruction booklet before using the appliance

GB

2

This appliance complies with the following

E.E.C. Directives:

* 73/23 - 90/683 (Low VoltageDirective);

* 93/68 (General Directives);

* 89/336 (Electromagnetical Compatibility

Directive);

* 90/396 (Gas Appliances),

and subsequent modifications

Guide to Use the instructions

The following symbols will be found in the text to guide

you throughout the Instructions:

Safety Instructions

Step by step instructions for an operation

Hints and Tips

Enviromental information

F

Important Safety Information

You MUST read these warnings carefully before installing or using the hob. If you need

assistance, contact our Customer Care Department on 08705 727727

Installation

l This hob must be installed by qualified personnel,

according to the manufacturers instructions and to

the relevant British Standards.

l Any gas installation must be carried out by a

registered CORGI installer.

l Remove all packaging before using the hob.

l Ensure that the gas and electrical supply complies

with the type stated on the rating plate, located near

the gas supply pipe.

l Do not attempt to modify the hob in any way.

Child Safety

l This hob is designed to be operated by adults. Do

not allow children to play near or with the hob.

l The hob gets hot when it is in use.

l Children should be kept away until it has cooled.

l Children can also injure themselves by pulling pans

or pots off the hob.

During Use

l This hob is intended for domestic cooking only. It is

not designed for commercial or industrial purposes.

l When in use a gas cooking appliance will produce

heat and moisture in the room in which it has been

installed. Ensure there is a continuous air supply,

keeping air vents in good condition or installing a

cooker hood with a venting hose.

l When using the hob for a long period of time, the

ventilation should be improved, by opening a window

or increasing the extractor speed.

l Do not use this hob if it is in contact with water.

Do not operate the hob with wet hands.

l Ensure the control knobs are in the OFF position

when not in use.

l When using other electrical appliances, ensure the

cable does not come into contact with the hot surfaces

of the cooking appliance.

l Unstable or misshapen pans should not be used on

the hob as unstable pans can cause an accident by

tipping or spillage.

l Never leave the hob unattended when cooking with

oil and fats.

l Never use plastic or aluminium foil dishes on the hob.

l Perishable food, plastic items and areosols may be

affected by heat and should not be stored above or

below the hob unit.

Service

l This hob should only be repaired or serviced by an

authorised Service Engineer and only genuine

approved spare parts should be used.

Environmental Information

l After installation, please dispose of the packaging with

due regard to safety and the environment.

l When disposing of an old appliance, make it unusable,

by cutting off the cable.

Keep this instruction book for future reference

and ensure it is passed on to any new owner.

3

Contents

For the User

For the Installer

Important Safety Information 2

Description of the Hob 3

Operation 4

Maintenance and Cleaning 4

Something Not Working? 5

Service and Spare Parts 5

Guarantee conditions 6

Important safety requirements 10

Installation 10

Building In 11

Electrical connections 12

Wiring Diagram 13

Fault Finding 13

Commissioning 15

Conversion from Natural Gas to LPG 15

Description of the Hob

1

1. Semi-rapid Burners

2. Rapid Burner

3. Auxiliary Burner

4. Control knobs

1

2

3

4

2

1

3

1

1

4

ZGG 642

ZGG 752

4

Operation

Hob burners

To light a burner:

l push in the relevant control and turn it to maximum

position;

l ZGG 752: upon ignition, keep the knob pushed down

about 5 seconds. This will allow the "thermocouple" to

be heated and the safety device to be switched off,

otherwise the gas supply would be interrupted.

l then adjust the flame as required.

l If the burner does not ignite, turn the control knob to

zero, and try again.

If you use a saucepan which is smaller than the

recommended size, the flame will spread beyond

the bottom of the vessel, causing the handle to

overheat.

Take care when frying food in hot oil or fat, as

the overheated splashes could easily ignite.

Burner minimum maximum

diameter diameter

Large (rapid) 180 mm. 260 mm.

Medium (semi-rapid) 120 mm. 220 mm.

Small (Auxiliary) 80 mm. 160 mm.

Maintenance and Cleaning

Before any maintenance or cleaning can be carried

out, you must DISCONNECT the hob from the

electricity supply.

The hob is best cleaned whilst it is still warm, as

spillage can be removed more easily than if it is

left to cool.

The Hob Top

Regularly wipe over the hob top and the aluminium frame

using a soft cloth well wrung out in warm water to which

a little washing up liquid has been added. Avoid the use

of the following:

- household detergent and bleaches;

- impregnated pads unsuitable for non-stick saucepans;

- steel wool pads;

- bath/sink stain removers.

Should the hob top become heavily soiled, it is

recommended that a cleaning product such as Hob Brite

or Bar Keepers Friend is used.

Pan Supports

The pan supports are dishwasher proof.

If necessary, remove stubborn stains using a paste

cleaner. Never use steel wool pads or acids.

The Burners

The burner caps and crowns can be removed for cleaning.

Wash the burner caps and crowns using hot soapy water,

and remove marks with a mild paste cleaner. A well

moistened soap impregnated steel wool pad can be used

with caution, if the marks are particularly difficult to

remove.

