Whirlpool WFE550S0HZ, WFE505W0HB, WFE505W0HW User Manual

0 (0)
Whirlpool WFE550S0HZ, WFE505W0HB, WFE505W0HW User Manual

30" (76.2 cm) Freestanding Electric Range

PRODUCT MODEL NUMBERS

WFC110

WFE330

WFE540

WFC120

WFE505

WFE550

WFC130

WFE510

WFE710

WFC150

WFE515

WFE714

WFC310

WFE520

WFE720

WFC315

WFE524

WFE745

WFC340

WFE525

WFE770

WFE320

WFE530

WFE905

 

 

WFI910

Electrical: To properly install your range, you must determine the type of electrical connection you will be using and follow the instructions provided for it here.

■■ Range must be connected to the proper electrical voltage and frequency as specified on the model/serial number rating plate. The model/serial number rating plate is located on the left-side frame behind the storage drawer panel or behind the top right side of the oven door. Refer to the figures in the “Product Dimensions” section of the “Location Requirements” section.

■■ This range is manufactured with the neutral terminal connected to the cabinet. Use a 3-wire, UL Listed. 40or 50-amp power supply cord (pigtail) (see following Range Rating chart). If local codes do not permit ground through the neutral, use a 4-wire power supply cord

rated at 250 volts, 40 or 50 amps and investigated for use with ranges.

 

 

Specified Rating

 

 

of Power Supply

 

 

Cord Kit and

 

Range Rating*

Circuit Protection

 

 

 

120/240 Volts

120/208 Volts

Amps

 

 

 

8.8 – 16.5 KW

7.8 – 12.5 KW

40 or 50 **

 

 

 

16.6 – 22.5 KW

12.6 – 18.5 KW

50

 

 

 

*The NEC calculated load is less than the total connected load listed on the model/serial rating plate.

**If connecting to a 50-amp circuit, use a 50-amp rated cord with a kit. For 50-amp rated cord kits, use kits that specify use with a nominal 13/8" (34.9 mm) diameter connection opening.

■■ A circuit breaker is recommended.

CABINET OPENING DIMENSIONS

PRODUCT DIMENSIONS

A

B

F C

E

D

A.273/4" (70.5 cm) max. depth with handle

B.467/8" (119.1 cm) overall height (max.) with leveling legs screwed all the way in*

C.36" (91.4 cm) cooktop height (max.) with leveling legs screwed all the way in*

D.297/8" (75.9 cm) width

E.255/16" (64.3 cm) depth – back of range to front of cooktop**

F.Model/serial rating plate (located on the left-side frame behind storage drawer or right side of frame behind the oven door)

IMPORTANT: Range must be level after installation. Follow the instructions in the “Level Range” section. Using the cooktop as a reference for leveling the range is not recommended.

*Range can be raised approximately 1" (2.5 cm) by adjusting the leveling legs.

**Front of door and drawer may extend further forward depending on styling.

Cabinet opening dimensions shown are for 25" (64.0 cm) countertop depth, 24" (61.0 cm) base cabinet depth and 36" (91.4 cm) countertop height.

IMPORTANT: If installing a range hood or microwave hood combination above the range, following the range hood or microwave hoods combination instructions for dimensional clearances above the cooktop surface.

A freestanding range may be installed next to combustible walls with zero clearance.

*NOTE: 24" (61.0 cm) minimum when bottom of wood or metal cabinet is covered by not less than 1/4" (6.4 mm) flame retardant millboard covered with not less than No. 28 MSG sheet steel, 0.015" (0.4 mm) stainless steel, 0.024" (0.6 mm) aluminum or 0.020” (0.5 mm) copper.

A. 13" (33.0 cm) max.

A

C

upper cabinet depth

B. 30" (76.2 cm) min.

 

B

 

 

opening width

 

 

 

C. For minimum clearance

 

to top of cooktop, see

D

NOTE*

 

D. 301/8" (76.5 cm) min

 

opening width

E. Outlet – 8" (20.3 cm) to 22" (55.9 cm) from

E either cabinet, 51/2" (14.0 cm) max. to floor

F

F. Cabinet door or hinges

should not extend into

 

 

the cutout

Because Whirlpool Corporation includes a continuous commitment to improve our products, we reserve the right to change materials and specifications without notice.

Dimensions are for planning purposes only. For complete details, see Installation

Ref. W10403811C

Instructions packed with product. Specifications subject to change without notice.

04/17/2017

Loading...