After cleaning, be sure to wipe dry with a soft cloth.

To ensure maximum burner efficiency, you should only

use pots and pans with a flat bottom fitting the size of

the burner used (see table).

As soon as a liquid starts boiling, turn down the

flame so that it will barely keep the liquid

simmering.

If the control knobs become difficult to turn, please

contact your local Zanussi Service Centre.

ZGG 752

The cap and crown of each burner are secured with two

screws. To separate the two pieces, lift the crown, turn it

upside down, then undo the two fixing screws as shown

in fig. 1.

After cleaning, reassemble the two parts and refit the

cap on its correct position on the burner.

FO 2265

Fig. 1

F

F

5

Something Not Working?

If the hob is not working correctly, please carry out the following checks before contacting your local Service Force

Centre.

IMPORTANT:

If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or

installation, a charge will be made even if the appliance is under guarantee.

SYMPTOM

n There is no spark when lighting the gas

n The gas ring burns unevenly

SOLUTION

u Check that the unit is plugged in and the electrical

supply is switched on

u Check that the RCCB has not tripped (if fitted)

u Check the mains fuse has not blown

u Check the burner cap and crown have been

replaced correctly, e.g. after cleaning.

u Check the main jet is not blocked and the burner

crown is clear of food particles.

u Check the burner cap and crown have been

replaced correctly, e.g. after cleaning.

If after all these checks, your hob still does not operate

correctly, contact your local Service Force Centre.

Please note that it will be necessary to provide proof of

purchase for any in-guarantee service calls.

In-guarantee customers should ensure that the

above checks have been made as the engineer will

make a charge if the fault is not a mechanical or

electrical breakdown.

In the event of your appliance requiring service, or if you

wish to purchase spare parts, please contact your local

Zanussi Service Force Centre by telephoning:

0870 5 929929

Your telephone call will be automatically routed to the

Service Force Centre covering your post code area. The

addresses are listed on the following pages.

Before calling out an engineer, please ensure you have

read the details under the heading Something Not

Working.

When you contact the Service Force Centre you will need

to give the following details:

1. Your name, address and post code

2. Your telephone number

3. Clear and concise details of the fault

4. The model and serial number of the appliance (found

on the rating plate)

5. The purchase date

Service and Spare Parts

6

Zanussi Guarantee conditions

We, Zanussi, undertake that if, within 24 months of the

date of the purchase, this Zanussi appliance or any part

thereof is proved to be defective by any reason only of

faulty workmanship or materials, we will, at our option,

repair or replace the same FREE OF ANY CHARGE for

labour, materials or carriage on condition that:

* The appliance has been correctly installed and used

only on the gas and electricity supply stated on the

rating plate.

* The appliance has been used for normal domestic

purpose only, and in accordance with the

manufacturer's instructions.

* The appliance has not been serviced, maintained,

repaired, taken apart or tampered with by any person

not authorised by us.

* All service work under this guarantee must be

undertaken by a Zanussi Service Centre.

* Any appliance or defective part replaced shall

become the Company's property.

* This guarantee is in addition to your statutory and

other legal rights.

Home visits are made between 8.30am and 5.30pm

Monday to Friday. Visits may be available outside these

hours, in which case a premium will be charged.

Exclusions

This guarantee does not cover:

* Damage or calls resulting from transportation,

improper use or neglect, the replacement of any light

bulbs or removable parts of glass or plastic.

* Costs incurred for calls to put right an appliance

which is improperly installed or calls to appliance

outside the United Kingdom.

* Appliances found to be in use within a commercial

or similar environment, plus those which are the

subject to rental agreements.

* Products of Zanussi manufacture which are not

marketed by Zanussi.

European Guarantee

If you should move to another country within Europe then

your guarantee moves with you to your new home

subject to the following qualifications:

* The guarantee starts from the date you first

purchased your product.

* The guarantee is for the same period and to the same

extent for labour and parts as exist in the new country

of use for this brand or range of products.

* This guarantee relates to you and cannot be

transferred to another user.

* Your new home is within the European Community

(EC) or European Free Trade Area.

* The product is installed and used in accordance with

our instructions and is only used domestically, i.e. a

normal household

* The product is installed taking into account

regulations in your new country.

Before you move, please contact your nearest Customer

Care centre, listed below, to give them details of your

new home. They will then ensure that the local Service

Organisation is aware of your move and able to look after

you and your appliances.

France Senlis [phone]

Germany Nürnberg [phone]

Italy Pordenone [phone]

Sweden Stockholm [phone]

UK Slough [phone]

Guarantee Conditions

For general enquiries concerning your Zanussi appliance

or for further information on Zanussi products, please

contact our Customer Care Department by letter or

telephone at the address below or visit our website at

www.zanussi.co.uk

Customer Care Department

Zanussi

55-77 High Street

Slough

Berkshire

SL1 1DZ

08705 727727 (*)

* calls to this number may be recorded for training

purposes.

Customer Care Department